JVCKENWOOD 452501 UHF DIGITAL BASE-REPEATER User Manual

JVC KENWOOD Corporation UHF DIGITAL BASE-REPEATER TKR D710 TKR D810 K

a href="https://usermanual.wiki/JVCKENWOOD" itemprop="url"> JVCKENWOOD >

Users Manual

B5A-1121-00 (K)TKR-D710VHF DIGITAL REPEATERUHF DIGITAL REPEATERINSTRUCTION MANUALTKR-D810
1◆ Do not install the repeater in explosive atmospheres (infl ammable gas, dust particles, metallic powders, grain powders, etc.).◆ This repeater is intended for use as a fi xed base station with the antenna located outdoors on the rooftop or on an antenna tower.◆ This repeater is designed for a 13.6 V DC power source! Never use a 24 V DC or higher source to power the repeater. ◆ Use only the supplied DC cord.◆ Do not remove the ferrite core attached to the DC cord. Doing so may cause interference with radio communications.THANK YOU!We are grateful you purchased this KENWOOD repeater. We believe this easy-to-program repeater will be highly eff ective in your communications system, and will keep personnel operating at peak effi ciency.PRECAUTIONS• Do not expose the unit to rain or moisture; to prevent fi re or electric shock.• Do not open the unit under any circumstances; to avoid risk of electric shock.• Do not expose the unit to long periods of direct sunlight, nor place it close to heating appliances.• Do not place the unit in excessively dusty and/or humid areas, nor on unstable surfaces.• Do not put the plastic bag used for packing of this equipment on the place which reaches a small child's hand. It will become a cause of suffocation if it wears fl atly.• Always switch the transceiver power off before installing optional accessories.• If you detect an abnormal odor or smoke coming from the unit, disconnect the power from the unit immediately. Contact your KENWOOD service center or dealer.NOTICES TO THE USERUNPACKING AND CHECKING EQUIPMENTNote: The following unpacking information is for use by your KENWOOD dealer, an authorized KENWOOD service center, or the factory.Carefully unpack the repeater. We recommend that you identify the items listed in the following table before discarding the packing material. If any items are missing or have been damaged during shipment, fi le a claim with the carrier immediately.Item Part Number QuantityHardware fi xture J21-8559-XX 1Front glass B10-2635-XX 1Name plates B11-1259-XX 1Cushion G13-1801-XX 4Cushion G13-1802-XX 4Foot J02-0475-XX 2Foot J02-0492-XX 2Grommet J59-0302-XX 2Handle K01-0418-XX 1Screws N30-4006-XX 2Screws N35-3006-XX 5DC cord E30-3427-XX 1Lead wire with connector (15 pin) E31-3228-XX 1Fuse F05-1537-XX 1Instruction Manual B5A-1121-XX 1INSTALLATIONTo install the handles onto the front panel of the repeater, align the handles with the holes on the front panel, then secure the handles using the supplied screws.Please consult your dealer for installing the repeater and antenna.VHF DIGITAL REPEATER/ UHF DIGITAL REPEATERINSTRUCTION MANUALTKR-D710/ TKR-D810◆ Government law prohibits the operation of unlicensed radio transmitters within the territories under government control.◆ Illegal operation is punishable by fi ne and/or imprisonment.◆ Refer service to qualifi ed technicians only.One or more of the following statements may be applicable:FCC WARNINGThis equipment generates or uses radio frequency energy. Changes or modifi cations to this equipment may cause harmful interference unless the modifi cations are expressly approved by the party responsible/JVC KENWOOD. The user could lose the authority to operate this equipment if an unauthorized change or modifi cation is made.INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCCThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can generate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer for technical assistance.Firmware CopyrightsThe title to and ownership of copyrights for fi rmware embedded in KENWOOD product memories are reserved for JVC KENWOOD Corporation.The AMBE+2TM voice coding Technology embodied in this product is protected by intellectual property rights including patent rights, copyrights and trade secrets of Digital Voice Systems, Inc. This voice coding Technology is licensed solely for use within this Communications Equipment. The user of this Technology is explicitly prohibited from attempting to extract, remove, decompile, reverse engineer, or disassemble the Object Code, or in any other way convert the Object Code into a human-readable form. U.S. Patent Nos. #6,199,037, #6,912,495, #8,200,497, #7,970,606, and #8,359,197.
Download:
Mirror Download [FCC.gov]
Document ID2819192
Application IDS0MMLPd2eK9PPaQaWci8Ag==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize18.07kB (225827 bits)
Date Submitted2015-11-23 00:00:00
Date Available2015-11-23 00:00:00
Creation Date2015-10-15 10:44:08
Document Lastmod2015-11-05 12:00:55
Document TitleTKR-D710,TKR-D810 (K)
Document CreatorAdobe InDesign CS5.5_J (7.5.3)
Document Author: JVC KENWOOD Corporation
FCC ID Filing: K44452501

Navigation menu