Jada Toys JY27TX84000 RC Car Transmitter 27 MHz User Manual 1
Jada Toys Company Limited RC Car Transmitter 27 MHz Users Manual 1
Contents
- 1. Users Manual 1
- 2. Users Manual 2
Users Manual 1
![](/img.php?id=550378&img=bg1.png)
Keep these instructions for future reference: they contain
important information.
IMPORTANT: Please read all “Consumer
Information” before operating your vehicle.
CAUTION:
ELECTRICALLY OPERATED PRODUCT
Not recommended for children under 8 years of age. As
with all electric products, precautions should be observed
during handling and use to prevent electric shock.
ADULT SUPERVISION REQUIRED.
Surfaces may become hot and cause burns if electronics
get wet. Do not operate vehicle through water or snow.
Consumer Information:
Note to Adults: to ensure that the child’s play is both
safe and fun, please review all operating instructions and
safety rules with your child.
CONTENTS
Vehicle
Transmitter Controller
Antenna for Transmitter Controller
9.6V Ni-Cd Battery Pack
Charger for 9.6V Ni-Cd Battery Pack (120V AC 60Hz)
Safety Tips
• NEVER drive your vehicle on streets! They’re for real
cars!
• DO NOT pick up vehicle while in motion.
• Avoid collisions with wall or hard surfaces.
• Keep fingers, hair and loose clothing away from tires
and the wheel hubs while the vehicle is switched ON.
• Adult supervision is recommended when this vehicle is
being operated.
• To avoid accidental operation, remove all batteries when
not in use.
• Battery charger used with the toy to be regularly
examined for damage to cord plug enclosure and
other parts: and in the event of such damage. Toy
must not be used with the battery charger until such
damage has been repaired.
• For transformer toys and toys with battery boxes: toy
is not to be connected to more than recommended
number of power supplies.
• Recommended rechargeable battery 9.6V 700mAH
Ni-Cd.
• Be sure to rest your vehicle for at least 5 minutes
after every 15 minutes of operation.
BEFORE BATTERY INSTALLATION
Your new R/C is designed to work with standard R/C
9.6-volt Ni-Cd batteries and charger.
Controller is designed to work with a 9-volt alkaline battery.
For detailed information regarding Ni-Cd battery charging
and safety, please follow the specific instructions that came
with your battery pack and charger.
BATTERY CHARGING:
(When using 9.6V Ni-Cd Battery Pack)
**RECHARGEABLE BATTERIES ARE TO BE CHARGED
BY ADULT ONLY**
(The rechargeable Ni-Cd battery pack is not charged,
please charge battery for 4 (four) hours prior to use)
1. Plug the wall pack battery charger into wall outlet.
2. Connect the cables leading from the Battery Pack
and the charger together by snapping the jack and
the socket tightly. (See diagram 1)
3. To disconnect cables, press down on the clip and
pull apart. (See diagram 1)
4. After charging for 4 (four) hours, the battery will be
warm. This condition is normal for fully charged
batteries. DO NOT overcharge the battery.
5. After use, the battery pack will be hot!!! Wait at
least 20 minutes until the battery cools before
recharging. Recharging a warm or hot battery pack
will greatly shorten the use life of the battery.
INSTALLING BATTERIES IN THE R/C
9.6V Ni-Cd
1. Push the ON/OFF to “OFF” position on vehicle.
2. To install the 9.6V Ni-Cd battery, use a Phillips
screwdriver (not included), to remove the battery
compartment door underneath the vehicle.
(See diagram 2)
3. Remove the battery compartment door.
4. Plug the battery pack into the cable by snapping the
jack and socket lightly.
5. Replace the battery compartment door and use
Phillips screwdriver to lock the compartment door.
INSTALLING CONTROLLER –
9 VOLT BATTERY
1. Open the battery cover as shown (See Diagram 3)
2. Install one 9V battery with polarity (+/-) as shown
inside battery compartment.
3. Replace battery cover.
Battery Safety Information
• Insure that battery polarity is correct.
• Use only batteries of the type recommended
(or equivalent).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
• Remove used-up batteries immediately. Remove
batteries if vehicle will not be used for a long period of
time to prevent possible leakage.
• Do not recharge non-rechargeable batteries.
• Do not short-circuit terminals.
• Remove rechargeable batteries before recharging.
• Rechargeable battery must be charged by adult only.
• Dispose of batteries safely. Do not dispose of batteries
(or products containing non-replaceable batteries) in
fire, as batteries may explode or leak.
• Do not disassemble the battery pack.
• Do Not overcharge the battery. Use only the charger
provided. Do Not use other chargers to charge battery.
Like any other rechargeable battery, explosion may
occur, if improperly charged.
©2005 Jada Toys, Inc.
City of Industry, CA 91748 USA
DUB CITY® and R/C ROLLER$™
are trademarks of Jada Toys, Inc.
All Rights Reserved.
83002-IS-US04
Operations Tips:
Locate the transmitter antenna mount
on the top of the transmitter. Insert the
antenna into the mount opening and
rotate in a clockwise direction until snug.
Car: ON / OFF switch located on the
bottom of the car.
Transmitter: ON / OFF switch located on
the front of the transmitter.
When you ready to run, please make sure
push the ON / OFF switches to “ON” position
on both. Go to get fun.
To replace battery pack
remove screw on battery
cover as shown in
illustration and replace
battery pack
Steering Dial
Press here
when opening Press here
when opening
FRONT
REAR
Battery
Charger
9.6V Ni-Cd
battery pack
9.6V Ni-Cd
battery pack
9.6V Ni-Cd
battery pack
Insert 9 volt
battery into
transmitter
Power on
LED Light Up
TRANSMITTER CONTROLLER
BOTTOM OF
TRANSMITTER CONTROLLER
Left / Right
Screw On
On / Off
Stop
Go
Forward
Reverse
TO ADJUST STEERING ALIGNMENT
Adjust the steering alignment lever on
the underside of the vehicle when the
vehicle doesn’t run straight forward.
steering alignment lever