Jada Toys JT49TX91000 9” Chub City RC and 4.5” Chub City RC. User Manual 83047 IS US01 Front

Jada Toys Company Limited 9” Chub City RC and 4.5” Chub City RC. 83047 IS US01 Front

Contents

user man pt 1

TROUBLE SHOOTING
PROBLEM SOLUTION
Car will not START
Car does not respond
to controls.
Car does not drive straight.
1. Power switch is off. Turn on. 2. Batteries are installed with
incorrect polarities. Check the + and - markings to make sure the
batteries are properly aligned. 3. Batteries are drained. Charge
batteries and/or install new batteries.
1. Transmitter controller battery is drained. Replace the 9V
controller battery. 2. Vehicle is out of range. Bring controller
closer to the vehicle. 3. Interference from surrounding electrical
machinary. Bring to a wide open space.
1. Adjust the steering dial underneath the front axle, left or right,
until the wheels point straight forward.
COMPLIANCE WITH FCC REGULATIONS (VALID IN U.S.
ONLY) THIS DEVICE COMPLIES WITH PART 15 FCC
RULES. OPERATION OF THIS DEVICE IS SUBJECT TO
THE FOLLOWING TWO CONDITIONS:
1. THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE.
2. THIS DEVICE MUST ACCEPT ANY HARMFUL
INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
This device generates and uses radio frequency energy
and if not used properly may cause interference to radio
and television reception. It has been tested and found to
comply with the limits set by the FCC which are designed to
provide reasonable protection against such interference.
FCC Warning:
CAUTION:
The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this
equipment. Changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and
receiver.
--Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician
for help.

Navigation menu