QUICCO SOUND M1REV3 WIRELESS MIDI INTERFACE User Manual 141016 mi 1 En
QUICCO SOUND Corporation WIRELESS MIDI INTERFACE 141016 mi 1 En
User Manual
Wireless Precautions Usage Precautions Do not leave this product in the following places: Places where there is direct sunlight, or inside automobiles in the sun. Places with high heat such as near heaters. Places with high humidity or where condensation occurs. This product does not have a waterproof construction. Use and store in places where it will not be exposed to water or other liquids. Insert only into MIDI connectors. Follow local regulations and ordinances when disposing of this product. First Step For European Union QUICCO SOUND Corporation hereby declares that this WIRELESS MIDI INTERFACE mi.1 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC and 2011/65/EU. This statement has to be accompanied by the exact address (http://www.quicco.co.jp/support-mi1) where a copy of the original declaration of conformity may be found or obtained. Firmware update Update of the firmware is recommended so that mi.1 can be used in the most optimal condition. To do this, please download the dedicated iPhone/iPad application "Piano Jukebox" (free) from App Store. For European Union Information for Users on Collection and Disposal of Old Equipment Piano Jukebox This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC. By disposing of these products correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. Thank you for purchasing the Wireless MIDI Interface mi.1. Be sure to read this manual before use. After reading this manual, store it in a safe place. Intended Use Included Items mi.1: 1 Operation Manual (this manual): 1 Specifications Wireless system Bluetooth Low Energy Connector plug MIDI plug (5-pin DIN) x 2 Power consumption 7 mW (when MIDI OUT is 3.3 V) 25 mW (when MIDI OUT is 5 V) Hall element switch x 1 Magnet x 1 LED (white) x 1 *The specifications and external appearance may change without notice due to continuous improvements. Safety Precautions Be sure to read and follow the directions of the cautions described below to prevent electric shocks, fires, injuries and malfunctions. CAUTION Do not use this product for uses other than its intended use. Stop using this product immediately if it generates heat, smoke or odors, or if there are any other abnormalities. Stop using this product immediately if it is damaged. Do not disassemble, alter or repair this product by yourself. How to connect to iPhone/iPad/Mac [For business users in the European Union] If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. Connection between iPhone/iPad is made by using Bluetooth MIDI-enabled applications such as GarageBand. For connection between Mac, go to Application/Utilities folder and open Audio MIDI Setup. For details please visit our website. [Information on Disposal in other Countries outside the European Union] This symbol is only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Wireless Precautions mi.1 is an interface inserted into electronic musical instruments with MIDI connectors that allows bidirectional MIDI communication between iPhone/iPad/Mac and the instrument. Insert only into MIDI connectors. Use only as an interface for electronic musical instruments. Please follow the instruction that can be found online at: http://www.quicco.co.jp/mi1-update For USA FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. http://www.quicco.co.jp/how-to-connect-mi1v2 Installation Firmware Version Check that the power of the electronic musical instrument has been turned off. Insert mi.1 into the MIDI IN/OUT ports as shown. Factory-default version of firmware is V2. FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment. Terms of Product Warranty For information about product warranty, returns or troubleshooting, please see the URL below. http://www.quicco.co.jp/support-mi1 Authorised Representative Crestec Europe B.V 110 Teleportboulevard, 1043 EJ, Amsterdam, The Netherlands The arrows on the product show the direction of the MIDI signal. Use them as guides for installation. IN OUT This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that are deemed to comply without testing of specific absorption rate(SAR). MIDI Manufacturer QUICCO SOUND Corporation B-2 3-3-1, Shinmiyakoda 1-chome, Kita-ku Hamamatsu 431-2103 Japan iPhone/iPad are registered trademarks of Apple Inc. MIDI is a registered trademark of the MIDI Manufacturers Association (MMA). Bluetooth is the registered trademark of Bluetooth SIG.Inc. ©2014 QUICCO SOUND Corporation. NF00120
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : Adobe XMP Core 5.3-c011 66.145661, 2012/02/06-14:56:27 Format : application/pdf Title : 141016_mi.1_En Metadata Date : 2015:07:15 11:34:05+09:00 Modify Date : 2015:07:15 11:34:05+09:00 Create Date : 2014:10:16 11:46:16+10:00 Creator Tool : Adobe Illustrator CS6 (Windows) Thumbnail Width : 256 Thumbnail Height : 176 Thumbnail Format : JPEG Thumbnail Image : (Binary data 20701 bytes, use -b option to extract) Instance ID : uuid:5b5299d3-8c50-4c39-a5b2-28420026388c Document ID : xmp.did:7EA55D94DE54E4118C07E11EECF1D363 Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : uuid:b76eaa8d-f498-46f8-a811-5318231f1b09 Derived From Document ID : xmp.did:0E37C211C74DE411A5F9952021E251FE Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:32BC0AFADA49E411979C9DB0C131497E, xmp.iid:7EA55D94DE54E4118C07E11EECF1D363 History When : 2014:10:02 14:56:21+09:00, 2014:10:16 11:46:07+09:00 History Software Agent : Adobe Illustrator CS6 (Windows), Adobe Illustrator CS6 (Windows) History Changed : /, / Startup Profile : Print Has Visible Overprint : True Has Visible Transparency : False N Pages : 1 Max Page Size W : 296.999959 Max Page Size H : 210.001652 Max Page Size Unit : Millimeters Font Name : ArialMT, MicrosoftSansSerif, MyriadPro-Bold, MyriadPro-Semibold, MyriadPro-Regular, MyriadPro-SemiboldIt, Wingdings-Regular, KozGoPr6N-Medium Font Family : Arial, Microsoft Sans Serif, Myriad Pro, Myriad Pro, Myriad Pro, Myriad Pro, Wingdings, 小塚ゴシック Pr6N Font Face : Regular, Regular, Bold, Semibold, Regular, Semibold Italic, Regular, M Font Type : Open Type, Open Type, Open Type, Open Type, Open Type, Open Type, Open Type, Open Type Font Version : Version 6.87, Version 6.02, Version 2.106;PS 2.000;hotconv 1.0.70;makeotf.lib2.5.58329, Version 2.106;PS 2.000;hotconv 1.0.70;makeotf.lib2.5.58329, Version 2.106;PS 2.000;hotconv 1.0.70;makeotf.lib2.5.58329, Version 2.106;PS 2.000;hotconv 1.0.70;makeotf.lib2.5.58329, Version 5.00, Version 6.016;PS 6.007;hotconv 1.0.70;makeotf.lib2.5.5900 Font Composite : False, False, False, False, False, False, False, False Font File Name : arial.ttf, micross.ttf, MyriadPro-Bold.otf, MyriadPro-Semibold.otf, MyriadPro-Regular.otf, MyriadPro-SemiboldIt.otf, wingding.ttf, KozGoPr6N-Medium.otf Plate Names : Cyan, Magenta, Yellow, Black Swatch Groups Colorants Tint : 100.000000 Swatch Groups Group Name : Brights Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=60 M=90 Y=0 K=0 Swatch Groups Colorants Mode : CMYK Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Cyan : 60.000002 Swatch Groups Colorants Magenta : 90.000004 Swatch Groups Colorants Yellow : 0.003099 Swatch Groups Colorants Black : 0.003099 Producer : Adobe PDF library 10.01 Page Count : 1 Creator : Adobe Illustrator(R) 16.0 For : nu, Bounding Box : 15 -575 827 -22 Container Version : 9 Creator Version : 16EXIF Metadata provided by EXIF.tools