Hon Hai Precision Industry WFU03 WiFi Module User Manual

Download:
Mirror Download [FCC.gov]
Document ID	1901791
Application ID	EhymclOoikbgN/NgRUpJhg==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	29.18kB (364755 bits)
Date Submitted	2013-02-19 00:00:00
Date Available	2013-08-19 00:00:00
Creation Date	2013-02-05 14:51:23
Producing Software	Microsoft® Word 2010
Document Lastmod	2013-02-06 16:34:18
Document Title	User Manual
Document Creator	Microsoft® Word 2010
Document Author:	user

Foxconn WFU03 Series
Foxconn WFU03 series
Hardware
Specification
第 1 頁
Foxconn WFU03 Series
Introduction
Product Overview
The Foxconn WFU03 series wireless LAN module contains the Ralink® MT7601 single
chip which is a highly integrated MAC/BBP for 2.4GHz RF transmission and supporting
150Mbps PHY rate. It fully complies with IEEE 802.11 b/g/n feature rich wireless
connectivity at high standards, delivers reliable, cost-effective, throughput from an extended
distance. The optimized radio frequency architecture and baseband algorithms provide super
performance and low power consumption. Deploy a high efficient USB engine and hardware
data processing accelerators without overloading the host processor. Security, quality of
service and international regulation are supported by WFU03 series and giving end users the
greatest performance anytime in any circumstance.
Key Features
 Legacy data rates 1, 2 in DSSS mode and rates 5.5, and 11 Mbps in CCK
mode, 6, 9, 12, 18, 24, 36, 48, and 54 in OFDM mode
 Support 40MHz wide channel bandwidth
 Uses the 2.412 to 2.497GHz ISM frequency band defined by the IEEE
802.11b/g/n specifications









Reverse direction grant data flow and frame aggregation
WEP 64/128, WPA, WPA2, TKIP, AES, WAPI
QoS-WMM, WMM-PS, WPS/WPS2, PIN, PBC
Multiple BSSID Support
Fully compliance with USB 2.0 high-speed mode
Form Factor: PCI Express 1.1 Half Mini Card(single side)
International Regulation – 802.11d/h/k
Supports Wi-Fi Direct
Low power with advanced power management
第 2 頁
Foxconn WFU03 Series
Electrical Specifications
Pin Definitions
Table. Pin Definitions
Pin
# Name
Pin
# Name
51
N/A
52
+3.3V
49
N/A
50
GND
47
N/A
48
N/A
45
N/A
46
N/A
43
GND
44
LED_WLAN#
41
+3.3V
42
N/A
39
+3.3V
40
GND
37
GND
38
USB_D+
35
GND
36
USB_D-
33
N/A
34
GND
31
N/A
32
N/A
29
GND
30
N/A
27
GND
28
N/A
25
N/A
26
GND
23
N/A
24
N/A
21
GND
22
PERST#
19
N/A
20
W_DISABLE#
17
N/A
18
GND
Mechanical Key
15
GND
16
N/A
13
N/A
14
N/A
11
N/A
12
N/A
GND
10
N/A
CLKREQ#
N/A
N/A
N/A
N/A
GND
WAKE#
+3.3V
DC Specifications
The Max Power (as max defined in the Mini-card Spec) is 2000mW  667mA (need at lease
第 3 頁
Foxconn WFU03 Series
2 Power Pins of the 5 exists in the Mini-Card spec, Max limit for each Pin is 500mA).
For all MiniCard voltage rails (3.3V), it is recommended not to exceed 100mVpp noise in the
frequency range of 10-500KHz.
Table DC Specifications
Parameters
Symbol
3.3V Supply Voltage
Conditions
Min.
3.0
+3.3V
Typ. Max.
3.3
3.6
Unit
Receiver
3.3 V Current consumption
Icc 33rx
HT 40MHz MCS 7
200
mA
300
mA
Transmitter
3.3 V Current consumption
Icc 33tx
HT 40MHz MCS 7
Power Consumption Specifications
Power consumption is measured using current probe loop on the Power rails of the USB
interface (Pins). Assuming ASMP enabled (L1-active enabled and L0s is disabled).
Table. Power Consumption Specifications(preliminary)
Description
Typical
Unit
Sleep mode
1.1
mA
Rx Active, HT40, MCS7
151
mA
Rx Power Saving. DTIM=1
15
mA
Rx Listen
mA
Tx HT40, MCS7 @15dBm
210
mA
Tx CCK, 11Mbps @19dBm
242
mA
第 4 頁
Foxconn WFU03 Series
Antenna Specifications
Nominal antenna port impedance specification is 50 ohms for the Foxconn WFU03 series
hardware.
For regulatory requirements, it is assumed that the antenna gain is:
 Antenna gain for the 2.4GHz band : 2.5 dBi
There are two antennas supporting 2.4-2.5GHz band.
The Foxconn HD96017 connector will be used on the Foxconn WFU03 series hardware.
The antenna will be defined Main and Aux where is listing below:
Figure WFU03 series Perspective
Label Specifications
Figure 5.3 WFU03 Label Drawing
第 5 頁
Foxconn WFU03 Series
Environmental Specifications
The following tables provide normal operating conditions and maximum rating requirements
for WFU03 series hardware.
Table . Operating Conditions (preliminary)
Environment
Limits
Operating
-10-70℃
※The radio parts at operating state and above temperature of T-shield.
Table . Non-operating Conditions (preliminary)
Temperature
Environment
Humidity
Min. Typ. Max. Unit Min. Typ. Max. Unit
Non-Operating
-40
25
85
℃
45
90
※ Temperature condition for storage (Packaged) in warehouse is Maximum 40℃ up to 6 months.
Part Numbering
ID Definitions
Table ID Definitions
WLAN Type
Mode
PID
VID
WFU03UXXX-MT7601U
BGN
0x7601
0x148F
第 6 頁
Foxconn WFU03 Series
Module Photo
Top side
Bottom side
第 7 頁

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print, Extract, Print high-res
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Create Date                     : 2013:02:05 14:51:23+08:00
Creator Tool                    : Microsoft® Word 2010
Modify Date                     : 2013:02:06 16:34:18+08:00
Metadata Date                   : 2013:02:06 16:34:18+08:00
Format                          : application/pdf
Creator                         : user
Producer                        : Microsoft® Word 2010
Document ID                     : uuid:94e68fc2-b0f5-4935-8d35-9b7e124fa384
Instance ID                     : uuid:b46a6888-2a0b-4df4-a3cb-0ef74246be23
Page Count                      : 7
Language                        : zh-TW
Author                          : user

EXIF Metadata provided by EXIF.tools