SAGEMCOM BROANDS FAST5260CV Fast 5260 CV Home Router User Manual

SAGEMCOM SAS Fast 5260 CV Home Router

user manual

Download: SAGEMCOM BROANDS FAST5260CV Fast 5260 CV Home Router User Manual
Mirror Download [FCC.gov]SAGEMCOM BROANDS FAST5260CV Fast 5260 CV Home Router User Manual
Document ID2067440
Application IDXutk8vqqfwN81gxndGhFew==
Document Descriptionuser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize67.6kB (844993 bits)
Date Submitted2013-09-10 00:00:00
Date Available2014-01-22 00:00:00
Creation Date2013-06-25 13:52:10
Producing SoftwareAcrobat Distiller 9.5.5 (Windows)
Document Lastmod2013-06-25 13:52:10
Document TitleMicrosoft Word - 253541042B Fast 5260 Safety sheet 30-05-2013.doc
Document CreatorPScript5.dll Version 5.2.2
Document Author: g092899

Safety and Certifications
Safety and Certifications
Important Information about the Sagemcom F@st 5260CV:
Installation and Safe Usage Instructions:
1. Place the router in a vertical orientation on a flat surface.
2. Connect the manufacturer supplied AC to DC power adapter. The F@st 5260CV router requires the
use of a 12 VDC, 2.5 A power adapter. Only use a manufacturer supplied and approved power adapter
and Ethernet cable.
3. Connect the F@st 5260CV to the AC Mains in accordance with the installation instructions in this
booklet, and the markings on the identification label (voltage, current, and frequency of electricity
network).
4. Connect the Ethernet cable (provided) to one of the RJ45 ports on the Router labeled "1", "2", "3", or
"4". Then connect the other end of the Ethernet Cable to the Ethernet port of a computer. Repeat as
necessary for the other available Ethernet ports.
5. For an Ethernet WAN configuration, connect the RJ45 port labeled “wan” to the connection provided by
your ISP.
When using this device, basic safety precautions should always be followed to reduce the risk of
fire, electric shock, and injury to persons including the following:
1. Do not use this product near water and avoid contact with moisture. For example, do not use near a
bathtub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool. Care
should be taken so that liquids are not spilled on this equipment.
2. This equipment is for indoor use only, do not place or install in an outdoor location.
3. Place your product on a firm, solid surface, no obstacle at a minimum distance of 20 cm (0.65 ft). If
you put it on something unsteady, it may fall and be damaged. If you place it on a soft surface, such
as rug, sofa or cushion, the vents may be blocked, causing the product to overheat.
4. Never insert objects into the vents of this equipment as this can result in the risk of electrical shock or
fire.
5. As the power adapter is the only way to connect to the electrical network, the product must be
installed near an easily accessed power outlet.
6. This equipment should only be operated from the type of power supply (Voltage and Current)
indicated on the marking label.
7. Do not overload wall outlets or extension cords. Doing so can result in the risk of fire or electrical
shock.
8. Avoid blocking any vent openings or exhaust exits on this equipment. Do not place equipment in a
built-in installation such as a cabinet that may impede the flow of air through the ventilation openings.
9. The equipment should be situated away from heat sources such as radiators, heat registers, stoves,
or other heat producing appliances and equipment.
10. Care should be taken to ensure that the power cord is routed, so it is not likely to be walked on or
pinched by items placed upon or next to it.
11. Unplug this equipment before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp
cloth for cleaning only.
12. This equipment is not user serviceable and is to be serviced by qualified personnel only. Do not
disassemble this equipment. If service is required, disconnect all power from the equipment and
consult qualified service personnel.
13. To disconnect this equipment from AC power, unplug the power supply from the AC wall socket.
14. Connect only to in house equipment (SELV interface). It is not allowed to connect to public cable
distribution or cable television network.
15. Use the product in the environment specified as below:
Air temperature between 0 °C and + 40 °C.
Relative humidity between 20 % and 90 %.
Altitude: 2000 meters (6562 ft) maximum.
Save these Instructions!
253541042-B
25 June 2013
253541042-B
25 June 2013
Safety and Certifications
Safety and Certifications
Wall Mounting Router (Optional)
Federal Communications Commission (FCC) Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Modifications:
You are cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
FCC Responsible Party:
Sagemcom USA
14651 N. Dallas Parkway
Suite 900
Dallas, TX 75254
Phone: 972-674-4100
While many users place their F@st 5260CV series gateways on their desk, it can be optionally wall
mounted.
1.
The unit is wall mounted with the top of the unit facing up.
2.
Ensure that the wall you use is smooth, flat, dry, and sturdy.
3.
The unit is mounted using two M3x20 screws (20mm length and 3mm in diameter).
4.
Install the two screws 135 mm (5.3 inches) apart approximately 20 mm (0.8 inches) below the
desired top of the unit per the following figure.
5.
Screw the screws into the wall leaving their heads extending approximately 3.5 to 4.0 mm
(0.15 inch) from the wall surface.
6.
Carefully align the screw heads in the keyholes on the back of the unit and gently push it onto the
wall moving it downward to secure it in the narrow portion of the keyhole slots.
Radio Frequency Interference Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1.
2.
3.
4.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device produces radio frequency energy in the 2.4 GHz and 5 GHz spectrums. The antenna must be
positioned to keep a minimum distance of 20 cm (0.65 ft) from the radiating element to any nearby
person.
Issued by Sagemcom Broadband SAS
Sagemcom
250, route de l'Empereur - 92848 RUEIL MALMAISON CEDEX
FRANCE
© Sagemcom Broadband SAS 2013
All rights reserved. Subject to availability.
Rights of modifications reserved.
www.sagemcom.com
253541042-B
25 June 2013
253541042-B
25 June 2013

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Producer                        : Acrobat Distiller 9.5.5 (Windows)
Creator Tool                    : PScript5.dll Version 5.2.2
Modify Date                     : 2013:06:25 13:52:10+02:00
Create Date                     : 2013:06:25 13:52:10+02:00
Format                          : application/pdf
Title                           : Microsoft Word - 253541042B Fast 5260 Safety sheet 30-05-2013.doc
Creator                         : g092899
Document ID                     : uuid:83ea4d4c-1d44-4492-b1eb-fa08054603aa
Instance ID                     : uuid:09f6d7c9-d3dc-4147-860f-97571a469d69
Page Count                      : 2
Author                          : g092899
EXIF Metadata provided by EXIF.tools
FCC ID Filing: VW3FAST5260CV

Navigation menu