Betterway Electronic X-011 WIRELESS MICROPHONE TRANSMITTER User Manual C8ABD2B3B4ABD5E6CDBCC6AC
Betterway Electronic Co., Ltd. WIRELESS MICROPHONE TRANSMITTER C8ABD2B3B4ABD5E6CDBCC6AC
Contents
- 1. USERS MANUAL
- 2. User Manual
USERS MANUAL
PROFES SIONAL WIRELES S MICROPHONE SYSTEM OPERATION INSTRUCTIONS READ THESE INSTRUCTIONS CAREFULLY BEFORE USE, AFTER READING,KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE. MAIN FEATURES ‘Nide frequency response, high S/N ratio. lligh precision quartz crystal locked frequency technology. .’."esist disturbing strongly, limit noise output. ,, {Jo hitting when putting in the switch, so can protect the amplifier and Speakers. With a wide using range for over lOOmeters for compandor type or 50meters for non—compandor type in a good surrounding, for 40-60m for compandor type or 20- 30meters for non-compandor type in a duplicate one. With a complete working state and power level indication. A double—way channel design,two hands holding each two microphone at the same time to sing without any disturbing caused by. .. . ,_OPERATING 1.Put the receiver near the audio adjuster, with power cord and the signal protected cord with mixed output A+B or plug output A or output B separatly with two signal cords. And then connect with the amplifier or the microphone of the audio adjuster (MID IN), draw out two antennas completely, Put on the power switch,the power indicator shines.This receiver is being standing by.(Don't put the receiver in a corner so that it work in a good good condition). 2.Unscrew the cover in battery case. install the battery correctly then tight it up. (Don't install the battery oppositely). 3.Put the awitch to ON position, the indicator shines for a moment. At that time,the indicator on the receiver available to the signal channel on.It means that the signal is available the receiver from the microphone. Adjust the signal volume switch. Speak to the microphone and output the signals. 4.Put the switch to the middle position. This unit is being in silent state.Stop the receiver voice outputting and protect a noisy interruption outputting. 5.Ifthe indicator on the microphone shines for a long noisy time, the battery is being lowvoltage. It means it needs to replace a new battery. JLI i. :O: 6' c o'flb o ‘o 00‘5'0 o ACAUYIDN A ll o o 4 O OE" a}, a o Arum/V um" Amn l.Power switch of the receiver SACHB volume level switch 2.111dicat0r of power of receiver 9,CH.B antenna 3.CH.A RF signal light ll).CH.AB mixed output 4.CH.A AF signal light ll.CH.B output 5.CH.A volume level switch 12.CH.A output 6.CH.B RF signal light l3.AC power cord 7.CH.B AF signal light l4.CHlA antenna AzMIC set B:Battery indicator C1P0wer & silent switch DsBattcry case PRECAUTIONS In case of problem . Do not use the wireless microphone if it seems not to function correctly. Take the battery out or disconnect the AC immediately, and consult your dealer or an Authorized Service Centre Do not open or modify .Do not disassemble the system, as it may cause damage ti the unit, For internal repairs, consult your dealer or an Authorized Service Centre. Cleaning QBefore servicing or cleaning the unit, be sure to disconnect the AC ‘The system can be cleaned by wiping with a soft cloth. To remove stains, wipe with a soft cloth moistened with a mile detergent solution and wrung dry, then wipe with a dry soft cloth. .Do not use benzene, thinner, or any other chemical product on the system, as this may cause deterioration. SPECIFICATlONS if Carrier Frequency: Frequency Steadying: Modulating Mode: Audio dynamic range: Audio Frequency Responses: Audio output Level: S/N Ratio: T.H.D: Sensitivity: VHF174.1-215.6MHz Less than 0.002% FM Over 70dB 100Hz—15KHZ 0-280mV Over 70dB Less than 0.5% 3uV For 30dB S/N
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Page Count : 7 XMP Toolkit : XMP toolkit 2.9.1-13, framework 1.6 About : uuid:b0e6d05e-e6d6-483a-beb7-31a2bcd48f95 Producer : Acrobat Distiller 6.0.1 (Windows) Creator Tool : PScript5.dll Version 5.2 Modify Date : 2007:04:25 23:19:21+08:00 Create Date : 2007:04:25 23:19:21+08:00 Document ID : uuid:97806d80-fc34-4e36-8c55-1165cf1a96c4 Format : application/pdf Title :EXIF Metadata provided by EXIF.toolsCreator : henly.xie Author : henly.xie