RCA Communications Systems RDR3500U Two Way Radio User Manual 1

RCA Communications Systems Two Way Radio 1

Contents

User Manual 1

Model: RDR3500U
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
IC statement
The device has been tested and compliance with SAR limits, users can obtain Canadian information on
RF exposure and compliance
Après examen de ce matériel aux conformité aux limites DAS et/ou aux limites d’intensité de champ RF,
les utilisateurs peuvent sur l’exposition aux radiofréquences et la conformité and compliance d’acquérir
les informations correspondantes
RF Exposure Compliance and Control Guidelines and Operating Instructions
To control your exposure and ensure compliance with the occupational/controlled
environment exposure limits always adhere to the following procedures.
Guidelines:
Do not remove the RF Exposure Label from the device.
User awareness instructions should accompany device when transferred to other
users.
Do not use this device if the operational requirements described herein are not met.
Operating Instructions:
Transmit no more than the rated duty factor of 50% of the time. To transmit (talk),
push the Push-To-Talk (PTT) button. To receive calls, release the PTT button.
Transmitting 50% of the time, orless, is important because this radio generates
measurable RF energy exposure only when transmitting (in terms of measuring for
standards compliance). Hold the radio in a vertical position in front of face with the
microphone (and the other parts of the radio, including the antenna) at least one inch
(2.5 cm) away from the nose. Keeping the radio at the proper distance is important
because RF exposures decrease with distance from the antenna. Antenna should be
kept away from eyes.
When worn on the body, always place the radio in a Xiamen Puxing Electronics
Science&Technology Co., Ltd approved clip, holder, holster, case, or body harness
for this product.
Using approved body-worn accessories is important because the use of Xiamen
Puxing Electronics Science&Technology Co., Ltd or other manufacturer’s
non-approved accessories may result in exposure levels, which exceed the FCC’s
occupational/controlled environment RF exposure limits.
If you are not using a body-worn accessory and are not using the radio in the intended
use position in front of the face, then ensure the antenna and the radio are kept at least
2.5 cm (one inch) from the body when transmitting. Keeping the radio at the proper
distance is important because RF exposures decrease with increasing distance from
the antenna.
Use only Xiamen Puxing Electronics Science&Technology Co., Ltd approved
supplied or replacement antennas, batteries, and accessories. Use of
non-manufacturer-nameapproved antennas, batteries, and accessories may exceed the
FCC RF exposure guidelines.

Navigation menu