Advance Security R28 Car Alarm Receiver User Manual

Advance Security Inc Car Alarm Receiver Users Manual

a href="https://usermanual.wiki/Advance-Security" itemprop="url"> Advance Security >

Users Manual

MODEL 6978REMOTE ENGINE STARTERWITH ALARM SYSTEM MANUALThis system works on only auto transmission vehicle.F. 4 pin starter connectorE. 4 pin wire harness2 pin valet plug2 pin LED plugD. 4 pin optional sensor plugC. 3 pin door lock plugB. 6 pin starter connection plugA. 9 pin wire connection plugAntenna WireWIRING:A. 9 pin wire connection plug:Green Wire Negative Door Pin Switch:Blue Wire: Instant Trigger Ground InputViolet Wire: Positive Door Pin SwitchYellow Wire: (-) 200mA CH 3 outputOrange Wire: 500mA Grounded when armedBrown Wire: (-) 200mA of 2 steps door unlock.Pink Wire: (-) 200mA of horn outputWhite Wire: (-) 200mA of dome light outputGray Wire: (-) 200mA of channel 2 output+12V+12V85 863087a87CutTo start solenoid From ignition switchHorn/pager outputDome light outputChannel 2 outputTo door unlock systemCH 3 output
2B. 6 pin starter connection plug:Yellow: Ignition 2 (-) outputOrange: Pulsed ground output during startBlue: OEM alarm outputViolet: Negative safety input - hand brakeGray: Negative safety input - hood or trunkGreen: Tachometer connection1. Gray wire – Negative safety input - hood or trunk.Prevents engine from starting while vehicle is being serviced (or anytime that hood is raised).a. Mount a hood tilt switch, as suggested by the manufacture, so as anytime the hood is raised the switch will be in theclosed position.b. Wire the hood tilt switch as below figure. The alarm’s hood pin switch wire can be tied into this wire.c. If desired an optional valet switch can be wired as below figure.Note: The tilt switch used must be of a type that is environmentally sealed, so that corrosion will not prevent theswitch from making contact.Under HoodGray wireValet switchHood tilt switchGrommet throughbulkhead panel2. Violet wire:– Negative safety input - hand brake.Shuts engine off if hand brake is released.Connect to the vehicle’s hand brake light wire that shows +12Volts when the hand brake is pull up. See below:+ 12VBrake light switchViolet wireHand brake lightVehicle without a neutral safety switchSome vehicles are not equipped with a true neutral safety switch. If the vehicles starter will engage when the gearshift isplaced in any gear other than PARK or NEUTRAL, the following steps must be followed:a. Using a voltmeter, find a wire on the back-up light/Neutral safety switch that show a positive voltage when the gearshift isin any position other than PARK or NEUTRAL.b. Connect that wire to the violet wire as shown below.From brake switchFrom neutral safety switchDiodesWhite bandViolet wire
Download:
Mirror Download [FCC.gov]
Document ID47553
Application IDX2D+oB5pBUEOy6uTasQY5g==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize6.47kB (80916 bits)
Date Submitted1999-07-13 00:00:00
Date Available1999-09-21 00:00:00
Creation Date2001-06-11 11:38:14
Producing SoftwareAcrobat Distiller 4.0 for Windows
Document Lastmod2001-06-11 11:38:16
Document TitleUsers Manual
FCC ID Filing: H5OR28

Navigation menu