ELITEGROUP COMPUTER SYSTEMS TH8AG20GA4 Wireless Motherboard User Manual

ELITEGROUP COMPUTER SYSTEMS CO., LTD Wireless Motherboard

Contents

User manual

TH80GA
Wireless Motherboard Guide
1
FEDERAL COMMUNICATIONS COMMISSION
INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for
help.
CAUTION:
Any changes or modifications not expressly approved by the
grantee of this device could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
2
End Product Labeling
This transmitter module is authorized only for use in device where
the antenna may be installed such that 20cm may be maintained
between the antenna and users. The final end product must be
labeled in a visible area with the following: "Contains FCC ID:
WL6-TH8AG20GA4”
Information for the OEMs and Integrators
The following statement must be included with all versions of this
document supplied to an
OEM or integrator, but should not be distributed to the end user.
1) This device is intended for OEM integrators only.
2) Please see the full Grant of Equipment document for other
restrictions.
This radio transmitter FCC ID: WL6-TH8AG20GA4 has been
approved by FCC to operate with the antenna types listed below
with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not
included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this
device.
Antenna List
No. Manufacturer Part No. Antenna
Type
Peak Gain
1 SOUTH STAR 13H130-JJ5370
PIFA Antenna 2.71 dBi for 2.4GHz
2 SOUTH STAR 13H130-JJ5451 PIFA Antenna 0.46 dBi for 850MHz
1.32 dBi for 1900MHz
.
3
Motherboard layout
Main components
4
Mark Component
A eMCP
B CPU
C RF
System connectors
No. Name
1 WiFi & GPS Antenna Connector
2 TP Connector
3 Battery Connector
5
4 LCD Connector
5 RF Antenna Connector
I/O Ports and Buttons
No. Name
1 Power Connector
2 Headphone plug
3 Micro SD card slot
4 Micro USB port
6
5 SIM card slot
6 SAR Connector
Features
Processor 64-bit Intel® Atom™ Processor
Quad-core, 1.2 GHz
Memory Default 1 GB
Up to 2 GB
Storage Default 8 GB
Up to 16 GB
Wireless
Wi-Fi 802.11 b/g/n
Bluetooth 4.0 LE
2G and 3G
HSDPA+ 21Mhz /HSUPA 5.76
Mbps
Touchscreen
8-inch IPS LCD
Resolution: 800x1280 pixels
10-points multi-touch
Cameras Front: 2M
Rear: 5M
Battery
Li-polymer
3600 mAh
7
Input/Output
1 x micro-USB 2.0 OTG port
(Type B)
1 x Mic/head phone jack combo
1 x micro-SD card slot (32G max)
Speaker &
Mic
Build-in Speaker x 1
Analog MIC
USB charger
DC Output: 5V/2A/10W
Input Voltage: 100 - 240VAC
Input Frequency: 47 - 63Hz
Operating
system Android 6.0
Dimension
(mm) 209 (W) x 125 (H) x 10.5 (D)
Weight 500 g (w/o adapter)

Navigation menu