Radio Shack AWS1475R 900MHz Wireless Speaker User Manual 40 1475 UG indd

RadioShack Corporation 900MHz Wireless Speaker 40 1475 UG indd

User Manual

Please read this user’s guide before installing, setting up, or using your new product.AWS-1475900MHz Wireless Indoor /Outdoor Mnon SpeakerThank you for purchasing your Accurian 900MHz Wireless Indoor/Outdoor Mono Speaker. speaker transmitter12V DC adaptor 9V DC adaptorRCA cable 3.5mm plug adaptor6.3mm plug adaptor user’s guidewhat’s includedConnect the 9V DC adaptor to the transmitter’s DC jack, then plug the other end into a standard AC outlet.powering the transmitterEach transmitter has three channels, select the desired channel to match the receiver’s channel. Make sure that the transmitter’s channel is the same as the receiver’s channel.setting the channel FCC InformationThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult your local RadioShack store or an experienced radio/TV technician for help.If you cannot eliminate the interference, the FCC requires that you stop using your speaker. Changes or modifications not expressly approved by RadioShack may cause interference and void the user’s authority to operate the equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.speakertransmitterG -VOLUMERotate in the direction of the arrow until it clicks to turn on the speaker. The green led lights. Then adjust it to a comfortable listening level. To turn off, rotate it clockwise until it clicks.BASSTo increase or decrease bass notes.TransmitterCarrier Frequency ................................................................................915.6 - 918.4 MHzPower Source ........................................................................................................................... Unregulated 9V DC, Center Tip set to positive (+), 250mAModulation Method ................................................................................FM ModulationFrequency Response ....................................................................80 Hz – 20 kHz (6 dB)Measurement (WHD) ................................................................ 4½ x 2½ x 41/8 InchesSpeakerPower Source .............................................................................................................12V DCSensitivity ..................................................................................... < 2µV (with 20 dB S/N)S/N Radio (@-50 dBm) .......................................................................... 70 dB (A weight)Audio Distortion ............................................................................................................ <2%Max. Audio output .....................................................................................................>=5WMeasurement (WHD) ................................................................. 82/3 x 11 x 8¼ InchesSpecifications are typical; individual units might vary. Specifications are subject to change and improvement without notice. Actual product may vary from the product images in this document.specificationsNOTEchannel 3 9V DC adaptorDC 9V jackCaution: Do not attempt to recharge alkaline batteries or regular batteries. Warning: Do no try to recharge the non-rechargeable batteries, or the batteries would explode!The speakers’ DC 12V jack is for charging rechargeable batteries and powering the speaker.1. Turn off the speaker.2. Remove the battery cover.3. Slide ON/OFF inside the battery compartment to ON. 4. Insert eight C rechargeable batteries in the battery compartment, matching the polarity symbols (+ and -) marked inside.5. Connect one end of the 12V DC adaptor to the DC 12V jack and plug the other end to a standard AC outlet.6. When charging is completed, unplug the DC adaptor from the power source, and disconnect it form the speaker’s DC jack.recharging Ni-Cd or Ni-MH batteriestransmitter speakerYou can connect your audio source (such as MP3, CD and DVD) to the transmitter with the supplied RCA cable.1. Connect the RCA cable’s color jacks to your transmitter by matching the color.2. Plug the other ends into your audio source’s output jacks. If the output jack of your audio source is 3.5mm or 6.3mm, connect the RCA cable to the 3.5mm plug adaptor or/and 6.3mm plug adapter for the connection.connecting to y0ur audio sourceYou can power the speaker with the 12V DC adaptor.To power the speaker with AC power, connect one end of the 12V DC adapter to the receiver, then plug the other end into a standard AC outlet.The green led on the transmitter turns on when its built-in Automatic Level Detection circuit detects the music or signal from the audio source. When the audio source stops for more than 30 seconds, the transmitter will automatically shut down and enter the standby mode.powering the speaker with AC power1. Lift up the battery cover on the bottom of the speaker.2. If the batteries are non-rechargeable batteries, slide ON/OFF inside the battery compartment to OFF. 3. Insert eight C batteries in the battery compartment, matching the polarity symbols (+ and -) marked inside.4. Replace the cover.installing batteries for the speaker• It takes about 10-12 hours to fully recharge the batteries.• The built-in charger is designed for batteries (both Ni-Cd & Ni-MH) with a voltage of 1.2 Volts and a current rating of 2000mAh.• The batteries will be automatically recharged during the standby mode and when the Power ON/OFF is OFF.• Dispose of old batteries promptly and properly. Do not burn or bury batteries.• Do not mix batteries of different sizes or chemistries.• If you do not plan to use your mouse for a week or more, remove the batteries. Batteries can leak chemicals that can damage electronic parts.batteries notesRCA cable3.5mm plug adaptor6.3mm plug adaptor12V DC adaptorDC 12V jackON/OFF switchbattery coverThis product is warranted by Innovation One against manufacturing defects in material and workmanship under normal use for ninety (90) days from the date of purchase from authorized Innovation One dealers. For complete warranty details and exclusions, check with your dealer or contact Innovation One directly.Innovation One, Inc. 350 North Henderson Street Fort Worth, TX 76102 04/05limited 90-day warrantyNOTE©2005. Innovation One, Inc. All rights reserved. Accurian is a trademark used by Innovation One..ASW-147512A05Printed in ChinaAO0259AAA1www.radioshack.com40-1475_UG.indd 1 12/02/2005 14:13:10FCC ID: AAOAWS1475R

Navigation menu