Netgear orporated 17200387 FlexPower ONVIF Wire-Free IP Camera User Manual

Netgear Incorporated FlexPower ONVIF Wire-Free IP Camera rev

a href="https://usermanual.wiki/Netgear-orporated" itemprop="url"> Netgear orporated >

User Manual_rev.pdf

Quick StartWire-Free IP Camera (ONVIF-Compliant)Model VNC4030-111PASStep 2: Sync Your Camera With the Base StationYou must install the base station before you can sync the cameras.1.  Bring the camera within 2 to 4 feet (60 to 120 cm) of the base station.2.  Press the Sync button on the top of the base station for about two seconds and release the button.The base station Sync LED blinks blue.3.  Press the Sync button on top of the camera for about two seconds and release the button.The camera LED blinks blue. When the camera is synced to the base station, the camera LED blinks rapidly to confirm sync. Note:  The camera LED blinks amber if the sync is not successful. You must repeat the sync process.Step 1: Insert the Battery1.  Unlock the battery compartment by pressing and holding the latch.2.  Gently pull the battery door back to open the compartment.3.  Align the battery contacts.4.  Insert the battery.5.  Close the battery door.Camera LED GuideCamera State LED BehaviorGeneral Blinks blue once. The camera was powered on.Blinking blue and amber. A firmware update is in progress. Do not turn o the camera.O. The camera is either powered o or is powered on and is synced to a base station.Syncing Slow blinking blue. The camera is attempting to sync to a base station.Fast blinking blue. The camera is syncing with a base station.Fast blinking amber. The camera did not sync.Charging Fast blinking blue. The camera is connected to power and is charging.Solid blue. The camera is powered on and the battery is fully charged.Slow blinking amber. The camera battery charge is low.Fast blinking amber. The power connection failed.Package ContentsMagnetic wall mountWire-Free IP camera Power cable Power adapterOutdoor mountQuick install guide (this document)Mounting screws (4)Rechargeable batteryDRAFTFlexPower ONVIF  Wire-Free IP Camera
12Set Up Your System Place or Mount Your CamerasYou can place your camera on a shelf or other flat surface, or you can mount it to the wall.Note:  Use the Arlo app in Position mode to help aim the camera. See Position Mode on page 15. ¾To mount your camera to the wall:1.  Fasten the mounting screw into the wall,  and hang the magnetic mount from the screw.  2.  If you’re mounting the camera to drywall, be sure to use the plastic drywall anchors that are provided.Note:  You can also use double-sided tape instead  of screws.
Download:
Mirror Download [FCC.gov]
Document ID3535158
Application IDqrMFndPHpeGPNZsn84mIQQ==
Document DescriptionUser Manual_rev.pdf
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize204.89kB (2561100 bits)
Date Submitted2017-08-30 00:00:00
Date Available2018-02-26 00:00:00
Creation Date2017-08-18 19:07:23
Producing SoftwareiTextSharp 5.0.4 (c) 1T3XT BVBA
Document Lastmod2017-08-24 21:58:14
Document TitleUser Manual_rev.pdf
FCC ID Filing: PY317200387

Navigation menu