Panasonic of North America 9TGWL11E 802.11n 2X2 PCIe MINICARD User Manual Operating Instructions WL11E
Panasonic Corporation of North America 802.11n 2X2 PCIe MINICARD Operating Instructions WL11E
Contents
Users Manual of Module
Model: WL11E
Operating Instructions
1 GENERAL
The purpose of this manual is to explain correct way how to integrate module
WL11E to Panasonic PC. It includes procedures that shall assist you to avoid
unforeseen problems. This manual presents information that shows how module
complies with regulations in certain regions.
The system may only be implemented in the configuration that was authorized.
Note that any changes or modifications to this equipment not expressly
approved by Panasonic could void the user’s authority to operate this
equipment.
2. Frequency Scanning Plan
The EEPROM will be programmed at the factory to only operate and actively
scan on these specific channels:
Channels 1-11, 2412-2462MHz 802.11b mode
Channels 1-11, 2412-2462MHz 802.11g mode
Channels 1-11, 2412-2462MHz 802.11n mode (20MHz channel)
Channels 3-9, 2422-2452MHz 802.11n mode (40MHz channel)
This information when programmed into the EEPROM will not be accessible and
can not be changed by the end user.
Regulatory Information
USA-Federal Communications Commission (FCC)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Caution
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Labeling
The model WL11E is labelled as below.
FCC ID: ACJ9TGWL11E
The proposed with FCC ID label format is to be placed on the module. If FCC ID
is not visible when the module is installed into the system, “Contains FCC ID:
ACJ9TGWL11E” shall be placed on the outside of final host system.
Caution: Exposure to Radio Frequency Radiation.
To comply with FCC RF exposure compliance requirements, the antenna(s)
used for this transmitter must not be collocated or operating in conjunction with
any other antenna or transmitter within a host device, except in accordance with
FCC multi-transmitter product procedures.