JVC KENWOOD 500000 UHF DIGITAL TRANSCEIVER User Manual 2 of 2

Download:
Mirror Download [FCC.gov]
Document ID	3775183
Application ID	+d/DU8tB7a/FSNQDAw7bBA==
Document Description	Users Manual - 2 of 2
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	7.75kB (96889 bits)
Date Submitted	2018-03-09 00:00:00
Date Available	2018-03-09 00:00:00
Creation Date	2017-04-07 09:44:41
Producing Software	iTextSharp™ 5.5.8 ©2000-2015 iText Group NV (AGPL-version); modified using iTextSharp™ 5.5.8 ©2000-2015 iText Group NV (AGPL-version)
Document Lastmod	2017-04-07 09:44:42
Document Title	Users Manual - 2 of 2
Document Creator	CubePDF

Radio Frequency Energy Safety Information
This KENWOOD transceiver has been tested and complies with the standards listed below, in regards to
Radio Frequency (RF) energy and electromagnetic energy (EME) generated by the transceiver.
•
FCC RF exposure limits for Occupational Use Only. RF Exposure limits adopted by the FCC are
generally based on recommendations from the National Council on Radiation Protection and
Measurements, & the American National Standards Institute.
•
FCC OET Bulletin 65 Edition 97-01 Supplement C
•
American National Standards Institute (C95.1 – 1992)
•
American National Standards Institute (C95.3 – 1992)
This KENWOOD transceiver generates RF EME while transmitting. RF EME (Radio Frequency Electric
& Magnetic Energy) has the potential to cause slight thermal, or heating effects to any part of your body
less than the recommended distance from this radio transmitter’s antenna. RF energy exposure is
determined primarily by the distance to and the power of the transmitting device. In general, RF exposure
is minimized when the lowest possible power is used or transmission time is kept to the minimum
required for consistent communications, and the greatest distance possible from the antenna to the
body is maintained.  The transceiver has been designed for and is classified for Occupational Use Only.
Occupational/ controlled exposure limits are applicable to situations in which persons are exposed to RF
energy as a consequence of their employment, and such persons have been made aware of the potential
for exposure and can exercise control over their exposure. This means you can use the transceiver only
if you are aware of the potential hazards of operating a transceiver and are familiar in ways to minimize
these hazards. This transceiver is not intended for use by the general public in uncontrolled environments.
Uncontrolled environment exposure limits are applicable to situations in which the general public may be
exposed to RF energy, or in which the persons who are exposed as a consequence of their employment
may not be fully aware of the potential for exposure or cannot exercise control over their exposure.
The following list provides you with the information required to ensure that you are aware of RF exposure
and of how to operate this transceiver so that the FCC RF exposure limitations are not exceeded.
•
While transmitting (holding the PTT switch or speaking with VOX enabled), always keep the
antenna and the radio at least 3 cm (1 3/16 inches) from your body or face, as well as from any
bystanders. A LED on the top of the radio shows red when the transmitter is operating in both
PTT and VOX modes.
•
Do not transmit for more than 50% of the total transceiver use time; transmitting over 50% of the
total use time may exceed the limits in accordance to the FCC RF exposure requirements. Nominal
transceiver operation is 5% transmission time, 5% reception time, and 90% stand-by time.
•
Use only the specified antenna for this transceiver; this may be either the antenna provided with
the transceiver or another antenna authorized by KENWOOD.
Use only KENWOOD authorized accessories (antennas, battery packs, belt clips, Speaker/ Mics or
headsets etc.): When worn on the body, always place the radio in a KENWOOD recommended clip
or carrying case meant for this product. The use of other than recommended or approved body- worn
accessories may result in RF exposure levels which exceed the FCC’s occupational/ controlled
environment RF exposure limits.
To ensure that your exposure to RF EME is within the FCC limits for occupational use, you must
observe and adhere to the above points.
Electromagnetic Interference Compatibility
Electronic devices are susceptible to electromagnetic interference (EMI) if they are not adequately
shielded or designed for electromagnetic compatibility.  Because this transceiver generates RF energy, it
can cause interference to such equipment.
•
Turn OFF your transceiver where signs are posted to do so.  Hospitals and health care facilities use
equipment that is sensitive to electromagnetic radiation.
•
Turn OFF your transceiver while on board an aircraft when so instructed.  Use of the transceiver
must be in accordance with airline regulations and/or crew instructions.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : No
Page Count                      : 1
Producer                        : iTextSharp™ 5.5.8 ©2000-2015 iText Group NV (AGPL-version); modified using iTextSharp™ 5.5.8 ©2000-2015 iText Group NV (AGPL-version)
Create Date                     : 2017:04:07 09:44:41+09:00
Modify Date                     : 2017:04:07 09:44:42+09:00
Title                           : 
Subject                         : 
Creator                         : CubePDF
Author                          : 

EXIF Metadata provided by EXIF.tools