GemTek Technology WLTCS106 WiMAX Gateway User Manual

Gemtek Technology Co., Ltd. WiMAX Gateway 11 UserMan MXF WLTCS106 rev

a href="https://usermanual.wiki/GemTek-Technology" itemprop="url"> GemTek Technology >

Contents

11. UserMan_MXF-WLTCS106_rev

Outdoor Gateway Quick Installation Guide    1 Introduction  This Quick Installation Guide covers the basic installation of the Outdoor Gateway.    Overview The Outdoor Gateway is a WiiMAX subscriber station designed to provide Internet access for a home or small  office.  The  Outdoor  Gateway  includes  an  outdoor  unit  (ODU)  connected  to  a  supply  unit  (IDU).  The  ODU provides the WiMAX Internet link, and the IDU serves as the gateway for a local Ethernet wired.  The indoor unit includes:  •  One standard RJ-45 Ethernet port for LAN connections.    •  One 8 PIN RJ-45 Ethernet port for connection to the ODU. This cable provides a dedicated Power-over-Ethernet (PoE) power supply to the ODU, as well as a data link between the ODU and the IDU. The IDU should be connected to an AC power connection.       Installing the ODU  Before installing the ODU, verify that you have all the items listed in the package checklist. If any of the items are missing or damaged, contact your WiMAX service provider.    Selecting a Location  The ODU should be pole-mounted outdoors and aligned so its antenna faces the nearest WiMAX base station. When selecting a suitable location for the unit, consider these guidelines:  •  Place the ODU as high as possible to achieve the best possible link quality.    •  Place the ODU away from power and telephone lines.    •  Avoid placing the ODU too close to any metallic reflective surfaces.    •    Be sure to ground the ODU with an appropriate grounding wire (not included) by attaching it to the grounding screw on the unit and to a good ground connection.
Outdoor Gateway Quick Installation Guide    2 Additional information:  Check below items before installing the outdoor CPE: •  One RJ-14 connector for connecting to the telephone line. •  One RJ-45 connector for connecting to the PoE adaptor. •  LED indicator inside and SIM card slot for inserting SIM card. •  A grounding screw on the rear panel.                    Mounting the ODU Mount the ODU unit on a 1"-4" pole using the supplied kit (Figure 1), or the optional Tilt accessory.  Using the Clamp  1  Thread the M10*100mm bolt through a spring washer, flat washer and the bracket holes.   2  With the connector facing downward, attach the ODU to a 1" -4" pole.   3  Attach the bracket to the other side of the pole.   4  Thread the M10*100 mm bolts through both holes on either side. Tighten the nuts.    Figure 1: Mounting the ODU on the Pole
Download:
Mirror Download [FCC.gov]
Document ID2237570
Application IDHtaXf9RKAoxr7OT0KWORRg==
Document Description11. UserMan_MXF-WLTCS106_rev
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize74.67kB (933382 bits)
Date Submitted2014-04-10 00:00:00
Date Available2014-04-10 00:00:00
Creation Date2017-10-23 07:21:42
Producing SoftwareGPL Ghostscript 9.18
Document Lastmod2017-10-23 07:21:42
Document Title11. UserMan_MXF-WLTCS106_rev
FCC ID Filing: MXF-WLTCS106

Navigation menu