LINKSYS WET610N Wireless-N Ethernet Bridge with Dual-Band User Manual

LINKSYS LLC Wireless-N Ethernet Bridge with Dual-Band Manual

a href="https://usermanual.wiki/LINKSYS" itemprop="url"> LINKSYS >

Manual

   Model:QUICK INSTALLATION GUIDEWireless-N Ethernet Bridgewith Dual-BandWET610N
 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part  15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in  a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not  installed and used in accordance with the instructions, may cause harmful interference to radio communications.   However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does  cause harmful interference to radio or television reception, which can be determined by turning the equipment off  and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could  void the user's authority to operate this equipment. For operation within 5.15 ~ 5.25GHz frequency range, it is restricted to indoor environment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This  device may not cause harmful interference, and (2) this device must accept any interference received, including  interference that may cause undesired operation.  IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This  equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The availability of some specific channels and/or operational frequency bands are country dependent and are  firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by  the end user. WET610N with Printed antenna and max. antenna gain is 1.58dBi in 2.4G.  Industry Canada statement This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two  conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference  received, including interference that may cause undesired operation.   IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This  equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Caution:The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel mobile satellite systems. High power radars are allocated as primary users (meaning they have priority) of 5250-5350 MHz and 5650-5850 MHz and these radars could cause interference and/or damage to LE-LAN devices.Note: The WET610N has disable the 5600-5650M band by S/W to avoid 5600-5650M band for IC certification. WET610N with Printed antenna and max. antenna gain is 1.58dBi in2.4G and 1.45dBi in 5G.
Download:
Mirror Download [FCC.gov]
Document ID1013074
Application ID0/+6hpSFvM7+VV3hZkbi4g==
Document DescriptionManual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize197.84kB (2472944 bits)
Date Submitted2008-10-09 00:00:00
Date Available2008-10-09 00:00:00
Creation Date2007-11-20 12:38:40
Producing SoftwareAdobe PDF Library 7.0
Document Lastmod2008-10-01 13:18:25
Document TitleManual
Document CreatorAdobe InDesign CS2 (4.0.5)
FCC ID Filing: Q87-WET610N

Navigation menu