Shantou City Hengdi Industry HD18A24G Drone Lunar 5inch Stunt Hand Controlled User Manual MS SI Lunar Drone Hand Control IM 20170427
Shantou City Hengdi Industry Co., Ltd Drone Lunar 5inch Stunt Hand Controlled MS SI Lunar Drone Hand Control IM 20170427
Contents
- 1. User Manual
- 2. Packaging
User Manual
OPERATING DRONE
OVERVIEWGETTING TO KNOW YOUR DRONE
OPERATING DRONE OPERATING DRONE ADVANCED MODES TIPS & TROUBLESHOOTING
CONTENTSWARNINGSGENERAL WARNINGS CHARGING/BATTERY
77 88 99
2211 33 44
66
1010
DRONE
REMOTE
STUNT TIPSDIRECTION
INSIDE THE BOX
TAKE OFF AND LAND
CLIMB/DIVE AUTO-ORIENTATION
TROUBLE SHOOTING
55
CHARGING
PAIRING
DIRECTIONAL LIGHTS
REMOTE CONTROL
14+14+
OFF ON
5 FEET
10 FEET
10 FEET
360
45
mins
22
Thumbstick
• Do not crash drone into sand or dirt. Drone gears may become clogged
• When first learning to fly, practice lifting o and hovering
• Stay several feet from walls and buildings
• Always press throttle all the way down after crashing or when something gets stuck in propellers
• Never fly drones above or near people, sudden changes in wind or other conditions could lead to
unexpected crashes.
• Always use caution when flying drone vehicles, obey relevant laws, respect the privacy and
property rights of others.
• The drone shall never be modified or used for anything except its intended purpose.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Turn Left
and Right
Forward and
Backward
Sideways
TAKE-OFF
Press and
release
thumbstick.
Drone will
rise and
auto-hover.
CLIMB
Press and hold thumbstick while raising hand.
Drone will climb.
DIVE
Press and hold thumbstick while lowering hand.
Drone will descend.
SPIN CLOCKWISE
Push the thumbstick
forward.
SPIN
COUNTER-CLOCKWISE
Push the thumbstick
backward.
When first using drone, use small hand movements to control it.
LANDING
Bring drone
to 10’ of
ground.
Press and
release
thumbstick
and drone
will land.
iiii
iii
iii
iv
iv
v
v
i
i
Slide drone
switch to ON.
Place drone
on a flat even
surface.
For ease of control, the red lights should be toward you.
Turn remote
ON. The status
LED will light.
Make sure
your remote
is o.
1. Read all warnings and instructions.
2. Install remote batteries, page 3.
3. Make sure that drone and remote are
powered o.
4. Install drone holder.
5. Charge batteries, page 3.
Always turn o remote prior to retrieving or picking up drone.
This will help you avoid accidently activating propellers.
Choose a location
Pairing Drone
Pre Flight Checklist
11
2
2
3
3
Lunar 5” Drone Drone Controller
Replacement Propellers
Open battery cover and
install 3 “AAA” 1.5V
batteries as shown.
Battery Cover
Warning: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
©2018 Sharper Image. Sharper Image® name and logo are registered trademarks. All rights
reserved. Distributed by MerchSource, LLC, Irvine, CA 92618.
The artwork and design of this manual are protected by US copyright law and may not be
reproduced, distributed, displaced, published or used for any purpose without prior written
permission. Altering, removing or reproducing any of the trademark or copyright notices on this
package is not permitted.
PATENT PENDING
Printed in China
WARNING: ONLY USE PROVIDED
USB CABLE FOR CHARGING
Before calling please locate the 10-digit code printed on the back of your remote
QUESTIONS OR CONCERNS?
PLEASE GIVE US A CALL ... WE«RE HERE TO HELP
CUSTOMER SERVICE (800) 374-2744
STUNT DRONE
WITH HAND CONTROL
ii
Hover the
drone to at
least above
10 ft.
Push and
hold the
thumbstick
up.
iiii
While still holding
the thumbstick up,
move your hand in
the direction that
you want the drone
to flip.
iiiiii
10 FEET
• Not recommended for children under 14 years of age. As with all electrical products,
precaution should be observed during handling and use to reduce the risk of
electrical shock.
• Adult supervision is required at all times.
• Before each use, an adult should review the product and battery to determine that no
damage or hazards exist.
• DO NOT TOUCH SPINNING PROPELLERS.
• Do not allow anything to intentionally make contact in any way with spinning propellers.
• Prevent contact with spinning blades by turning o remote prior to handling drone.
• Use caution and pay attention to your surroundings while operating drone.
• Do not fly drone into animals, people, or inanimate objects.
• Keep drone away from power lines, buildings, trees, public areas, and any other
potentially hazardous areas.
• Do not operate in rain, heavy wind, and or any type of severe weather.
• Do not land drone on wet surfaces.
• Never touch or allow others to touch drone while it is flying.
• Always turn drone o when it is not in use.
• Always fly drone in large open areas.
• Never fly drones above or near people, sudden changes in wind or other conditions
could lead to unexpected crashes.
• Always use caution when flying drone vehicles, obey relevant laws, respect the
privacy and property rights of others.
• The drone shall never be modified or used for anything except its intended purpose.
READ ALL WARNINGS AND PRECAUTIONS BEFORE USE.
SAFETY WARNINGS:
FAA WARNING
This drone weighs 0.08 lbs. As of November 2017, the Federal Aviation Administration
(FAA) requires registration of unmanned aircrafts weighing more than .55lbs. Visit
www.faa.gov/uas/registration for more information. Ongoing compliance with
Federal, state and local laws regarding operation is an owner’s sole responsibility.
The drone’s
lights will
flicker rapidly
during the
auto-pairing
process and
then remain
on once it has
paired.
When drone is in Auto-Orientation mode, the drone will orient to
the user (remote), no matter what direction the drone is facing.
To turn o Auto- Orientation
mode, push the
thumbstick down
and release. The
drone’s lights will
stop blinking and
remain on.
iviv
The drone’s
lights will
blink steadily
while in auto-
orientation
mode.
iiiiii
ii
ii
Press the
thumbstick
down and
release.
When remote switch is turned on, the remote light does not illuminate:
1) Check that batteries in the remote are installed correctly OR
2) Replace with new batteries
During flight, the Remote Power LED is flashing:
1) Remote batteries are low. Land the drone immediately.
2) Replace old batteries.
Drone and remote properly pair, but the drone will not lift-o:
1) Drone battery needs charging. Use the USB Charge Cable to connect the drone to power
source.
After trimming the drone, flight is very unstable and it cannot fly properly:
1) One or more blades are most likely damaged; Replace with the proper number replacement
blade and try flying again (page 3).
2) Press the thumbstick down for 5 seconds to reset the gyroscope.
3) Turn o the drone and remote, then repeat the pairing process (page 6).
Remote and drone cannot be paired:
1) Remote must be within 12 feet of drone.
Note: If there is more than one unpaired drone within 12 feet, one must be successfully paired
before others may be paired.
RECHARGEABLE BATTERY WARNING: (REPLACEABLE BATTERY)
There is a risk of fire and personal injury if battery is punctured, damaged, or misused
• Do not dismantle, crush, incinerate or short-circuit battery.
• Never expose battery to extreme temperatures or moisture
• Keep away from flammable materials and direct sunlight
• Only charge using the provided charger, cable, and/or adapters
• Rechargeable battery is only to be charged by an adult.
• Adult Supervision of the battery while it is charging is required
• Allow battery to cool to room temperature before charging.
• Charge on a non-flammable surface and keep away from flammable products
• Discontinue charging if battery becomes hot, swells, smokes, or gives o a strong odor.
• Battery chargers used with the product are to be regularly examined for damage to the cord, plug,
enclosure, and other parts, and in the event of such damage, they must not be used until the damage
has been repaired.
• Remove batteries (if removable) before storing
• Recycle or dispose of battery according to federal, state, and local laws
• Cells or batteries should not be disassembled, crushed, punctured, opened, or otherwise mutilated.
• Seek medical advice immediately if a cell or battery has been swallowed.
• In the event that the electrolyte comes into contact with the skin or eyes, immediately flush with fresh
water for at least 15 minutes and seek medical advice.
• Store cells and batteries in their original packaging and away from metal objects which may
short-circuit them.
• Do not drop or subject the cell or battery to strong mechanical shock.
• Keep cells or batteries clean and dry both during use and storage. Wipe metal terminals with a soft,
dry cloth if they become dirty.
• Charge cells or batteries before use.
• On first use, or after prolonged periods of storage, it may be necessary to charge and discharge the
cell or battery two or three times before obtaining maximum performance.
• It is best to charge the cell or battery at temperatures between 15°C and 30°C unless otherwise
specified by the manufacturer.
• Retain original product literature for future reference.
BATTERY WARNING
• Do not mix old and new batteries
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries
• Alkaline batteries are recommended. Use only the specified voltage.
• Insert batteries using the correct polarity. Always use, replace, and recharge (if applicable) batteries
under adult supervision
• Do not charge with non-rechargeable batteries
• Do not short-circuit the battery supply terminals
• Do not dispose of batteries in fire, batteries may explode or leak.
• Remove batteries (if removable) before storing.
• Recycle or dispose of batteries according to federal, state, and local laws.
USB Charge Cable
CHOKING HAZARD –
SMALL PARTS NOT FOR CHILDREN UNDER 3 YEARS.
ADULT ASSEMBLY REQUIRED.
PLEASE RECYCLE OR DISPOSE OF ELECTRONICS PROPERLY
RECYCLING INFORMATION IS AVAILABLE AT
WWW.MERCHSOURCE.COM
HoldHold HoldHold
Hold
Hold
Press and Release =
Auto Take O/Landing
Press and Hold +
Raise Hand = Drone Climb
Lower Hand = Drone Descend
Forward = Spin Drone Clockwise
Backward = Spin Drone
Counterclockwise
Up and Hold + Hand Motion =
360˚ flip in direction of hand motion
Down and Release =
Auto Orientation On/O
Down and Brief Hold = Reset Gyroscope
ON/OFF switch
Propeller 1
White Lights (Front)
Red Light (Back)
Propeller 2
Propeller 2Propeller 1
Battery Compartment
ON/OFF remote switch
(on other side)
Light indicates
remote is on
Hand Strap
• Drone must be charged before each use (USB Charge Cable included)
• Indicator light will turn o once fully charged
• Install batteries in remote
Before each flight pair the remote with the drone:
1. Turn your drone on and place on a flat, level surface
2. Turn on the remote.
3. Steady lit lights on the drone confirm pairing
4. Repeat steps 1 and 2 if necessary.
IMPORTANT!
After a hard landing, turn drone and remote o.
Then, repeat pairing!
• White lights indicate the front of the drone
• Red lights indicate the back of the drone
• Not applicable in auto-orientation mode
The drone is controlled by the movement of the hand wearing the controller.
Practice flying in an area free of obstruction. Fly below 10 feet until control
is mastered.
• The controller is designed for the right hand
• Use small movements for maximum control
• The thumbstick toggles take-o and landing, altitude changes, & special
flight modes.
PLEASE READ ALL WARNINGS AND INSTRUCTIONS PRIOR TO
USE. KEEP THIS DOCUMENT AS IT CONTAINS IMPORTANT
INFORMATION ABOUT YOUR DRONE.
Pull firmly to remove broken propeller. Replace with a new one.
Push firmly and carefully.
ii
Each blade has a number on it. Match the blades with the corresponding
number on the drone.
iiii
Printed in China
Printed in China Printed in China Printed in China Printed in China Printed in China
Printed in ChinaPrinted in ChinaPrinted in ChinaPrinted in ChinaPrinted in China Printed in China
Printed in China
iiii
iii
iii
Connect the Battery Charger to the charge port
on the drone.
Connect connector to power source.
ii Turn o the drone before charging.
Note: The USB charging cable will light up
while the battery is charging and will turn
o when the battery is fully charged.
Charge time is approximately 45 minutes.
Size: 888 x 210 mm (Folded: 148 x 210 mm) Accordion Fold
Black PMS 374U