Intermec Technologies 03CN4 Handheld PDA-type device WCDMA/GSM/GPRS/EDGE User Manual
Intermec Technologies Corporation Handheld PDA-type device WCDMA/GSM/GPRS/EDGE 935 029
a href="https://usermanual.wiki/Intermec-Technologies" itemprop="url">
Intermec Technologies >
Contents
- 1. Users Manual
- 2. Manual Compliance Insert
- 3. revised Compliance Insert
Manual Compliance Insert
![Models CN4 and CN4e Compliance Insert The users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of accessories other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may void the compliance of this product and may result in the loss of the user’s authority to operate the equipment.Battery Information Battery Recycling InformationNote: In the U.S.A., the EPA does not consider spent Li-ion batteries as hazardous waste.Laser Compliance and PrecautionThe CN4 is registered with the CDRH as a Class I LASER Product (21 CFR Subchapter J, Part 1040 with Laser Notice 50).Note: There are no controls or adjustments provided for routine operation or maintenance of the CN4.Laser and Imager Compliance and PrecautionThis product complies with the following standards for laser and LED safety:•IEC 60825-1 / EN 60825-1 - Class 1 (embedded laser component < 3 mW)本產品的使用者必須小心使用 Intermec Technologies Corporation 許可的配件與週邊設備。使用非上述建議的配件,或是在未經 Intermec Technologies Corporation 許可的情況下變更本產品可能會使得本產品的相容性失效,並且使得使用者喪失操作設備的權力。Caution: This marking indicates that the user should read all included documentation before use.Caution: For use with Intermec battery pack Model(s) AB8, AB9, AB15, and AB16 only. For power supply, use Intermec Model 074246 or AE13 (P/N 851-089-x03). Do not connect and charge the CN4 or CN4e if the temperature is greater than 50°C (122°F). No user-serviceable parts.Caution: The battery pack used with this product may ignite, create a chemical burn hazard, explode, or release toxic materials if mistreated. Do not incinerate, disassemble, or heat above 100°C (212°F). Do not short circuit; may cause burns. Do not charge batteries in a temperature above 40°C (104°F). Keep away from children. Charge only in or with Intermec Model(s) AC12, AD10, AD11, or AD12. Use of incorrect charger or battery packs may present risk of fire or explosion. Promptly dispose of used battery pack according to the instructions.Li-ionLi-ionThis product contains or uses a lithium-ion (Li-ion) main battery. When the battery reaches the end of its useful life, the spent battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the solid waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information.Caution: There are no user serviceable parts inside the CN4. Use of controls or adjustments, or performances of procedures other than those specified herein, may result in hazardous laser light exposure.注意:此標誌表示使用者應在使用前先閱讀所有隨附的文件。注意:僅適用於 Intermec AB8、AB9、AB15 或 AB16 型電池。 請使用 Intermec 074246 或 AE13 (P/N 851-089-x03) 型電源。 如果環境溫度高于 50ºC,切勿連接 CN4 或 CN4e 爲其充電。無使用者可自行維修之零件。](https://usermanual.wiki/Intermec-Technologies/03CN4.Manual-Compliance-Insert/User-Guide-1124715-Page-1.png)
![電池資訊電池回收資訊雷射和線性影像感應器之相容性與安全措施本產品符合以下雷射及 LED 安全標準:•IEC 60825-1 / EN 60825-1 - Class 1 (內含的雷射元件 < 3mW)Utilisateurs de ce produit sont avisés d’utiliser des accessoires et des périphériques approuvés par Intermec Technologies Corporation. L’utilisation d’accessoires autres que ceux recommandés ou des changements à ce produit qui ne sont pas approuvés par Intermec Technologies Corporation peuvent annuler la conformité de ce produit et mettre fin au droit qu’a l’usager d’utiliser l’équipement.Informations pour la pileInformations pour le recyclage de la pileConformité et précautions pour l’utilisation du laserLe CN4 est enregistré auprès du CDRH à titre de produit au laser de Classe I (21 CFR Sous-chapitre J, Partie 1040 avec avis sur le laser 50). La sortie maximale de ce produit est de 1,0 mW à 630-670 nm.Remarque : Il n’y a pas de contrôles ou d’ajustements fournis pour le fonctionnement ou l’entretien périodique du CN4.Conformité et précautions pour l’utilisation du laser et de l’imageurCe produit est conforme aux normes suivantes visant la sécurité quant au laser: •IEC 60825-1/EN 60825-1 - Classe 1 (composant laser intégré < 3 mW)注意:此裝置中所用的電池必須小心處理,否則可能會燃燒、造成化學灼傷、爆炸或釋放出有毒物質。請勿焚燒、拆卸或使其溫度超過 100°C (212°F)。 環境溫度高于 40ºC 時,切勿對電池充電。請勿短路,否則可能會導致灼傷。請放在兒童拿不到的地方。只能使用 Intermec AC14、AD10、AD11 和 AD12 型充電器充電。充電器或電池使用不當可能會引發起火或爆炸。 請依照指示及時棄置用過的電池。Li-ionLi-ion本產品包含或使用鋰 ( 鋰離子 ) 主電池。當電池已達其使用壽命,應將其置於合格的回收筒或危險物質的處理裝置中。請勿將此電池與固體廢棄物混在一起。如需暸解電池的回收或棄置資訊,請聯絡 Intermec Technologies 客服中心。Attention: Ce marquage indique que l’usager doit, avant l’utilisation, lire toute la documentation incluse.Attention: Pour utilisation avec les bloc-piles AB8, AB9, AB15 et AB16 Intermec exclusivement. Pour l’alimentation, utiliser le modèle Intermec 074246 ou AE13 (N/P 851-089-x03). Ne pas brancher ni charger le CN4 ou le CN4e lorsque la température est supérieure à 50 °C. Ne contient aucune pièce réparable par l’utilisateur.Attention: Le bloc-piles utilisé dans cet appareil peut prendre feu, constituer un risque de brûlure chimique, exploser ou dégager des substances toxiques s’il est manipulé de façon inappropriée. Ne pas jeter au feu, démonter ou chauffer à plus de 100 °C (212 °F). Ne pas court-circuiter; cela pourrait causer des brûlures. Ne pas charger les piles lorsque la température est supérieure à 40 °C. Garder hors de la portée des enfants. Ne charger qu’avec les modèles AC14, AD10, AD11et AD12 d’Intermec. L’utilisation d’un chargeur ou de blocs-piles inappropriés présente un risque d’incendie ou d'explosion. Mettre rapidement au rebut tout bloc-piles usé, conformément aux instructions.Li-ionLi-ionCe produit contient ou utilise une pile principale au lithium-ion (Li-ion). Lorsque la batterie atteint la fin de sa durée de vie utile, la batterie usées doivent être mises aux rebuts par un agent de recyclage ou un manipulateur de matériaux dangereux agréé. Il ne faut pas mélanger la batterie aux autres déchets solides. Pour plus d’informations sur le recyclage ou la mise aux rebuts, contacter votre centre de services Intermec Technologies.Attention: Le CN4 ne contient aucune pièce réparable par l’utilisateur. L’utilisation de commandes ou de réglages, ou l’exécution de procédures autres que ce qui est spécifié aux présentes, peut présenter une exposition dangereuse à la lumière laser d'une intensité allant jusqu'à 1 mW à 630-670 nm.Vorsicht: Diese Kennzeichnung weist darauf hin, dass der Benutzer vor dem Gebrauch alle mitgelieferten Unterlagen lesen soll.](https://usermanual.wiki/Intermec-Technologies/03CN4.Manual-Compliance-Insert/User-Guide-1124715-Page-2.png)