Radio Shack 3201258AR Receiver for Wireless Microphone User Manual

RadioShack Corporation Receiver for Wireless Microphone

User Manual

installing batteries for the microphone1. Unscrew the microphone grille to loosen it and remove the battery cover.2. Insert two AA batteries.3. Replace the battery cover and screw the microphone grille when completed.battery notes• When the indicator on the microphone becomes dim, replace the batteries. • Dispose of old batteries promptly and properly. • Do not burn or bury batteries.• Use only fresh batteries of the required size and recommended type.• Do not mix batteries of different sizes or types.• If you do not plan to use your microphone system for a month or more, remove the batteries. Batteries can leak chemicals that can damage electronic parts.Thank you for purchasing your 170MHz Single Channel Wireless Microphone System from RadioShack. Your system will transmit microphone signals while you move freely up to 200 feet away from the receiver.microphone receiver9V AC adapter user’s guidewhat’s includedpowering the microphone system32-1258170MHz Single Channel Wireless Microphone System1. Press POWER on the receiver to turn it on. The POWER indicator will light up.2. Fully extend the receiver’s antenna.                      OFF/MUTE/TALK switch to TALK. The READY indicator will light up.  VOLUME on the receiver. OFF/MUTE/TALK to MUTE. Use MUTE to avoid the popping noise that might occur if you turn OFF/MUTE/TALK to OFFTALK.7. Rotate SQUELCH to control the transmitting distance. Turn to minimum to increase the transmitting distance.When you nish using the system, be sure to turn the OFF/MUTE/TALK switchon the microphone to OFF mode to save battery power.using the microphone systemFrequency ........................................................................................ ................. RF Power ...............................................................................10dBm ..................................................Operating Range .................................................. 200 feet (Typical) ...............................Two AA BatteriesReceiver ..........................................................1uV .......................................................75dB .......................................................................55dB ...........................................................................510mV Microphone Output ................................................................10mVFrequency Response ................................................120---13000HzPower Requirement ............................AC-DC adapter 9V@250mANOTE: Specications are typical; individual units may vary. Specications are subject to change and improvement without notice.specicationsWarning: Modifying, tampering with, or adjusting this unit, or replacing any transmitter component (crystal, semiconductor, etc.) may result in a violation of the FCC rules.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult your local RadioShack store or an experienced radio/TV technician for help.If you cannot eliminate the interference, the FCC requires that you stop using your microphone system. Changes or modications not expressly approved by RadioShack may cause interference and void the user’s authority to operate the equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device may not cause harmful interference.This wireless microphone system complies with Part 90 of the FCC Rules. There are three frequencies available for the system. You must obtain a license for each frequency you plan to use before operating your system. One license can include both frequencies. Visit http://wireless.fcc.gov/uls/, or call your local FCC ofce to apply for your license. Your ability to obtain a license will depend on how you plan to use the system.For RF exposure“IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the system exceeding the RF exposure requirements.”For devices less than 200mW ERPSAFETY INFORMATIONYour wireless microphone contains a low power transmitter. When the EUT is powered on, it sends out radio frequency (RF) signals. In August 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for wireless devices.IMPORTANTTo maintain compliance with the FCC’s RF exposure guidelines, hold the transmitter and antenna at least 1 inch (2.5 centimetres) from your face and speak in a normal voice, with the antenna pointed up and away from the face. Ensure that the antenna is at least 1 inch (2.5 centimetres) from your body when you are using your wireless microphone. Use only the supplied antenna. Unauthorized antennas, modications, or attachments could damage the transmitter and may violate FCC regulations.the FCC wants you to know©2006. RadioShack Corporation. All rights reserved. RadioShack and RadioShackused by RadioShack Corporation.32-125804A06 Printed in China  POWER to OFFvolume to minimum.2. Connect the 9V AC adapter to the receiver’s DC 9VPlug the other end into a standard AC outlet.3. Use a shielded audio cable (not included) to connect the LINEyour receiver to the LINE/AUXIf you are using your amplier’s LINE/AUX IN, connect the MICROPHONE jack on your receiver to the MICROPHONE jack on your amplier with a 1/4” audio cable (not included). You can connect both output jacks to an amplier and a tape recorder to record the microphone signals at the same time you are listening to the audio.connecting the receiverThis product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for one (1) year from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. For complete warranty details and exclusions, check with your local RadioShack store.RadioShack Customer Relations 300 RadioShack Circle, Fort Worth, TX 76102 04/04limited one-year warrantyup and using your new product.microphone grillebattery coverVOLUME – Rotate to adjust the volume.SQUELCH – Rotate to limit the background noise and control the transmitting distance when speaking into the microphone.POWER – Press to turn on/off the receiver.TALK-MUTE-OFF switchPOWER indicatorREADY indicatorWARNING: To reduce the risk of re or shock hazard, do not expose this product to rain or moistureCAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.The lightning symbol is intended to alert you to the presence of uninsulated, dangerous voltage within this product’s enclosure that might be of sufcient magnitude to constitute a risk of electric shock. Do not open the product’s case.The exclamation symbol is intended to inform you that important operating and maintenance instructions are included in the literature accompanying this product.CAUTION!RISK OF ELECTRIC SHOCKDO NOT OPEN!shielded audio cable 1/4” audio cable AC adapter

Navigation menu