Fanimation JY1004 CEILING FAN REMOTE CONTROLLER (TRANSMITTER) User Manual

Fanimation, INC CEILING FAN REMOTE CONTROLLER (TRANSMITTER) Model JY1004 with light function

a href="https://usermanual.wiki/Fanimation" itemprop="url"> Fanimation >

User Manual

Model # JY1004 (with light function) DC POWER CEILING FAN REMOTE CONTROL MANUAL □INSTALLATION INSTRUCTIONS NOTE: This unit is to be used for the control of DC power ceiling fan and in an AC120V 60Hz power supply only. Output Power: 40W (Max.) for motor and 190W (Max.) for light. Important: Using a full range dimmer switch (not included) to control fan speed will damage the fan. To reduce the risk of fire or electrical shock, do not use a full range dimmer switch to control fan speed. (1)JY1004 (2)RC205QBT-D1 is a remote controller embedded with Bluetooth Module”CC2541” . It is intend to install with an electrical fan and aims at switching fan speeds and lighting. 1. Switch power off at fuse box or circuit breaker before you begin installing the fan. 2. Make wiring connections as indicated Fig. 1. 3. Launch distance for remote control: about 10m. 4. The remote code setting process: Step: 1 Open the remote battery cover and install 3V,CR2032, 2pcs Lithium batteries, with the fan power off. (Fig. 2) Step: 2. Within 30 seconds of restring power to the fan, you must use a ball pen or tool to press “SET” button about 5 seconds, (Fig. 3). Once the receiver has detected the frequency, the receiver will make sound, Bi Bi, twice and light flicker twice and turn off. This will indicate the receiver has learned the frequency that was previously selected on the transmitter. Note: After the AC power is on, do not press any other button on the transmitter before setting learning. Doing so will cause the procedure to fail. After completing the steps above, you should be able to operate the ceiling fan and light. If the fan is not responding to the transmitter, please turn the power off to the receiver. And repeat step 2. □LIGHT FUNCTION SELECT SWITCH If installed energy light onto ceiling fan, please slide the dip switch, light function select switch, to “O” position. If installed tungsten light onto ceiling fan, please slide the “light function select switch” to “D” position. (Fig. 4) □FUCNCTIONS OF REMOTE CONTROL: (Fig. 5) Indicator LED light: fan speed or light dimmer indicator button: Tape once turn off the fan. Press and hold this button for 5 seconds to turn on or turn off the buzzer. Fan speed: Turn on the fan and turn speed up. Turn on the fan and turn speed down. Light button: Turn on or off the light. Increase light output level. Decrease light output level. (Tungsten only and light function select switch on dimmer position.) Sleep Timer: Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5
Download:
Mirror Download [FCC.gov]
Document ID2931983
Application IDP8Ro16Q+kpgruhvDI7R0+w==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize14.79kB (184857 bits)
Date Submitted2016-03-16 00:00:00
Date Available2016-03-16 00:00:00
Creation Date2016-02-18 13:54:17
Document Lastmod2016-02-18 13:54:17
Document TitleModel # JY1004 (with light function)
FCC ID Filing: 2ABGUJY1004

Navigation menu