LG Electronics USA LTTG94 GSM/WCDMA Telematics NAD module User Manual Installation Guide

LG Electronics USA GSM/WCDMA Telematics NAD module Users Manual Installation Guide

Contents

Users Manual - Installation Guide

LG Electronics Inc. 1 13-12-16 1/121. Installation Guide for GEN9.4NADCANADA This part establishes the installation guide for GEN9.4NADCANADA. Description of installation is shown as below:  1. Number ① : Top cover 2. Number ② : TCU (Telematics Control Unit) : Power board 3. Number ③ : GEN9.4NADCANADA module 4. Number ④ : TCU main connector bracket. 5. Number ⑤ : Bottom cover 6. Number ⑥ : B to B connector
2/12LG Electronics Inc. 2 13-12-16 [Fig.1] VCP [module(NAD) + Power board(TCU)] setting information [Fig.2] VCP [module(NAD) + Power board(TCU) + Housing] setting information (Full Assembly)  <Front View> <Rear View >
3/12LG Electronics Inc. 2 13-12-16 <FCC Regulatory Notices> 1. GEN9.4NADCANADA module has been granted as limited modular approval that is limited to that the specific host only (Telematics device). The host manufacturer is LG Electronics USA; Host FCC ID: BEJLTTG94L. 2. GEN9.4NADCANADA module has no its power supply and it must be connected with this host while working; and the TCU part in this host support the power. 3. A label must be affixed to the outside of the end product into which the GEN9.4NADCANADA module is incorporated, with a statement similar to the following: “This device contains FCC ID: BEJLTTG94.” 4. The transmitter module must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures. 5. The end product with an embedded GEN9.4NADCANADA module may also need to pass the FCC Part 15 unintentional emission testing requirements and be properly authorized per FCC Part 15. 6. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 7. Changes or modifications made to this equipment not expressly approved by LG Electronics USA may void the FCC authorization to operate this equipment. 8. This is device is a mobile device with respect to RF exposure compliance. The antenna used for this transmitter must be installed to provide a separation distance of at least 30 cm from all persons. Final Installers (automobile manufacturer) must be provided with specific information required to satisfy RF exposure compliance for installations and final host devices. Compliance of this device in all final host configurations is the responsibility of the Grantee. The highest permitted antenna gains including cable loss for use with this device are: GSM850/ WCDMA850: -2.4 dBi, GSM1900/WCDMA1900: -0.3 dBi. 9. The cable length that must be used in the final installation is at least 1.5 m. - RF cable loss is proportional to the line length increases. - RF cable type : straight FAKRA plug type RF cable.
4/12LG Electronics Inc. 2 13-12-16  1) Low Band RF cable loss (850Mhz) - GSM850/ WCDMA B5 (824 MHz ~ 894 MHz) Band GSM850/ WCDMA B5 Frequency (MHz) 824 836 849 869 881 894 1.5m I.L (dB) -1.8484 -1.8688 -1.8947 -1.9125 -1.9293 -1.9402 3m I.L (dB) -3.6968 -3.7376 -3.7894 -3.825 -3.8586 -3.8804 4.5m I.L (dB) -5.5452 -5.6064 -5.6841 -5.7375 -5.7879 -5.8206 6m I.L (dB) -7.3936 -7.4752 -7.5788 -7.65 -7.7172 -7.7608 FAKRA Type RF cable Antenna GEN9.4NADNA
5/12LG Electronics Inc. 2 13-12-16 2) High Band RF cable loss - GSM1900/ WCDMA B2 (1850MHz ~ 1990MHz) Band GSM1900/WCDMA B2 Frequency (MHz) 1850 1910 1930 1990 1.5m I.L (dB) -2.8762 -2.9696 -2.9474 -3.0094 3m I.L (dB) -5.7524 -5.9392 -5.8948 -6.0188 4.5m I.L (dB) -8.6286 -8.9088 -8.8422 -9.0282 6m I.L (dB) -11.5048 -11.8784 -11.7896 -12.0376 * Note I.L : insertion loss is the loss of signal power resulting from the insertion of a device in a transmission line or optical fiber and is usually expressed in decibels(dB).

Navigation menu