Spectralink RCC400 Standard Base Station User Manual Regulatory Guide

Spectralink Corporation Standard Base Station Regulatory Guide

UserManual.wiki >

Spectralink >

RCC400 User Manual >

Regulatory Guide HTML Version

1. Regulatory Guide
2. Installation Information

Regulatory Guide

REGULATORY INFORMATION

Link 6020 Wireless Telephone

Link WTS Base Stations

P/N: 72-1401-00-A

Link 6020 Wireless Telephones

Canada

(Safety)

CAN/CSA-C22-2

No. 60950-1

Canada Industry Canada RSS-210

IC: 2128B-602X

United States

UL 60950-1

United States

Part 15, IYG602X

1 TUV Rheinland of North America is a Nationally Recognized Testing Laboratory (NRTL) in the

United States and is accredited by the Standards Council of Canada to test and certify products

to Canadian National Standards. Clients can demonstrate compliance for both U.S. and Canadian

markets through a single mark (cTUVus) on their product(s) which denotes compliance to U.S. and

Canadian National Standards.

Model Registered Under

Link 6020 602X

Link Base Station RCC400

RCC410

RCO400

RCO410

RCH400

RHO400

International Certications Regulatory Model Number

Trademark Information

Information in this document is subject to change without notice and does not represent a

commitment on the part of SpectraLink Corporation.

SpectraLink®

Link

Are trademarks and registered trademarks of SpectraLink Corporation.

The SpectraLink logo is a registered trademark in the United States of America and in other

countries.

SpectraLink Corporation

5755 Central Avenue

Boulder, CO 80301

303 440 5330

800 676 5465

www.spectralink.com

Notes and Warnings

HAC—This equipment is Hearing Aid Compatible (HAC).

Handset Operation Normal Position—Hold the handset as you would any other tele-

phone, with the earpiece to your ear and speak into the microphone. The internal

antenna is then positioned properly.

Handset Operation Body-Worn Position—To maintain compliance with RF energy

exposure guidelines, if you wear a handset on your body when transmitting, always

use the handset with a SpectraLink-supplied accessory as described in the user guide

for this handset. SpectraLink supplies belt clips, holsters and lanyards for body-worn

operation. Use of accessories not supplied by SpectraLink may cause the handset

emissions to exceed RF energy exposure guidelines.

The user should not make changes or modications not expressly approved by Spec-

traLink. Any such changes could void the user’s authority to operate the equipment.

Warning—The earpiece/mouthpiece region on the handset can attract and retain

small objects.

•

Wireless Telephones

Link 6020: FCCID IYG602X

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

Base Stations

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

! SpectraLink recommends the use of shielded cable for all external signal

connections in order to maintain FCC Part 15 emissions requirements.

The FCC has granted an Equipment Authorization for this model phone with all reported

SAR levels evaluated as in compliance with the FCC RF emissions guidelines.

SAR information on this model phone is on le with the FCC and can be found under

the Display Grant section of http://www.fcc.gov/oet/fccid after searching on FCC ID

IYG602X.

Additional information on SAR can be found on the Cellular Telecommunications Industry

Association (CTIA) web-site at:

http://www.ctia.org.

The only authorized headsets that may be utilized with the the Link 6020 Wireless Tele-

phone are those obtainable from SpectraLink or its reseller partners.

The peak SAR values of the Link 6020 Wireless Telephone are:

Body (0.223 mW/g)

Head (0.463 mW/g)

SAR: Frequency range 902.4817 – 927.4826 MHz

Your Wireless Telephone is a low-power radio transmitter and receiver. When it is ON,

it receives and also sends out radio frequency (RF) signals. In August 1996, the Federal

Communications Commissions (FCC) adopted RF exposure guidelines with safety levels

for hand-held wireless telephones. Those guidelines are consistent with the safety standards

previously set by both U.S. and international standards bodies:

ANSI C95.1 (1992) American National Standards Institute

NCRP—Report 86 (1986) National Council on Radiation Protection and Measure-

ments

ICNIRP (1996) International Commission on Non-Ionizing Radiation Protection;

DHWC—Safety Code 6 Department of Health and Welfare Canada

Those standards were developed by independent scientic organizations through periodic

and thorough evaluation of scientic studies. The standards include a substantial safety mar-

gin designed to assure the safety of all persons, regardless of age and health. The exposure

standard for wireless mobile phones employs a unit of measurement known as the Specic

Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.2 Tests for SAR are

conducted using standard operating positions specied by the FCC with the telephone trans-

mitting at its highest certied power level in all tested frequency bands. Although the SAR is

determined at the highest certied power level, the actual SAR level of the telephone while

operating can be well below the maximum value. This is because the telephone is designed

to operate at multiple power levels so as to use only the power required to reach the network.

In general, the closer you are to a wireless Base Station antenna, the lower the power output.

Before a phone model is available for sale to the public, it must be tested and certied to the

FCC that it does not exceed the limit established by the government-adopted requirement

for safe exposure. The tests are performed in positions and locations (e.g., at the ear and

worn on the body) as required by the FCC for each model. While there may be differences

between the SAR levels of various telephones and at various positions, they all meet the

government requirement for safe exposure.

2 In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6

watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a substantial margin

of safety to give additional protection for the public and to account for any variations in measure-

ments.

•

FCC Information

Wireless Telephones

Link 602X

This device complies with RSS-210 of Industry Canada. Operation is subject to the follow-

ing two conditions: 1) this device may not cause interference, and 2) this device must accept

any interference, including interference that may cause undesired operation of the device.

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instruction manual, may cause harmful inter-

ference to radio communications. Operation of this equipment in a residential area is likely

to cause harmful interference in which case the user will be required to correct the interfer-

ence at his own expense. This Class A digital apparatus complies with Canadian ICES-003.

Certication Number IC: 2128B-602X