Spectralink RCC400 Standard Base Station User Manual Regulatory Guide

Spectralink Corporation Standard Base Station Regulatory Guide

Contents

Regulatory Guide

Download: Spectralink RCC400 Standard Base Station User Manual Regulatory Guide
Mirror Download [FCC.gov]Spectralink RCC400 Standard Base Station User Manual Regulatory Guide
Document ID775064
Application IDfy7wqHm2t/WrqunrMRY7cQ==
Document DescriptionRegulatory Guide
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize13.27kB (165865 bits)
Date Submitted2007-03-30 00:00:00
Date Available2007-03-30 00:00:00
Creation Date2007-03-20 10:27:49
Producing SoftwareAdobe PDF Library 7.0
Document Lastmod2007-03-20 15:46:20
Document TitleRegulatory Guide
Document CreatorAdobe InDesign CS2 (4.0.4)

Regulatory Model Number
International Certifications
Link 6020 Wireless Telephones
Canada
(Safety)
CAN/CSA-C22-2
No. 60950-1
Canada
Industry Canada RSS-210
IC: 2128B-602X
Model
Registered Under
Link 6020
602X
Link Base Station
RCC400
RCC410
RCO400
RCO410
RCH400
RHO400
Trademark Information
United States
Notes and Warnings
UL 60950-1
United States
Part 15, IYG602X
TUV Rheinland of North America is a Nationally Recognized Testing Laboratory (NRTL) in the
United States and is accredited by the Standards Council of Canada to test and certify products
to Canadian National Standards. Clients can demonstrate compliance for both U.S. and Canadian
markets through a single mark (cTUVus) on their product(s) which denotes compliance to U.S. and
Canadian National Standards.
Information in this document is subject to change without notice and does not represent a
commitment on the part of SpectraLink Corporation.
SpectraLink®
•
HAC—This equipment is Hearing Aid Compatible (HAC).
Link
•
Handset Operation Normal Position—Hold the handset as you would any other telephone, with the earpiece to your ear and speak into the microphone. The internal
antenna is then positioned properly.
Are trademarks and registered trademarks of SpectraLink Corporation.
•
Handset Operation Body-Worn Position—To maintain compliance with RF energy
exposure guidelines, if you wear a handset on your body when transmitting, always
use the handset with a SpectraLink-supplied accessory as described in the user guide
for this handset. SpectraLink supplies belt clips, holsters and lanyards for body-worn
operation. Use of accessories not supplied by SpectraLink may cause the handset
emissions to exceed RF energy exposure guidelines.
•
The user should not make changes or modifications not expressly approved by SpectraLink. Any such changes could void the user’s authority to operate the equipment.
•
Warning—The earpiece/mouthpiece region on the handset can attract and retain
small objects.
REGULATORY INFORMATION
The SpectraLink logo is a registered trademark in the United States of America and in other
countries.
SpectraLink Corporation
5755 Central Avenue
Boulder, CO 80301
303 440 5330
800 676 5465
www.spectralink.com
Link 6020 Wireless Telephone
Link WTS Base Stations
P/N: 72-1401-00-A
FCC Information
Industry Canada (IC) Notice
Wireless Telephones
Wireless Telephones
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1) this device may not cause interference, and 2) this device must accept
any interference, including interference that may cause undesired operation of the device.
Link 6020: FCCID IYG602X
Base Stations
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
! SpectraLink recommends the use of shielded cable for all external signal
connections in order to maintain FCC Part 15 emissions requirements.
Link 602X
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference at his own expense. This Class A digital apparatus complies with Canadian ICES-003.
Certification Number IC: 2128B-602X
Base Stations
RCC400
RCC410
RCO400
RCO410
RCH400
RHO400
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1) This device may not cause interference, and 2) this device must accept
any interference, including interference that may cause undesired operation of the device.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference at his own expense. This Class A digital apparatus complies with Canadian ICES-003.
Certification Number IC: 2128 101 416A
Specific Absorption Rate (SAR) Information
Your Wireless Telephone is a low-power radio transmitter and receiver. When it is ON,
it receives and also sends out radio frequency (RF) signals. In August 1996, the Federal
Communications Commissions (FCC) adopted RF exposure guidelines with safety levels
for hand-held wireless telephones. Those guidelines are consistent with the safety standards
previously set by both U.S. and international standards bodies:
• ANSI C95.1 (1992) American National Standards Institute
• NCRP—Report 86 (1986) National Council on Radiation Protection and Measurements
• ICNIRP (1996) International Commission on Non-Ionizing Radiation Protection;
• DHWC—Safety Code 6 Department of Health and Welfare Canada
Those standards were developed by independent scientific organizations through periodic
and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure
standard for wireless mobile phones employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. Tests for SAR are
conducted using standard operating positions specified by the FCC with the telephone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual SAR level of the telephone while
operating can be well below the maximum value. This is because the telephone is designed
to operate at multiple power levels so as to use only the power required to reach the network.
In general, the closer you are to a wireless Base Station antenna, the lower the power output.
Before a phone model is available for sale to the public, it must be tested and certified to the
FCC that it does not exceed the limit established by the government-adopted requirement
for safe exposure. The tests are performed in positions and locations (e.g., at the ear and
worn on the body) as required by the FCC for each model. While there may be differences
between the SAR levels of various telephones and at various positions, they all meet the
government requirement for safe exposure.
 In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6
watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a substantial margin
of safety to give additional protection for the public and to account for any variations in measurements.
The FCC has granted an Equipment Authorization for this model phone with all reported
SAR levels evaluated as in compliance with the FCC RF emissions guidelines.
SAR information on this model phone is on file with the FCC and can be found under
the Display Grant section of http://www.fcc.gov/oet/fccid after searching on FCC ID
IYG602X.
Additional information on SAR can be found on the Cellular Telecommunications Industry
Association (CTIA) web-site at:
http://www.ctia.org.
The only authorized headsets that may be utilized with the the Link 6020 Wireless Telephone are those obtainable from SpectraLink or its reseller partners.
The peak SAR values of the Link 6020 Wireless Telephone are:
Body (0.223 mW/g)
Head (0.463 mW/g)
SAR: Frequency range 902.4817 – 927.4826 MHz

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Page Count                      : 2
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:0671de6f-4db9-4506-8200-ed3be258a247
Producer                        : Adobe PDF Library 7.0
Trapped                         : False
Create Date                     : 2007:03:20 10:27:49-06:00
Modify Date                     : 2007:03:20 15:46:20-06:00
Metadata Date                   : 2007:03:20 15:46:20-06:00
Creator Tool                    : Adobe InDesign CS2 (4.0.4)
Thumbnail Format                : JPEG
Thumbnail Width                 : 256
Thumbnail Height                : 256
Thumbnail Image                 : (Binary data 4567 bytes, use -b option to extract)
Instance ID                     : uuid:eb0d6370-b001-495c-ab56-7ac80ce95486
Rendition Class                 : proof:pdf
Document ID                     : adobe:docid:indd:2e807733-53fe-11db-861d-8aebae5bdd46
Derived From Instance ID        : 455ef8e5-53e4-11db-9718-ea9235663088
Derived From Document ID        : adobe:docid:indd:ae4c848f-49a3-11db-8c27-bf5653c25e48
Format                          : application/pdf
Creator                         : Adobe InDesign CS2 (4.0.4)
EXIF Metadata provided by EXIF.tools
FCC ID Filing: IYGRCC400

Navigation menu