Megavision MV176 LCD MONITOR & TV User Manual USERS MANUAL 1

Megavision co., Ltd. LCD MONITOR & TV USERS MANUAL 1

USERS MANUAL 1

Download: Megavision MV176 LCD MONITOR & TV User Manual USERS MANUAL 1
Mirror Download [FCC.gov]Megavision MV176 LCD MONITOR & TV User Manual USERS MANUAL 1
Document ID380337
Application IDPVt0gzCjiQ1ilB9v1salQQ==
Document DescriptionUSERS MANUAL 1
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize116.2kB (1452545 bits)
Date Submitted2003-12-10 00:00:00
Date Available2003-12-10 00:00:00
Creation Date2003-12-10 10:22:09
Document Lastmod2003-12-10 10:22:45
Document TitleUSERS MANUAL 1
Document CreatorQuite Imposing 1.2kg (Çѱ¹¾î) beta 6

17" TFT LCD MONITOR/ T v
USER'S MANUAL
TABLE OF CONTENTS
INTRODUCTION
FCC Compttonce Statement
Equtpment Check Itst
Safety Informotton
Features
MONITOR OVERVIEW
Control Buttons
Cobte Connection
SELECTING AND ADJUSTING THE OSD MENU
MONITOR/ TV OSD MENU FUNCTION
TV OSD MENU
V—CHIP OSD MENU
OPERATION MESSAGE
REMOTE CONTROL OVERVIEW
TROUBLE SHOOTING
SPECIFICATIONS
ohm»
TO
IT
13
15
IE
I9
20
22
(tl
FCC COMPLIANCE STATEMENT
* Note :
This equipment has been tested and found to comply with the limits for a Class 5
digital deitice, pursuant to Part 15 of FCC Rules These limits are designed to
prmtide reasonable protection against radio frequency interference in a residential
installation This equipment generates, uses and can radiate radio frequency energy
I] not installed and used in accordance with the instructions, it may cause
interference to radio communications However, there is no guarantee that
interference will not occur in a particular installation If this equipmentdoes cause
interference to radio or television reception(this can be determined by turning this
equipment all and an), the user is encouraged to try to correct the interference by
fine or more nfthc following measure-s-
- Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver
- Connect the equipment to an outlet on a circuit differentfrorn that to which the
receiver is connected
CAUTION:
To comply wl'lht'n the limits [by an FCC Class a computing device, always use the
shielded signal eerdsupplieit with this unit
CAUTION TO THE USER:
The Federal Communications Commission warns that changes or modifications to
the unit not expressly approved by the party responsible/or compliance could void
the user's authority to operate the equipment. Il’necessary, the user should contact
the dealer or an experienced radio/television technician/or additional suggestions.
The user may find the Federal Communications Commission booklet,
How to Identify and Resolve Radio—TVMler/erence Problems, helpful.
This booklet is available from the as, Government Printing Office, Washington,
17.0. Slack No.004—000—00345—4
NOTICE OF COMPLIANCE WITH CANADIAN INTERFERENCE-
CAUSING EQUIPMEN REGULATIONS
DDC COMPLIANCE NOTICE:
Thu" digital epparaats does not exceed the Class B limits for radio noise L‘mimlunx
fiom digital tzppamllu set out in the Radio lnte erence Regulationv of the
Canadian Department of Communications.
(2
EQUIPMENT CHECK LIST
Um ; mu; EEI
Manual MONITOR DISKETTE
Dc Adapter Power Cord VGA Signal Cable
“in“
Remote Control AV Inlerface Cable Audlo Cable Speaker Cable
(1
SAFETY INFORMATION
' - Don't plug the power adapter into a
nonfgrounding power outlet.
' Only use the adaoter provided with the monitor.
An electric shock or tire accrdent may occur.
' Keep the power cord from Droximity to a
V . .
L < heatmg |h strument
. ‘ \
m 7 *. The covering material at the cord may melt. causing
- a tire or electric shock.
' Pull the DOWGV cord DUI when the mOHIIOV IS not
i . ' \ used for a long time, or while you are away
V A dust covering may cause on electric shock electric leakage,
\, or tire by heat generation, ignition, and insulation degradation.
“l “ - Select a cool. dry area and protect your monitor trorn
(A i G extremes in temperature. humidny, dust and smoke.
w ,_A‘i
If Accidents ot electric shock fire or failure may occur.
' Avoid direct sunlight or any other source of
heat such as a fireplace.
A fire or electric shock accident may be caused.
' Don‘t spill liquids such as chemicals, water on
the monitor.
A fire or electric shock accident may be caused.
(4
SAFETY INFORMATION
' Never disassemble and reoair the monitor but
trained repair engineers.
A fire or electric shock ocmoenl may be caused. it you need
the repair and odiustment, please Contact the cppiopriote
soles agency Oi customer counsel Window for check-ups
- Don't spray any liquids directly onto the monitor.
An electric shock or we accident may occur.
Y) ' Clean the LCD Danel with a solt material such
as cotton cloth after removing the power cord
from the monitor.
A fire or electiic shock accident may be caused
' Place the monitor On a stable and secure surface.
Foil oi displacement of the monitor may cause on iniuiy.
nu. Be caretul With the shock when moving the monitor
' Don‘t press upon the panel or scratch the surface
“fi' J With your hands or sharp item such as a hail, pens.
K‘— Damoge or failure of the panel may be coused
53 l a 4x. ' The fluorescent light of the monitor contains a mercury
J QB which could be exploded. Don't discard or bury the
. it
~ ' monitor Without permissmn ot the law concerned.
(it

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Modify Date                     : 2003:12:10 10:22:45+09:00
Create Date                     : 2003:12:10 10:22:09+09:00
Creator                         : Quite Imposing 1.2kg (Çѱ¹¾î) beta 6
Page Count                      : 6
EXIF Metadata provided by EXIF.tools
FCC ID Filing: QJSMV176

Navigation menu