GemTek Technology WLTFQT141GN Cat4 Indoor CPE User Manual

Gemtek Technology Co., Ltd. Cat4 Indoor CPE Users Manual

Users Manual

       BC-4GMCPGa Quick Installation Guide
Getting to Know your Device               1. SIM card Slot Cover: Open the cover and insert SIM card into the slot with right direction.  2. Telephone Port (RJ-11): Connect your telephone to Dual-Band Modem with a RJ-11 telephone cable.  3. LAN Port (RJ-45): Port for connecting PC, hub and switch or other network equipment by RJ-45 Ethernet cable.  4. WPS Button: Press “WPS” button, so, router can easily connects to client which also support WPS function.  5. Reset Button: Press “Reset” button less than 5 seconds to reboot the device. Or press and hold the Reset button 10 seconds to set router to factory default settings.  6. Power Adapter Socket (DC-12V): Plug adapter DC pin into this socket.  7. Power Switch
Installation Please follow the steps below to install the device:  Step1: Insert SIM card into the device with right direction.  Step2: Insert the power cord into the DC-12V power jack; and insert the plug into power outlet.  Step3: Power ON the device using the switch button. The device will start the booting process.  After a few seconds, the LED lights will start blinking.  Step4: Connect the RJ 45 Ethernet cable to the LAN port of the device and your PC, or connect wirelessly using the default SSID and Password at the back label of your device.
Easy Setup Please follow the steps below to configure your device through the web interface:  Step1: Open the Web browser (Internet Explorer) and enter the default IP address of the Dual-Band Modem : http://192.168.1.1 Step2: Enter Dual-Band Modem administrator login username/password to access the web management interface. The default username/password is admin/admin.   Step3: The main page after login will display the default setting of SSID, Encryption, and Password.   Step4:  You could specify an SSID (Service Set ID) and Password then click Apply.
Troubleshooting Tips  If you are experiencing any issues with your device:  Restart your device.  Restore your device to its factory default settings.  Contact Telefonica Network or visit the website http://www.telefonica.com.ar/
Federal Communication Commission Interference Statement This  equipment  has  been  tested and found to comply with  the  limits  for  a  Class B digital  device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against  harmful  interference  in  a  residential  installation.  This  equipment  generates,  uses  and  can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause  harmful  interference  to  radio  communications.    However,  there  is  no  guarantee  that interference  will  not  occur  in  a  particular  installation.    If  this  equipment  does  cause  harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: -  Reorient or relocate the receiving antenna. -  Increase the separation between the equipment and receiver. -  Connect  the  equipment into  an  outlet  on  a  circuit  different  from  that  to  which  the  receiver  is connected. -  Consult the dealer or an experienced radio/TV technician for help. FCC  Caution:  Any  changes  or  modifications  not  expressly  approved  by  the  party  responsible  for compliance could void the user's authority to operate this equipment. This  device  complies  with  Part  15  of  the  FCC  Rules.  Operation  is  subject  to  the  following  two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC  Caution:  Any  changes or modifications  not  expressly  approved  by the  party  responsible for compliance could void the user's authority to operate this equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. This  transmitter  must  not  be  co-located  or  operating  in  conjunction  with  any  other  antenna  or transmitter.  Country Code selection feature to be disabled for products marketed to the US/CANADA.  Operation of this device is restricted to indoor use only.

Navigation menu