Polycom BTMOD01 Bluetooth Radio Module User Manual Polycom Bluetooth Module
Polycom Inc. Bluetooth Radio Module Polycom Bluetooth Module
Polycom >
Users Manual Revised
Polycom Bluetooth Module
Integration Note from Corporate compliance to
Engineering.
The Polycom Bluetooth module is designed to be used in Proprietary Polycom set top
videoconferencing products.
Usage notes
The Module is approved using the FCC ‘unlicensed modular transmitter approval’
method. Therefore the module must only be used with the approved antenna board.
Use of another antenna requires re-approval & must be submitted to Polycom
corporate compliance for FCC registration.
All changes to the module must be made through the Polycom electronic change order
process.
All Polycom software written to control this device must use the Radio Power Table
within the module that controls the maximum output power to +4.16 +/- 2 dBm.
When using this module in a Polycom design. The placement of the Antenna and
module must meet the following RF exposure requirements.
A separation distance of at least 20 cm must be maintained between the antenna of
this device and all persons. This Transmitter must not be collocated or operating in
conjunction with any other antenna or transmitter.
The following labelling & user guide information must be used by anyone using this
module. The ECO process will check that these guidelines have been followed.
Labelling:
The following information must be placed on the Regulatory label of the unit that the
module is installed.
User Guide:
The following statements must be put in the User guide for the product:
Item 1 Pt 15 Rules
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Item 2 Class B Digital Device or Peripheral
NOTE: The Radio module within this equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Item 2c RF module included
To comply with FCC RF exposure compliance requirements, a separation distance of
at least 20 cm must be maintained between the antenna of this device and all persons.
This Transmitter must not be collocated or operating in conjunction with any other
antenna or transmitter.
Item 3 Modifications
In accordance with part 15 of the FCC rules, the user is cautioned that any changes or
modifications not expressly approved by Polycom Inc. could void the user’s authority
to operate the equipment.
Note to Integrators:
The user guide should NOT provide any instructions on how to remove or install the module.