GemTek Technology S941212G IEEE802.11g SDIO Wireless LAN Card User Manual 3 XDW

Gemtek Technology Co., Ltd. IEEE802.11g SDIO Wireless LAN Card 3 XDW

Manual

 This device is intended only for OEM integrators under the following conditions: 1)  The antenna must be installed such that 20 cm is maintained between the antenna and users, and  2)  The transmitter module may not be co-located with any other transmitter or antenna. 3)  The module must be completely embedded inside the final product and there is no direct access from outside to remove the module without opening the product chases with a tool. 4)  OEM shall not display or instruct the user how to install or remove the module. As long as 4 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).  IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.  End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users (for example : Projecter, Audio system). The final end product must be labeled in a visible area with the following: “Contains TX FCC ID: MXF-S941212G ”.  Manual Information That Must be Included The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the users manual of the end product which integrate this module.  The users manual for OEM integrators must include the following information in a prominent location “ IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.

Navigation menu