Ohsung Electronics URCRFX-250I RF Receiver User Manual H User s Manual

Ohsung Electronics Co., Ltd. RF Receiver H User s Manual

Contents

user manual

Order Number : GETEC-C1-10-149 FCC Certification Test Report Number : GETEC-E3-10-082 Page 1 / 1 EUT Type: RF Receiver FCC ID.: OZ5URCRFX-250I APPENDIX H : USER’S MANUAL
RFX-250i Installation ManualOptimizing Narrow Band Receptionwith the MRF-350i
Page 1RFX-250i INSTALLATION MANUALOverview - CompatibilityThe RFX-250i is a 433MHz RF receiver. It connects to an MRF-350,MRF-350i, MSC-400 or an MSC-400i. It is not compatible with allURC remote controls. It is only compatible with “I” series remotecontrols, which transmit at 433MHz.ConnectionsWhen the RFX-250i can be placed within 10 feetof the MRF/MSC unit, you can utilize the cablewith 3.5 mm plugs on both ends. When youneed a longer wire or are connecting up tothree RFX-250i’s, use a cable with a minimum ofthree conductors. If you use CAT 5, utilize twoconductors each from two of the twisted pairsfor DATA and two from the other twisted pairsfor 5V. Use all four of the other conductorstwisted in with each pair for GND.This providesbetter shielding and conductivity for long runs.Connect ONE (only) of either of the RFX-250i’s RF OUT connec-tors to ONE (only) ofeither of the RF INconnectors on the MRF or the MSC.Once the RFX-250i is correctly connect-ed, the POWER LED lights.If the RF LED lights, the RFX-250i mustbe moved to a new mounting location. Itis receiving in-band RF INTERFERENCE.
Page 2RFX-250i INSTALLATION MANUALOptimizing Range and Reliability1. Power on all AV components, dim all dimmers to 50% and power onanything that may create RF (particularly devices with high speedmicroprocessors or hard drives). Observe the RF LED of the RFX-250i bycupping your hand over it. If it is glowing or flickering you must relo-cate the RFX-250i. If you cannot relocate the RFX-250i,try removing its antenna.2. Once you have found a location that is absolutely cleanwith everything on, test to see if the range is adequateand that macro reliability is perfect. Start with theantenna angle set to 45 degrees and positioned so thatthe long side of the antenna is facing the customer’sfavorite seating position.3. When testing, set both the remote and the MRF/MSC to the sameVALID RFID#. Keep in mind that zero (0) is not a valid RFID#. Watchthe STATUS LED on MRF/MSC - it should light every time you press abutton on the remote. This will tell you that the signal was receivedand understood. Ignore the RF LED on the RFX-250i (it only indicatesthat a signal was received, not that it was understood).4. If the range is inadequate, you may extend wire to any area that is notgiving good results and place an additional RFX-250i in that area. Up tothree RFX-250i’s can be connected to each MRF/MSC.NOTE: The RFX-250i is ONLY compatible with additional RFX-250is. Youcannot mix RFX-150i in a system with RFX-250is.Suggested antennaangle.
Page 3RFX-250i INSTALLATION MANUALUSALimited Warranty StatementYour Universal Remote Control, when delivered to you in new condition,is warrantedagainst defects in materials or workmanship as follows: UNI-VERSALREMOTE CONTROL,INC. warrants this product against defects inmaterial or workmanship for a period of one(1) year and as set forthbelow. Universal Remote Control will, at its sole option, repair theproductusing new or comparable rebuilt parts, or exchange the product for acomparablenew or rebuilt product. In the event of a defect, these are yourexclusive remedies.This Limited Warranty covers only the hardware components packagedwith the Product. Itdoes not cover technical assistance for hardware orsoftware usage and it does not coverany software products whether or notcontained in the Product; any such software is pro-vided "AS IS" unlessexpressly provided for in any enclosed software Limited Warranty. To obtain warranty service, you must deliver the product, freight prepaid,in its originalpackaging or packaging affording adequate protection toUniversal Remote Control at theaddress provided in the Owner's Manual.It is your responsibility to backup any macroprogramming, artwork, soft-ware or other materials that may have been programmed intoyour unit. Itis likely that such data, software, or other materials will be lost during ser-viceand Universal Remote Control will not be responsible for any suchdamage or loss. Adated purchase receipt, Bill of Sale, Installation Contractor other verifiable Proof ofPurchase is required. For product support andother important information visit UniversalRemote Control's website:http://www.UniversalRemoteControl.com or call the UniversalRemoteControl Customer Service Center (914) 835-4484.This Limited Warranty only covers product issues caused by defects inmaterial or work-manship during ordinary consumer use. It does notcover product issues caused by anyother reason, including but not limitedto product issues due to commercial use, acts ofGod, third-party installa-tion, misuse, limitations of technology, or modification of or to anypart ofthe Universal Remote Control product. This Limited Warranty does notcoverUniversal Remote Control products sold as USED, AS IS, REFUR-BISHED, so-called "BSTOCK" or consumables (such as batteries). ThisLimited Warranty is invalid if the factory-applied serial number has beenaltered or removed from the product. This LimitedWarranty is valid onlyin the United States of America. This Limited Warranty specificallyex-cludes products sold by unauthorized resellers.
Page 4RFX-250i INSTALLATION MANUALUNIVERSALREMOTE CONTROLSHALLNOT BE LIABLE FOR ANYINCI-DENTALORCONSEQUENTIALDAMAGES FOR BREACH OF ANYEX-PRESS OR IMPLIED WARRANTYOR CONDITION ON THIS PRODUCT.EXCEPT TO THE EXTENT PROHIBITED BYAPPLICABLE LAW, THERE ISNO OTHER WARRANTYEXPRESSED OR IMPLIED. UNIVER-SALREMOTECONTROLWILLNOT BE HELD RESPONSIBLE FOR STATEMENTS MADE-BYOTHERS CONCERNING THE MERCHANTABILITYOR FITNESS FORAPARTICULARPURPOSE ON THIS PRODUCT. Some states or jurisdic-tions do not allow the exclusion orlimitation of incidental or consequen-tial damages, or allow limitations on how long animplied warranty lasts,so the above limitations or exclusions may not apply to you. ThisLimitedWarranty gives you specific legal rights and you may have other rightswhich varyfrom state to state or jurisdiction to jurisdiction.
Page 5MEMO
Page 6MEMO
500 Mamaroneck Avenue, Harrison, NY 10528 Phone: (914) 835-4484 Fax: (914) 835-4532 www.universalremote.comOCE-0033F REV03This equipment has been tested and found to comply with the lim-its for a Class B digital device, pursuant to part 15 of the FCCRules. These limits are designed to provide reasonable protectionagainst harmful interference in a residential installation. This equip-ment generates, uses and can radiate radio frequency energy and,if not installed and used in accordance with the instructions, maycause harmful interference to radio communications.However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful inter-ference to radio or television reception, which can be determinedby turning the equipment off and on, the user is encouraged to tryto correct the interference by one more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiv-er.Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.Consult the dealer or an experienced radio/TV technicianfor help.WarningChanges or modifications not expressly approved by the manufacturercould void the user's authority to operate the equipment.Note : The manufacturer is not responsible for any Radio or TV inter-ference caused by unauthorized modifications to this equipment.Such modifications could void the user's authority to operate theequipment.Information To The User

Navigation menu