J and M JMCB-2003 Motorcycle Mount Mobile CB Transceiver User Manual Part 90

J&M; Corporation Motorcycle Mount Mobile CB Transceiver Part 90

Contents

Manual

Rhein Tech Laboratories Client: J & M Corp. 360 Herndon Parkway Model: JMCB-2003 Suite 1400 Standards: FCC Part 95/IC RSS-136 Herndon, VA 20170 Report Number: 2003126 http://www.rheintech.com Date: August 21, 2003 45 of 63 APPENDIX I: MANUAL Please refer to the following pages.
Quality Motorcycle AudioJMCB-2003Handlebar-mounted 40 Channel Citizen’s Band Transceiver (CB)/Weather Radio with Rider-Passenger Intercomand Auxiliary Audio InputOwner’s Manual© COPYRIGHT 2003 J&M CORPORATION. ALL RIGHTS RESERVED
Table of ContentsProduct Description Section 1.FCC Regulations Section 2.Performance Features Section 3.Package Contents Section 4.Controls and Functions Section 5.Installation Instructions Section 6.Operation Instructions Section 7.Antenna Information Section 8.CB Channel Frequency Chart Section 9.Specifications Section 10.Warranty Statement Section 11.2. FCC RegulationsYou do not need an FCC license to operate this radio in the United States. However, youmust know and be familiar with Part 95 of the FCC Rules in regard to Subpart D of theCitizen’s Band Radio Service, a copy of which is enclosed in the JMCB-2003 packaging.1. Product DescriptionThe JMCB-2003 is a compact Citizen’s Band radio designed to operate in the 26.965MHz to 27.405 MHz band. This lightweight unit also features rider-to-passenger intercom, an auxiliar y audio input for an audio source such as an MP-3 player, and tenweather channels, consisting of seven NOAA frequencies and three international marinefrequencies.
3. Performance Features• Maximum legal RF output Power (4W) with high-level modulation (in accordance with FCC Part 95 rules).• Radio receives current National Weather Service broadcasts on one or more of seven separate frequencies and periodic marine weather information on three separate frequencies.• Hi/Lo TX Power selection button• Built-in automatic gain control (AGC)• Phase locked loop synthesizer provides clear voice transmission and reception on all CB channels• Integrated rider-passenger intercom• Auxiliary audio input (stereo)4. Package Contents• CB unit JMCB-2003• 12V Power harness• Headset connection cables• Auxiliary audio input cable• Owner’s manual• Copy of FCC Part 95, Subpart D• Copy of NOAA Weather Network frequency list
5 Controls and FunctionsA. Auxiliary Audio Volume—Controls auxiliary audio/input volume to the headsets.B. Squelch Control—Allows CB background noise to be eliminated when no signal is present.C. On/Off CB and Intercom Volume Control—In the inward position the knob turns theentire unit on and off and controls the CB volume. In the pulled-out position, the knobcontrols the intercom volume.D. Push-To-Talk Lever—Activates CB radio transmission mode.E. Hi/Lo Power Selector Button—Controls CB TX power level.F. Channel Up—Selects any one of the 40 channels available on the CB radio. It isalso used to select any one of the 10 weather channels in the Weather Mode.G. Channel Down—Selects any one of the 40 channels available on the CB radio. It isalso used to select any one of the 10 weather channels in the Weather Mode.H. Mode—Used to select CB channels, weather channels or keypad beep.I. LCD Display—Identifies CB or weather channe, Tx (transmit), Wx (weather mode), andsignal/power strength.A.B.C.D.E. F. G. H. I.
J. Helmet Headset Plugs—Allows hookup to J&M helmet headsets.K. 12V DC Power Cord—Provides power and ground for the JMCB-2003.L. PL-258 Connector—Antenna connector for a rear-mounted CB antenna.M. 3-Pin Connector—Connects auxiliary audio input to a Walkman®-type music deviceor other type of stereo radio system.N. Auxiliary Audio Cable—Connects to a Walkman®-type music device.torear-mountedCB antenna(not included)personal stereo/CD/MP3/cassette music device(not included)optional passenger CB transmit switchJ&M #PCS-485(not included)automotive-type radio adapterJ&M #FGA-290(not included)black3-pin plugground to framefuseholderinlinenoisefilter12 volt switchableLeft speaker(not included) Right speaker(not included)Fairing mountedradio or booster amp(not included)WHITE WHITE / REDREDRED / WHITEORblack3-pinplugwhite9-pinplugfemale 6-pin din6-pinlocking din6-pin dindriver's helmet headset(not included)passenger's helmet headset(not included)J.J.K.L.M.N.
6. Installation Instructions 1) Mount the JMCB-2003 to the left handlebar using the mounting bracket kit that isapplicable to your specific make and model of motorcycle. (Mounting Bracket Kits aresold separately.) 2) Route the wires from the CB radio down the handlebar. Plug in the white 9-pin plugfrom the supplied wiring harness. Connect the power wire (red) to a switchable powersource or accessor y terminal so that the unit is automatically turned off when the igni-tion is turned off. Connect the black wire to a frame ground (not to the battery nega-tive). If it becomes necessary to replace the fuse, use a 5 amp fuse for the red wire.3) Connect the black 3-pin plug to the auxiliary audio cable and route the cable to theauxiliary audio source.4) Route all other cables where desired and hook them up according to the wiring dia-gram.5) Secure all wires and cables with the zip ties provided.7. Operation of the JMCB-20031) With a helmet headset connected to the JMCB-2003 turn the ignition switch to theON position.2) Rotate the SQUELCH knob on the JMCB-2003 fully clockwise.3) Adjust the OFF/ON CB volume knob to a comfortable volume level and select thedesired CB channel.4) Rotate the SQUELCH knob counterclockwise until the background noise is removed.5) Plug in your auxiliary audio/music device and adjust the AUX VOL control on theJMCB-2003 fully clockwise to maximum volume. Adjust the volume on the auxiliaryaudio source to a maximum level just before distortion and then adjust the AUX VOLcontrol on the JMCB-2003 down to comfortable level. Further volume adjustmentswhile riding should be made with the CB mounted AUX VOL control only.6) The intercom volume can be adjusted by pulling out the CB VOL OFF/ON knob.Turning the knob clockwise will increase the intercom volume. When the intercom has
been adjusted to a comfortable level, push the VOL OFF/ON knob back to the inwardposition.7) Weather channels can be accessed by depressing the MODE button once then usingthe CH UP and CH DN buttons to select one of the ten weather channels. The National Weather Service uses several special radio frequencies to provide con-tinuous reports of the local weather conditions and forecasts throughout the UnitedStates. Taped weather messages are repeated every four to six minutes on a 24-hourbasis and are routinely revised every one to three hours, or more frequently if needed.During severe weather, the routine weather broadcasts will be interrupted with spe-cial weather warning messages.The JMCB-2003 is designed to receive all these special weather frequencies plusthree international marine frequencies. An NOAA Weather Radio Network Frequencypamphlet is enclosed to identify the frequencies specifically broadcast for your geo-graphical area.The JMCB-2003 receives CB, National Weather Service and international marineweather broadcast frequencies as listed below:CB Channels 1-40 26.965 to 27.405 MHzWeather Channels 01WX 162.550 MHz02WX 162.400 MHZ03WX 162.475 MHz04WX 162.425 MHz05WX 162.450 MHz06WX 162.500 MHz07WX 162.525 MHzInt’l Marine 08WX 161.650 MHz09WX 161.775 MHz00WX 163.275 MHz8) Function indication “beep” can be turned on or off by depressing the MODE buttontwo (2) times. The LCD display will show the word ON or OFF. To turn the beep on oroff, switch between the CHL UP and CHL DN buttons.
8. Antenna InformationThe maximum allowable CB transmitting power is limited by FCC regulations. Theantenna is a major component in the strength of the CB radio’s transmission signaland its reception range.A minimum distance of 18” between the CB antenna and the operator or passenger ofthe motorcycle should be maintained.
Channel 1 26.965 MHz2 26.975 MHz3 26.985 MHz4 27.005 MHz5 27.015 MHz6 27.025 MHz7 27.035 MHz8 27.055 MHz9 27.065 MHz Emergency Channel10 27.075 MHz11 27.085 MHz12 27.105 MHz13 27.115 MHz14 27.125 MHz15 27.135 MHz16 27.155 MHz17 27.165 MHz18 27.175 MHz19 27.185 MHz Highway Channel20 27.205 MHzChannel21 27.215 MHz22 27.225 MHz23 27.255 MHz24 27.235 MHz25 27.245 MHz26 27.265 MHz27 27.275 MHz28 27.285 MHz29 27.295 MHz30 27.305 MHz31 27.315 MHz32 27.325 MHz33 27.335 MHz34 27.345 MHz35 27.355 MHz36 27.365 MHz37 27.375 MHz38 27.385 MHz39 27.395 MHz40 27.405 MHz9. CB Channel Frequency ChartWARNING: Do not try to make any internal adjustments.Any internal adjustments must be made only by qualified technical personnel.Internal adjustments and/or modifications can lead to illegal operation as definedby FCC Rules and REgulations, Part 95. Illegal operation can result in serious con-sequences.
10. SpecificationsCB Channels 40CB Frequency Range 25.965 to 27.405 MHzWeather Channels 10Weather Frequency Range and International Marine 162.550 MHz - 163.275 MHzCB/Weather frequency control Phase locked loop (PLL) synthesizerOperation temperature range – 4°F to +122°FChannel display Liquid crystal display (LCD)Power source 13.2V DCDimensions 6.5” x 3” x 1.75”(165.1 mm x 76.2 mm x 44.5 mm)Weight .8 lbReceiver AM dual conversion superheterodyneTransmitter 4 watts (maximum FCC allowable)Noise and InterferenceMotorcycle audio systems are by their very nature noisy. While we do not guarantee thissystem to be completely free from electrical noises and interference, we have takenmany steps to achieve that goal: the power supply system is well filtered and the cablesassociated with the unit are shielded.Most modern day motorcycles have resistor-type spark plugs installed by the factory. It maybe necessary to insure that resistor-type spark plugs are installed on your motorcycle.
Two Year WarrantyJ&M Corporation warrants each new product it manufactures to be freefrom defective materials and workmanship and agrees to remedy anysuch defect or replace the unit (at our option), provided the unit is deliv-ered to us, intact, for our examination, with all transportation chargesprepaid to our factory, within two (2) years from the date of the sale tothe original purchaser. The provisions of the warranty shall not apply toany unit which has been subject to misuse, neglect, incorrect mechani-cal or electrical installation, unauthorized modifications, accident, nor tounits which have been repaired or altered outside of our factory.Thank you for the confidence you have shown by purchasing one of J&M’s innovative products. If you have any questions during installation, or require further assistance, youmay call us at 1-800-358-0881 from 8:00 a.m. to 5:00 p.m. Mountain Standard Time,Monday through Friday.1415 S. Cherry Avenue, Tucson, Arizona 85713-1997 U.S.A.(800) 358-0881 • www.jmcorp.com • audio@jmcorp.com7/2003

Navigation menu