C H Systems RF-SDWS Door/window sensor used by Security System User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2228582
Application ID	89uhxrVFI+IRtFlRq764PQ==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	162.18kB (2027223 bits)
Date Submitted	2014-03-28 00:00:00
Date Available	2014-09-24 00:00:00
Creation Date	0000-00-00 00:00:00
Document Lastmod	0000-00-00 00:00:00
Document Title	User Manual

MAGNASPHERE MSS -RFS-### SERIES WIRELESS SECURITY SENSOR INSTALLATION INSTRUCTIONS:
Required Tools and Componens
Provided by Manufacturer (per set) Provided by Installer
l MSSVRFS SWlIch module 4 Moummg Screws Hand Tools Auxlllary Contact (Dptlonal)
1 MSS-RFS magnet module 1 Battery (3VDC I,55Ah CR123A Lithium) Magnet Spacers ‘(DptlcnaL as needed)
MSS-RFS Series
comm 5.an SHOWN WITH
MAGNEI’ 1N seams PcsmoN
musmrrea
AUX common
AUX cLosEn LOOP
§
...
UP m man
(:nm)
. REDUCED
GAP
.J:
Magnasphere's MSS-
RFS uses a more
secure, restricted sense
zone. Orientation and
alignment is critical for
u proper operation.
‘ " Secure sensing zone begins
at this mark in the base
Spacers needed only to
.*Q yawn foroptimal gap. This
. j rare-earth magnet maybe
used directly on steel
Installation Plan a Switch Orientation
DOOR STOP MOUNT
(EGRESS DOOR)
BOTTOM VIEW
Tamper Switch
(actuate (or panel
enrollment)
J )
migrant?“"973”me °"‘"“”“'“‘s""5“‘“‘ MAGNASPHETQE‘” =3”
MAGNASF‘HERE N14W23777 Stone Ridge Dr Sulte160 Waukesha‘ WI 53186 tel 262 347.0711 lax 262347 0710 wwwmagnasphere Dom
FCC:
FCC label statement:
~This device complies with part 15 of the FCC Rules. Operation is subject to the followrng two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation "
Note: This equipment has been tested and found to comply with the limits for a Class B digital devrce, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the foIIowmg measures:
—Reon‘ent or relocate the receiving antenna.
—lncrease the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit dilferent from that to which the receiver is connected.
iconsult the dealer or an experienced radio/T V technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s
authority to operate the equipment.
RF Exposure Guidance: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment, This equipment should be installed and operated with a minimum distance of 1.5cm? between the
radiator and persons. This transmitter must not be coJocated or operating in conjunction with any other antenna or
transmitter, except in accordance with FCC mum-transmitter product pmcedures
I.C.:
LC. label Statement: IC: 11817A-RF5DW5
This device complies with Industry Canada licenceexempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le present appaieil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence
L’exploitation est eutorisee aux deux conditions suivantes : (1) I'eppareil ne doit pas produire de biouillage, et (2)
I'utilisateur de l'appareil doit accepter tout brouillage mdioelectrique subi, meme si la brouillage est susceptible d’en
compromettre Ie fonctionnement.
Under Industry Canada regulations, this iadio transmitter may only operate using an antenna of a type and maximum
(or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other
users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e,i.r.p.) is
not more than that necessary for successful communication.
Conforme'ment a la reglementetion d'lndustrre Canada, le present emetteur radio peut fonctionner avec une antenne
d'un type et d'un gain maximal (nu inferieur) approuve' pour/emetteurparlndustrie Canada. Dans le but de re’duire
Ies risques de brouillage mdioélectrique a I’intention des autres utilisateurs, iI faut choisir Ie type d'antenne et son
gain de sorta que la puissance isotrope rayonnee equivalents (p.i.r.e.) ne dépasse pas l'intensr'té necessaire a
I'etablissement d’une communication satisfaisante.
0272014 MSS-RFSrl NST REVl

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Page Count                      : 2

EXIF Metadata provided by EXIF.tools