Braeburn Systems 7490 Outdoorsensor User Manual

Braeburn Systems LLC Outdoorsensor manual

a href="https://usermanual.wiki/Braeburn-Systems" itemprop="url"> Braeburn Systems >

User manual

Installer Guide7490 Wireless Remote Outdoor Sensor®TMsmart connectPlease read all instructions before proceeding.The wireless remote outdoor sensor monitors temperature at a remote outdoor location and transmits the temperature data wirelessly to the thermostat. The sensor can be used to view the outdoor temperature or for heat pump systems requiring the use of balance points. One wireless outdoor remote sensor can be connected.1Specifications Operating Temperature: 40 - 120 ˚FStorage Temperature: 40 - 120 ˚FOperating Humidity: 5 - 95% Rh Battery Power: 3.0 Volt DCAccuracy: +/- 1˚F7490-100-02Blue LED Indicator- 1 flash every 30 seconds: Normal operation- 3 flashes every 30 seconds: Sending sensor data to thermostat- 1 flash every 2 seconds: Sensor is in pairing mode- Solid for 60 seconds: Successfully paired remote sensorRed LED Indicator- 3 flashes every 30 seconds: Low battery- 1 flash every 10 seconds: Lost communication with thermostatNOTE: LED indicators are only visible with the sensor cover off.IMPORTANT: Before mounting the remote sensor, you should verify there is good wireless communication in the area you wish to mount it by first pairing it in that location. If you are having trouble pairing in that location, try moving the remote sensor to a location closer to the thermostat.
Installer Guide 22Pairing Remote SensorSee thermostat Installer Guide for additional information on pairing sensors.1. Enter the wireless setup mode on the thermostat you wish to pair with the remote sensor. Proceed until you see the word SENS in the display with a flashing symbol.2. Make sure batteries are properly installed in the remote sensor and then press and hold the CONNECT button for 3 seconds.3. The remote sensor will enter pairing mode for 60 seconds. During this time the blue LED will flash once every 2 seconds.4. The thermostat will display ODS indicating that the wireless remote outdoor sensor was successfully paired. The symbol will stop flashing and the blue LED on the remote sensor will turn on for 60 seconds.5. You can repeat this process to pair additional wireless remote sensors or exit the wireless setup mode on the thermostat.NOTE: Sensors that have already been paired will appear in the thermostat display first, with a solid symbol. A maximum of 1 wireless remote outdoor sensors can be connected. A maximum of 4 wireless remote sensors total can be connected.++––ConnectButton3InstallationThe outdoor remote sensor should be mounted on an exterior wall, approximately 3 feet from any exhaust fans. For a more accurate temperature reading, mount the sensor on a wall that does not receive direct sunlight and is above the expected snow line.NOTE: Test location by pairing your thermostat before mounting (see section 2). Figure 1
Download:
Mirror Download [FCC.gov]
Document ID2562384
Application IDcKWgctohWWQOozb7rMmsjA==
Document DescriptionUser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize13.31kB (166352 bits)
Date Submitted2015-03-22 00:00:00
Date Available2015-03-22 00:00:00
Creation Date2015-03-19 12:02:52
Producing SoftwareAcrobat Distiller 9.0.0 (Windows)
Document Lastmod2015-03-19 12:02:52
Document Titlemanual.pdf
Document CreatorAdobe InDesign CS5.5 (7.5)
Document Author: Daria
FCC ID Filing: 2ADX6-7490

Navigation menu