JVC KENWOOD VBA006 Bluetooth audio adaptor for vehicle use. User Manual User Guide Setup
JVC KENWOOD Corporation Bluetooth audio adaptor for vehicle use. User Guide Setup
Contents
- 1. User Guide Setup
- 2. User Guide
User Guide Setup
INSTRUCTIONS / MANUAL DE INSTRUCCIONES / MANUEL D’INSTRUCTIONS / BEDIENUNGSANLEITUNG /
ISTRUZIONI / INSTRUÇÕES
LVT2214-002A
KS-BTA100
EN, SP, FR, GE, IT, PR
© 2010 Victor Company of Japan, Limited
For Customer Use:
Enter below the Model No. and Serial No. which is
located either on the rear or bottom of the speaker
unit. Retain this information for future reference.
Model No.
Serial No.
Using the Bluetooth device
Warning
Stop the car before operating the unit.
Caution
Operations may be different according to the connected device.
Registration of the Bluetooth device
Register (pair) a Bluetooth device
1 [Hold this button for 5 seconds.]
A play/pause button flashes on and off.
2 Search the KS-BTA100 from your device.
3 If a PIN code is required, enter “0000”.
(It is not necessary for some mobile phones.)
When registration is completed, a play/pause button lights up.
Using the Bluetooth mobile phone
Receiving a call
When a call comes in...
Making a call (Redial)
Making a call to the last connected number
from your phone.
Switching between handsfree and phone
While talking...
•
•
•
(Low) (High)
Microphone
Adjusting the microphone volume
Volume level: High/ Normal (initial)/ Low
[Hold]
Ends/rejects call
Voice dialing
Voice dialing is available only when the
connected mobile phone has the voice
recognition system.
•
•
Delete all registered devices
from the list.
•
[Hold the two buttons at the same time for about 10 seconds.]
Using the Bluetooth audio system
[Press] Selects track.
[Hold] Fast-forwards or reverses the track.
[Press] Play/Pause
[Hold] Stop
■
■
■
Fig A/Fig A/Fig AFig B/Fig B/Fig B
To JVC receiver/
To JVC receiver/
To JVC receiver
KS-BTA100
Brown/Brown/Brown
Black/Black/Black
Blue (white stripe)/
Blue (white stripe)/
Blue (white stripe)
Receiver’s Power Cords /
Receiver’s Power Cords /
Receiver’s Power Cords
ENGLISH
Thank you for purchasing a JVC product.
Installation
Warning
Avoid installing the adapter unit in the following places.
Where they would hinder your safety driving.
Where they would be exposed to direct sunlight or heat directly from
the heater or placed in an extremely hot place.
Where they would be subject to rain, water splashes or excessive
humidity.
Where they would be subject to dust.
Where they would be positioned on an unstable place.
Where they could damage the car’s ttings.
Where radio wave interferes (EX.: trunk, etc.)
Mounting the adapter unit
Wipe clean the selected surface sufficiently, and affix the Double-sided
tape. (refer to Fig A)
Connection
(refer to Fig B)
–
–
–
–
–
–
–
■
■
Power cord (Blue,white stripe) /
Power cord (Blue,white stripe) /
Power cord (Blue,white stripe) /
Negative ground /
Negative ground /
Negative ground
Power cord (Brown) /
Power cord (Brown) /
Power cord (Brown) /
ESPAÑOL
Thank you for purchasing a JVC product.
Installation
Warning
Avoid installing the adapter unit in the following places.
Where they would hinder your safety driving.
Where they would be exposed to direct sunlight or heat directly from
the heater or placed in an extremely hot place.
Where they would be subject to rain, water splashes or excessive
humidity.
Where they would be subject to dust.
Where they would be positioned on an unstable place.
Where they could damage the car’s ttings.
Where radio wave interferes (EX.: trunk, etc.)
Mounting the adapter unit
Wipe clean the selected surface sufficiently, and affix the Double-sided
tape. (refer to Fig A)
Connection
(refer to Fig B)
–
–
–
–
–
–
–
■
■
FRANÇAIS
Thank you for purchasing a JVC product.
Installation
Warning
Avoid installing the adapter unit in the following places.
Where they would hinder your safety driving.
Where they would be exposed to direct sunlight or heat directly from
the heater or placed in an extremely hot place.
Where they would be subject to rain, water splashes or excessive
humidity.
Where they would be subject to dust.
Where they would be positioned on an unstable place.
Where they could damage the car’s ttings.
Where radio wave interferes (EX.: trunk, etc.)
Mounting the adapter unit
Wipe clean the selected surface sufficiently, and affix the Double-sided
tape. (refer to Fig A)
Connection
(refer to Fig B)
–
–
–
–
–
–
–
■
■
Fig A/Fig A/Fig AFig B/Fig B/Fig B
To JVC receiver/
To JVC receiver/
To JVC receiver
KS-BTA100
Brown/Brown/Brown
Black/Black/Black
Blue (white stripe)/
Blue (white stripe)/
Blue (white stripe)
Receiver’s Power Cords /
Receiver’s Power Cords /
Receiver’s Power Cords
DEUTSCH
Thank you for purchasing a JVC product.
Installation
Warning
Avoid installing the adapter unit in the following places.
Where they would hinder your safety driving.
Where they would be exposed to direct sunlight or heat directly from
the heater or placed in an extremely hot place.
Where they would be subject to rain, water splashes or excessive
humidity.
Where they would be subject to dust.
Where they would be positioned on an unstable place.
Where they could damage the car’s ttings.
Where radio wave interferes (EX.: trunk, etc.)
Mounting the adapter unit
Wipe clean the selected surface sufficiently, and affix the Double-sided
tape. (refer to Fig A)
Connection
(refer to Fig B)
–
–
–
–
–
–
–
■
■
Power cord (Blue,white stripe) /
Power cord (Blue,white stripe) /
Power cord (Blue,white stripe) /
Negative ground /
Negative ground /
Negative ground
Power cord (Brown) /
Power cord (Brown) /
Power cord (Brown) /
ITALIANO
Thank you for purchasing a JVC product.
Installation
Warning
Avoid installing the adapter unit in the following places.
Where they would hinder your safety driving.
Where they would be exposed to direct sunlight or heat directly from
the heater or placed in an extremely hot place.
Where they would be subject to rain, water splashes or excessive
humidity.
Where they would be subject to dust.
Where they would be positioned on an unstable place.
Where they could damage the car’s ttings.
Where radio wave interferes (EX.: trunk, etc.)
Mounting the adapter unit
Wipe clean the selected surface sufficiently, and affix the Double-sided
tape. (refer to Fig A)
Connection
(refer to Fig B)
–
–
–
–
–
–
–
■
■
PORTUGUÊS
Thank you for purchasing a JVC product.
Installation
Warning
Avoid installing the adapter unit in the following places.
Where they would hinder your safety driving.
Where they would be exposed to direct sunlight or heat directly from
the heater or placed in an extremely hot place.
Where they would be subject to rain, water splashes or excessive
humidity.
Where they would be subject to dust.
Where they would be positioned on an unstable place.
Where they could damage the car’s ttings.
Where radio wave interferes (EX.: trunk, etc.)
Mounting the adapter unit
Wipe clean the selected surface sufficiently, and affix the Double-sided
tape. (refer to Fig A)
Connection
(refer to Fig B)
–
–
–
–
–
–
–
■
■
Using the Bluetooth device
Warning
Stop the car before operating the unit.
Caution
Operations may be different according to the connected device.
Registration of the Bluetooth device
Register (pair) a Bluetooth device
1 [Hold this button for 5 seconds.]
A play/pause button flashes on and off.
2 Search the KS-BTA100 from your device.
3 If a PIN code is required, enter “0000”.
(It is not necessary for some mobile phones.)
When registration is completed, a play/pause button lights up.
Using the Bluetooth mobile phone
Receiving a call
When a call comes in...
Making a call (Redial)
Making a call to the last connected number
from your phone.
Switching between handsfree and phone
While talking...
•
•
•
(Low) (High)
Microphone
Adjusting the microphone volume
Volume level: High/ Normal (initial)/ Low
[Hold]
Ends/rejects call
Voice dialing
Voice dialing is available only when the
connected mobile phone has the voice
recognition system.
•
•
Delete all registered devices
from the list.
•
[Hold the two buttons at the same time for about 10 seconds.]
Using the Bluetooth audio system
[Press] Selects track.
[Hold] Fast-forwards or reverses the track.
[Press] Play/Pause
[Hold] Stop
■
■
■
Using the Bluetooth device
Warning
Stop the car before operating the unit.
Caution
Operations may be different according to the connected device.
Registration of the Bluetooth device
Register (pair) a Bluetooth device
1 [Hold this button for 5 seconds.]
A play/pause button flashes on and off.
2 Search the KS-BTA100 from your device.
3 If a PIN code is required, enter “0000”.
(It is not necessary for some mobile phones.)
When registration is completed, a play/pause button lights up.
Using the Bluetooth mobile phone
Receiving a call
When a call comes in...
Making a call (Redial)
Making a call to the last connected number
from your phone.
Switching between handsfree and phone
While talking...
•
•
•
(Low) (High)
Microphone
Adjusting the microphone volume
Volume level: High/ Normal (initial)/ Low
[Hold]
Ends/rejects call
Voice dialing
Voice dialing is available only when the
connected mobile phone has the voice
recognition system.
•
•
Delete all registered devices
from the list.
•
[Hold the two buttons at the same time for about 10 seconds.]
Using the Bluetooth audio system
[Press] Selects track.
[Hold] Fast-forwards or reverses the track.
[Press] Play/Pause
[Hold] Stop
■
■
■
Using the Bluetooth device
Warning
Stop the car before operating the unit.
Caution
Operations may be different according to the connected device.
Registration of the Bluetooth device
Register (pair) a Bluetooth device
1 [Hold this button for 5 seconds.]
A play/pause button flashes on and off.
2 Search the KS-BTA100 from your device.
3 If a PIN code is required, enter “0000”.
(It is not necessary for some mobile phones.)
When registration is completed, a play/pause button lights up.
Using the Bluetooth mobile phone
Receiving a call
When a call comes in...
Making a call (Redial)
Making a call to the last connected number
from your phone.
Switching between handsfree and phone
While talking...
•
•
•
(Low) (High)
Microphone
Adjusting the microphone volume
Volume level: High/ Normal (initial)/ Low
[Hold]
Ends/rejects call
Voice dialing
Voice dialing is available only when the
connected mobile phone has the voice
recognition system.
•
•
Delete all registered devices
from the list.
•
[Hold the two buttons at the same time for about 10 seconds.]
Using the Bluetooth audio system
[Press] Selects track.
[Hold] Fast-forwards or reverses the track.
[Press] Play/Pause
[Hold] Stop
■
■
■
Using the Bluetooth device
Warning
Stop the car before operating the unit.
Caution
Operations may be different according to the connected device.
Registration of the Bluetooth device
Register (pair) a Bluetooth device
1 [Hold this button for 5 seconds.]
A play/pause button flashes on and off.
2 Search the KS-BTA100 from your device.
3 If a PIN code is required, enter “0000”.
(It is not necessary for some mobile phones.)
When registration is completed, a play/pause button lights up.
Using the Bluetooth mobile phone
Receiving a call
When a call comes in...
Making a call (Redial)
Making a call to the last connected number
from your phone.
Switching between handsfree and phone
While talking...
•
•
•
(Low) (High)
Microphone
Adjusting the microphone volume
Volume level: High/ Normal (initial)/ Low
[Hold]
Ends/rejects call
Voice dialing
Voice dialing is available only when the
connected mobile phone has the voice
recognition system.
•
•
Delete all registered devices
from the list.
•
[Hold the two buttons at the same time for about 10 seconds.]
Using the Bluetooth audio system
[Press] Selects track.
[Hold] Fast-forwards or reverses the track.
[Press] Play/Pause
[Hold] Stop
■
■
■
Using the Bluetooth device
Warning
Stop the car before operating the unit.
Caution
Operations may be different according to the connected device.
Registration of the Bluetooth device
Register (pair) a Bluetooth device
1 [Hold this button for 5 seconds.]
A play/pause button flashes on and off.
2 Search the KS-BTA100 from your device.
3 If a PIN code is required, enter “0000”.
(It is not necessary for some mobile phones.)
When registration is completed, a play/pause button lights up.
Using the Bluetooth mobile phone
Receiving a call
When a call comes in...
Making a call (Redial)
Making a call to the last connected number
from your phone.
Switching between handsfree and phone
While talking...
•
•
•
(Low) (High)
Microphone
Adjusting the microphone volume
Volume level: High/ Normal (initial)/ Low
[Hold]
Ends/rejects call
Voice dialing
Voice dialing is available only when the
connected mobile phone has the voice
recognition system.
•
•
Delete all registered devices
from the list.
•
[Hold the two buttons at the same time for about 10 seconds.]
Using the Bluetooth audio system
[Press] Selects track.
[Hold] Fast-forwards or reverses the track.
[Press] Play/Pause
[Hold] Stop
■
■
■