Sharp HRO00163 Cellular Phone with Bluetooth, WLAN and Felica User Manual 08 CDMA SHI14 FCC statements
Sharp Corporation Cellular Phone with Bluetooth, WLAN and Felica 08 CDMA SHI14 FCC statements
Sharp >
Contents
FCC statements
Safety Information CE Declaration of Conformity In some countries/regions, such as France, there are restrictions on the use of WiFi®. If you intend to use Wi-Fi® on the handset abroad, check the local laws and regulations beforehand. Hereby, Sharp Telecommunications of Europe Ltd, declares that this IS14SH is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the original declaration of conformity can be found at the following Internet address: http://www.sharp.co.jp/k-tai/ ■Mobile Light Do not point the illuminated light directly at someone’s eyes. Do not use Mobile light near people’s faces. Eyesight may be temporarily affected leading to accidents. EN60825-1:1994 A1:2002 & A2:2001 CLASS1 LED Product Mobile light CAUTION: Use of controls, adjustments or performance of procedure other than those specified herein may result in hazardous radiation exposure. As the emission level from Mobile light LED used in this product is harmful to the eyes, do not attempt to disassemble the cabinet. Servicing is limited to qualified servicing station only. Mobile light source LED characteristics a) Continuous illumination b) Wavelength White: 400-700 nm c) Maximum output White: 1.03mW (inside cell phone 3.43 mW) ■AC Adapter Any AC adapter used with this handset must be suitably approved with a 5Vdc SELV output which meets limited power source requirements as specified in EN/IEC 60950-1 clause 2.5. ■Battery - CAUTION Use specified battery or Charger only. Non-specified equipment use may cause malfunctions, electric shock or fire due to battery leakage, overheating or bursting. Do not dispose of an exhausted battery with ordinary refuse; always tape over battery terminals before disposal. Take battery to an au Shop, or follow the local disposal regulations. Charge battery in ambient temperatures between 5°C and 35°C; outside this range, battery may leak/overheat and performance may deteriorate. 付 録 / 索 引 73 ■Loudness warning Excessive sound pressure from earphones and headphones can cause hearing loss. ■Headphone Signal Level The maximum output voltage for the music player function, measured in accordance with EN 50332-2, is 35 mV. ■European RF Exposure Information Your mobile device is a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves recommended by international guidelines. These guidelines were developed by the independent scientific organization ICNIRP and include safety margins designed to assure the protection of all persons, regardless of age and health. The guidelines use a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit for mobile devices is 2 W/kg and the highest SAR value for this device when tested at the ear was 0.08 W/kg※. As SAR is measured utilizing the devices highest transmitting power the actual SAR of this device while operating is typically below that indicated above. This is due to automatic changes to the power level of the device to ensure it only uses the minimum level required to reach the network. The World Health Organization has stated that present scientific information does not indicate the need for any special precautions for the use of mobile devices. They note that if you want to reduce your exposure then you can do so by limiting the length of calls or using a hands-free device to keep the mobile phone away from the head. 付 録 / 索 引 74 ※ The tests are carried out in accordance with international guidelines for testing. FCC Notice - This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. - Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment. ■Information to User This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation; if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient/relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/TV technician for help. ■FCC RF Exposure Information Your handset is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications & Internet Association (CTIA) Website at http://www.phonefacts.net. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless handsets employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. Highest SAR value: Model FCC ID At the Ear On the Body CDMA SHI14 APYHRO00163 0.450 W/kg 0.578 W/kg This device was tested for typical body-worn operations with the back of the handset kept 1.5 cm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 1.5 cm separation distance between the user's body and the back of the handset. The use of beltclips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. The FCC has granted an Equipment Authorization for this model handset with all reported SAR levels evaluated as in compliance with the FCC RF emission guidelines. SAR information on this model handset is on file with the FCC and can be found at http://www.fcc.gov/oet/fccid/ under the Display Grant section after searching on the corresponding FCC ID (see table above). 付 録 / 索 引 75
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Page Count : 3 XMP Toolkit : XMP toolkit 2.9.1-13, framework 1.6 About : 2d5af586-27db-11e1-0000-6544fbb288ae Producer : GPL Ghostscript 9.02 Keywords : () Modify Date : 2011:12:13 11:43:02+00:00 Create Date : 2011:12:13 11:43:02+00:00 Creator Tool : PDFCreator Version 1.2.2 Document ID : 2d5af586-27db-11e1-0000-6544fbb288ae Format : application/pdf Title : 08_CDMA SHI14 FCC statements.pdf Creator : twyna-to Description : () Author : twyna-to Subject :EXIF Metadata provided by EXIF.tools