GE MDS DS9710N-1 Remote Data Transceiver User Manual

GE MDS LLC Remote Data Transceiver 3305B x710A C Body

a href="https://usermanual.wiki/GE-MDS" itemprop="url"> GE MDS >

Users Manual Revised

Installation and Operation Guide MDS 05-3305A01, Rev. BSEPTEMBER 2000 400 MHz/900 MHzRemote Data Transceiver MDS 4710/9710 Series (Including MDS 4710A/C and MDS 9710 A/C)
QUICK START GUIDE Below are the basic steps for installing the transceiver. Detailed instructions are given in “INSTALLA-TION” on page 9 of this guide. 1. Install and connect the antenna system to the radio • Use good quality, low loss coaxial cable. Keep the feedline as short as possible.• Preset directional antennas in the direction of desired transmission. 2. Connect the data equipment to the radio’s INTERFACE connector • Connection to the radio must be made with a DB-25 Male connector. Connections for typical sys-tems are shown below. • Connect only the required pins. Do not use a straight-through RS-232 cable with all pins wired.• Verify the data equipment is configured as DTE. (By default, the radio is configured as DCE.) 3. Apply DC power to the radio (10.5–16 Vdc @ 2.5 A minimum) • Observe proper polarity. The red wire is the positive lead; the black is negative. 4. Set the radio’s basic configuration with a Hand-Held Terminal (HHT) • Set the transmit frequency ( TX xxx.xxxx ).• Set the receive frequency ( RX xxx.xxxx ).• Set the baud rate/data interface parameters as follows. Use the BAUD xxxxx abc command, where xxxxx equals the data speed (110–38400 bps) and abc equals the communication parameters as follows: a = Data bits (7 or 8) b = Parity (N for None, O for Odd, E for Even c = Stop bits (1 or 2)(Example: BAUD 9600 8N1 )NOTE: 7N1, 8E2 and 8O2 are invalid parameters and are not supported by the transceiver. 5. Verify proper operation by observing the LED display • Refer to Table 5 on page 16 for a description of the status LEDs.• Refine directional antenna headings for maximum receive signal strength using the RSSI command. DB-25 DB-25TRANSCEIVER(DCE)2323RTU(DTE)45206DSR DSR6TXDRXDGNDRTSCTSTXDRXDGND4CTS5RTSDB-9 DB-25DB-9 to DB-25 ExampleDB-25 to DB-25 Example1145TRANSCEIVER(DCE)2332RTU(DTE)5207RXDTXDDCDGNDDSRRTSRXDTXDDCDGNDAs required for application51876CTSDSRRTSCTS864577GND GND8 8DCD DCDAs required for application
Download:
Mirror Download [FCC.gov]
Document ID577394
Application IDIWI4esG82Nm2YMN+6JiNkg==
Document DescriptionUsers Manual Revised
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize188.17kB (2352077 bits)
Date Submitted2005-09-01 00:00:00
Date Available2005-09-01 00:00:00
Creation Date2000-09-26 16:51:06
Producing SoftwareAcrobat Distiller 4.0 for Macintosh
Document Lastmod2005-08-20 13:37:20
Document Title3305B-x710A,C Body.book
Document CreatorFrameMaker 5.5
Document Author: MDS Employee
FCC ID Filing: E5MDS9710N-1

Navigation menu