Shure orporated P7TB In Ear Monitoring System User Manual

Shure Incorporated In Ear Monitoring System psm700 EN

a href="https://usermanual.wiki/Shure-orporated" itemprop="url"> Shure orporated >

Manual

English - 1! IMPORTANT SAFETY INSTRUCTIONS !1. READ these instructions.2. KEEP these instructions.3. HEED all warnings.4. FOLLOW all instructions.5. DO NOT use this apparatus near water.6. CLEAN ONLY with dry cloth.7. DO NOT block any ventilation openings. Install in accordance with the manu-facturer's instructions. 8. DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.9. DO NOT defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wider blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.10. PROTECT the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.11. ONLY USE attachments/accessories specified by the manufacturer.12.13. UNPLUG this apparatus during lightning storms or when unused for long periods of time.14. REFER all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is dam-aged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.15. DO NOT expose the apparatus to dripping and splashing. DO NOT put objects filled with liquids, such as vases, on the apparatus.This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit.This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit.WARNING!USING THIS SYSTEM AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE.USE AS LOW A VOLUME AS POSSIBLE.In order to use this system safely, avoid prolonged listening at excessive sound pressure levels. Please use the following guidelines established by the Occupational Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.90 dB SPL at 8 hours95 dB SPL at 4 hours100 dB SPL at 2 hours105 dB SPL at 1 hour110 dB SPL at ½ hour115 dB SPL at 15 minutes120 dB SPL — avoid or damage may occur It is difficult to measure the exact Sound Pressure Levels (SPL) present at the eardrum in live applications. In addition to the volume setting on the PSM, the SPL in the ear is affected by ambient sound from floor wedges or other devices. The isolation provided by the fit of quality earpieces is also an important factor in determining the SPL in the ear.Here are some general tips to follow in the use of this product to protect your ears from damage:• Turn up the volume control only far enough to hear properly.• Ringing in the ears may indicate that the gain levels are too high. Try lowering the gain levels.• Have your ears checked by an audiologist on a regular basis. If you experience wax buildup in your ears, stop using the system until an audiologist has examined your ears.• Wipe the ear molds with an antiseptic before and after use to avoid infections. Stop using the earphones if they are causing great discomfort or infection.USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
2 - EnglishQuickstartP7T Transmitter Setup1. Connect the transmitter to a power outlet using the supplied power cord.2. Attach the supplied antenna to the ANTENNA OUT BNC connector.3. Connect an audio source, such as a mixer, to the audio inputs of the transmitter. You can use both input jacks or choose either one for a mono source.NOTE: All inputs are phantom power protected up to 60 VDC.4. Set the PAD switch to either +4 dB or –10 dB depending on the signal level from the audio source.5. Turn on the transmitter.6. Set the SOURCE switch to MONO if you are using only one input. Otherwise set it to STEREO/MixMode.7. Set the GROUP switch UP to group 1.8. Set the CHANNEL dial to an unused channel.NOTE: See Selecting Channels.9. Power on the audio source and adjust the level control until the LEDs are in the –3 dB to +3 dB range.P7R Receiver Setup10. Attach the antenna to the ANTENNA connector. Use the red dot to align the threads. 11. Insert a 9V alkaline battery.12. Set the DIP switches (See Dip Switches)13. Set the channel to the same one as the transmitter.14. Set the balance control to the center detent position.15. Plug in the earphones and insert the earphones into your ears.16. Turn the receiver on by rotating the volume dial clockwise past the click. NOTE: If you do not hear anything, check the RF LED on the transmitter to makesure it is receiving the radio signal from the transmitter.1.2.3.5.4.6. 7.9. 8.10.11.12.13.14.15.16.Refer to the Troubleshooting section of this manual if you encounter any problems. LOWER THE VOLUME before troubleshooting the problem.
Download:
Mirror Download [FCC.gov]
Document ID340159
Application ID13nXBI6tef8SHxeYkQAUmg==
Document DescriptionManual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize105.95kB (1324401 bits)
Date Submitted2003-07-15 00:00:00
Date Available2003-07-15 00:00:00
Creation Date2002-12-02 12:34:30
Producing SoftwareAcrobat Distiller 5.0.5 (Windows)
Document Lastmod2003-07-07 09:31:11
Document Titlepsm700_EN.fm
Document CreatorFrameMaker 7.0
FCC ID Filing: DD4P7TB

Navigation menu