Chia Wei Electric Co FAN-9T Remote Control User Manual 1

Chia Wei Electric Co Ltd Remote Control 1

Contents

Users Manual

FANA UTO
TIMER
User's Manual
Air direction indicator
(Down-cooling; Up-heating)
Fan switch mode select
(High, Medium, Low, Off)
Light switch (ON/Off)
Temperature/T imer set up
Fan s witch
(Manual /A uto)
(Fan; Light; Off)
Set timer
(Temp. at which fan turns on)
Auto mod e temperature setting
Fan switch mode indicator
(Manual/Auto)
Battery indicator
buttons at the same time and hold
To select C/ F,press these two
Room temperature
Lighting status indicator
Fan speed indicator
(Off,Low,Medium,High)
(Down-cooling; UP-heating)
Fan direction select
(Turn light on for 3 minutes)
Temperature / T imer set down
LIGHT DELAY
HOUR
TEMP./SET
FOR/REV
for 3 seconds
(None-OK)
Light delay
(Degree)
(On/ Off)
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.

Navigation menu