Red Point Positioning MODV7 RTLS Module with UWB and BLE User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3726124
Application ID	A8ltBf2p3WoooNaLfX636A==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	35.57kB (444646 bits)
Date Submitted	2018-01-24 00:00:00
Date Available	2018-09-10 00:00:00
Creation Date	2017-12-21 17:03:24
Producing Software	Microsoft® Word 2016
Document Lastmod	2017-12-21 17:03:24
Document Title	User Manual
Document Creator	Microsoft® Word 2016
Document Author:	Gary Li

RTLS MODULE
User Manual for RTLS Module
__________________________________________
Revision History
revision
1.0
date
July 2017
notes
Initial release
Overview____________________________________________
The RTLS Module is a full function RTLS
subsystem that self-contained in a compact
dimension. This module provides high accuracy
positioning, UWB communication and Bluetooth
communication abilities to user’s system.
The figure below shows the block
diagram of the RTLS Module. RTLS Module is a
single PCB design and consists of a microcontroller, a radio transceiver, two on-board chip
antennas, power management circuitry, and
other peripherals.
RTLS Module
Specification_________________________________________
Maximum Rating
The modules should be stored indoor with relative humidity no greater than 80%, and
temperature between 0 °C and 40 °C. Exposure to high heat is prohibited. Direct sunlight should
also be avoided.
Parameter
Temperature (°C)
Humidity (%)
Supply Voltage (V)
Maximum Rating
-40 ~ 85
< 90
2.8 ~ 3.6
Recommended Operating Conditions
Parameter
Temperature (°C)
Humidity (%)
Min
-40
N/A
Max
85
<90
Power Supply
The RTLS Module can be powered by an external DC power supply via half holes on the
edge. The power supply should be clean with current rating of 200mA or higher.
Typical Voltage and Current Consumption.
Parameter
Voltage (V) (for both
DW3.3 and 3.3)
Current (A) on DW3.3
Current (A) on 3.3
Condition
Min
Typ
Max
Unit
2.8
3.3
3.6
144.5
10.85
mA
mA
RF Transceiver
The module operates in the unlicensed UWB band. The transmitted signal bandwidth is
500 MHz or greater. The units are calibrated such that the maximum radiated spectrum density
is no more than -41 dBm/MHz and is fully compliant to the spectrum mask defined in FCC part
15. It is also compliant with the similar spectrum regulation for regions and countries including
US, Canada and EU.
Parameter
Frequency Range (MHz)
10dB Bandwidth (MHz)
Center Frequency* (MHz)
Spectrum Density
(dBm/MHz)
Min
3244
500
3494.4
N/A
Max
6999
6489.6
-41
*The center frequency is software configurable. See table below for details.
The module is software configurable to operate on 4 UWB channels. The specification of
each channel is given as below.
Channel Number
Fc (MHz)
3494.4
3993.6
4492.8
6489.6
Fmin (MHz)
3244.8
3774
4243.2
6240
Fmax (MHz)
3744
4243.2
4742.4
6739.2
Important Regulatory Information
FCC Statements (United States)
This device complies with Part 15 of the FCC Rules:
Operation is subject to the following conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation
Changes and Modifications not expressly approved by Redpoint Positioning Corp. can void your
authority to operate this equipment under Federal Communications Commissions rules.
Warning: To fulfill FCC Certification requirements, users who integrate RTLS module in their
system must comply with the following regulations:
The RTLS Module modular transmitter must be labeled with its own FCC ID number, and, if the
FCC ID is not visible when the module is installed inside another device, then the outside of the
device into which the module is installed must also display a label referring to the enclosed
module. This exterior label can use wording such as the following:
Contains FCC ID: 2ADX4-MODV7
IMPORTANT:
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation
(FCC 15.19).
IMPORTANT Antenna Information:
To comply with FCC / ISED regulations limiting both maximum RF output power and human
exposure to RF radiation, the maximum antenna gain including cable loss in a mobile-only
exposure condition must not exceed;
Peak UWB Antenna Gain: 2.6dBi
Peak BLE Antenna Gain: 2.2dBi
Industry Canada (IC) Compliance Statements
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
CAUTION: Any changes or modifications not expressly approved by Redpoint Positioning Corp.
could void the user’s authority to operate the equipment.
The RTLS Module is labelled with its own IC ID. If the IC ID Certification Number is not visible
while installed inside another device, then the device should display the label on it referring the
enclosed module. In that case, the final product must be labelled in a visible area with the
following:
“Contains IC: 12677A-MODV7”
Ce module est étiqueté avec son propre ID IC. Si le numéro de certification IC ID n'est pas
visible lorsqu'il est installé à l'intérieur d'un autre appareil, l'appareil doit afficher l'étiquette sur le
module de référence ci-joint. Dans ce cas, le produit final doit être étiqueté dans un endroit
visible par le texte suivant:
“Contains IC: 12677A-MODV7”
Interfaces
RTLS module provides one UART interface, one SWD programming interface, and 6
general purpose IO to the user, all GPIOs may be configured as analog input as well.
Category
Power
Programming
Interface
User
interface
NFC RF
Analog /
GPIO
pin name
PWR_IN
GND
type
power
ground
SWDCLK
input
SWDIO
Input/output
nRESET
TXD
input
output
RXD
NFC1
NFC2
AIN0 / DIO0
/ RSTO0
AIN1 / DIO1
/ RSTO1
AIN2 / DIO2
/ INT0
AIN3 / DIO3
/ INT1
AIN4 / DIO4
AIN5 / DIO5
input
NFC input
NFC input
description
3.3V
SWD programming
interface
SWD programming
interface
Reset input, active
low
UART interface
UART interface
NFC antenna port
NFC antenna port
input/output/analog
GPIO / reset output 0
input/output/analog
GPIO / reset output 1
input/output/analog
GPIO / Interrupt 0
input/output/analog
input/output/analog
input/output/analog
GPIO / Interrupt 1
GPIO
GPIO
Mechanical and Packaging
The dimension of the module is 32mm x 25 mm. There are 24 castellation hole pin-outs around
the module, the pitch is 100mil (2.54mm). Following diagram shows outline of RTLS Module.
RTLS Module
Order Information
Use the following part number when ordering module.
Part Number
9101-0700
Description
RTLS Module
Contact Us___________________________________________
Redpoint Positioning, Corp.
100 N Washington St
Boston, MA 02114
phone: +1 (617) 207-4096
email: sales@redpointpositioning.com web:
www.redpointpositioning.com

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : No
Page Count                      : 7
Language                        : en-US
Tagged PDF                      : Yes
XMP Toolkit                     : 3.1-701
Producer                        : Microsoft® Word 2016
Creator                         : Gary Li
Creator Tool                    : Microsoft® Word 2016
Create Date                     : 2017:12:21 17:03:24-05:00
Modify Date                     : 2017:12:21 17:03:24-05:00
Document ID                     : uuid:13A5133E-3445-45D7-A788-F524590FBE2A
Instance ID                     : uuid:13A5133E-3445-45D7-A788-F524590FBE2A
Author                          : Gary Li

EXIF Metadata provided by EXIF.tools