The Gem Group 3260B Bluetooth Earphone User Manual

The Gem Group, Inc. Bluetooth Earphone

user manual

Download: The Gem Group 3260B Bluetooth Earphone User Manual
Mirror Download [FCC.gov]The Gem Group 3260B Bluetooth Earphone User Manual
Document ID3246196
Application ID+KRyjYUNfo0YI+9LZa3swQ==
Document Descriptionuser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize78.04kB (975442 bits)
Date Submitted2017-01-04 00:00:00
Date Available2017-01-04 00:00:00
Creation Date2016-11-08 11:48:29
Producing SoftwareAdobe PDF library 9.90
Document Lastmod2016-12-29 16:54:18
Document Title#3260_Spectrum Bluetooth® Earbuds Instruction Manual - PDF
Document CreatorAdobe Illustrator CS5.1

FCCID: 2AGR43260B
BLUETOOTH OPERATION
Overview
SPECIFICATION
Bluetooth Specifications:Bluetooth® version 4.1
Support profile: A2DP
Transmission distance: up to 2 m (This may vary based on
environmental factors or the type of Bluetooth® device being
used)
Built-in battery: 55 mAh Lithium battery
USB Recharge voltage: DC 5V/500mA
Output power: 16mW
Frequency Response: 20Hz - 20KHz
Transmission Response: 2.4GHz - 2.48 GHz
Spectrum Bluetooth® Earbuds
Vol + / Previous
PACKING
• Bluetooth® Earbuds
• Silicone Earbud Covers
• USB Charging Cable
• Travel Case and Carabiner
• User Manual
Back Cover
BUTTON CONTROL
• Pause / Play: Press the On/Off button once to pause the music,
press again to play.
• On / Off: Press and hold the On/Off button to control the power
of the earbuds.
• Vol + / Previous: Press and hold the + button for 2 seconds for
the previous track. Press once to increase the volume.
• Vol - / Next: Press and hold the – button for 2 seconds for the
next track. Press once to reduce the volume.
• Hands-free: Press On/Off button once to answer an incoming
call. While on a call, press On/Off once to end the call.
• Redial last call: Press On/Off button twice to redial last number
dialed on the connected mobile device.
CHARGING THE EARBUDS
1. When the battery is low, please charge via the included USB
cable. The charging time is approximately 1-1.5 hours and
provides up to 2 hours of continuous operation. Standby
time is approximately 60 hours.
2. The LED indicator light will be red during charging and will
turn blue once it is fully charged.
page 04
Microphone
Recharging Port
On/ Off
Pause / replay
Answer / Hang up
WARNING
1. Do not disassemble, repair, or modify the earbuds.
2. Do not place product in or near fire to avoid danger, as it
uses a lithium battery.
3. Avoid storage at extreme temperatures, this can shorten the
battery life and may affect the earbuds.
4. Keep the earbuds dry and do not store the earbuds in damp
areas to avoid damage to the earbuds.
5. Avoid dropping the earbuds as it may damage the product.
KIND REMINDER
1. To prolong the earbuds life span and to avoid hearing
damage, please do not listen to music under high volume
for long periods of time.
2. When an error occurs with the earbuds, please turn off the
earbuds and restart it to troubleshoot.
3. When the earbuds power is low, the Bluetooth range may
be affected. Please charge the earbuds to avoid
disruptions during use.
page 05
1. Please ensure that the Bluetooth function has been turned
on in the settings of your Bluetooth enabled device.
2. Turn the earbuds on by pressing the power button for 4
seconds. The indicator light will flash to detect Bluetooth
enabled devices near you and will enter pairing mode.
When pairing, remain within 3 feet of the earbuds. The
indicator light will go off if no Bluetooth devices are detected
within 5 minutes.
3. “GEMLINE EB” will appear on the Bluetooth device list,
select “GEMLINE EB” to establish pairing. If instructed to
enter a PIN code, please enter ‘0000’.
4. Once the earbuds have been paired to the desired mobile
device, the indicator light will turn blue to confirm successful
pairing.
5. When you want to play audio from another Bluetooth device,
disconnect the earbuds from the original device and follow
steps 1-3 to re-pair the earbuds with a new Bluetooth
enabled device.
Vol - / Next
User Manual
Front Cover
page 02
Unable to pair the
earbuds with a
mobile device
IC ID: 21530-3260B
1. Inspect whether the earbuds is searching
for a Bluetooth enabled device to connect
to. If not, restart the earbuds.
2. Difficulty in searching and connecting to
a desired device can be affected if multiple
devices are equipped, turned on, and in
range for Bluetooth connectivity. Please
turn off or disable the Bluetooth function on
the other devices.
3. The power of the battery is insufficient,
please recharge the earbuds.
page 03
The sound is low
or distorted
1. Inspect the volume of the connected
earbuds or Bluetooth enabled device and
adjust the volume as needed.
2. The power of the battery is insufficient,
please recharge the earbuds.
The Bluetooth
indicator light
remains OFF
1. The power of the battery is insufficient,
please recharge the earbuds.
2. Restart the earbuds.
1. Inspect the distance between the earbuds
and the Bluetooth enabled device, it may
exceed the Bluetooth transmission range.
2. Inspect if there is an obstacle between
the earbuds and the Bluetooth enabled
device.
3. The power of the battery is insufficient,
please recharge the earbuds.
page 06
page 07
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables auxappareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre lefonctionnement.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
XMP Toolkit                     : 3.1-701
Format                          : application/pdf
Title                           : #3260_Spectrum Bluetooth® Earbuds Instruction Manual - PDF
Creator Tool                    : Adobe Illustrator CS5.1
Create Date                     : 2016:11:08 11:48:29-04:00
Modify Date                     : 2016:12:29 16:54:18+08:00
Metadata Date                   : 2016:12:29 16:54:18+08:00
Thumbnail Width                 : 256
Thumbnail Height                : 136
Thumbnail Format                : JPEG
Thumbnail Image                 : (Binary data 13442 bytes, use -b option to extract)
Document ID                     : xmp.did:81DBF52AD3A5E611AC98C8CFCE56A158
Instance ID                     : uuid:c8bc12f6-6aab-47c2-8b7c-bc07923e5334
Rendition Class                 : proof:pdf
Original Document ID            : uuid:89729B405116E611A80FDE1394D5DE7B
Derived From Instance ID        : uuid:0c8d909a-2414-4546-b670-ae5410bffa61
Derived From Document ID        : xmp.did:F48FCC877D87E6119E619391DEBBEDE0
Derived From Original Document ID: uuid:89729B405116E611A80FDE1394D5DE7B
Derived From Rendition Class    : proof:pdf
History Action                  : saved, saved, saved
History Instance ID             : xmp.iid:329D06FF8683E611B7BF87D5EC63B189, xmp.iid:F48FCC877D87E6119E619391DEBBEDE0, xmp.iid:81DBF52AD3A5E611AC98C8CFCE56A158
History When                    : 2016:09:26 10:13:21+08:00, 2016:10:01 10:40:48+08:00, 2016:11:08 11:48:25-05:00
History Software Agent          : Adobe Illustrator CS5, Adobe Illustrator CS5, Adobe Illustrator CS5.1
History Changed                 : /, /, /
N Pages                         : 1
Has Visible Transparency        : False
Has Visible Overprint           : False
Max Page Size W                 : 16.000000
Max Page Size H                 : 11.000000
Max Page Size Unit              : Inches
Font Name                       : ArialMT, Calibri, Arial-BoldMT, AdobeSongStd-Light, TimesNewRomanPSMT
Font Family                     : Arial, Calibri, Arial, Adobe 宋体 Std, Times New Roman
Font Face                       : Regular, Regular, Bold, L, Regular
Font Type                       : Open Type, Open Type, Open Type, Open Type, Open Type
Font Version                    : Version 5.21, Version 5.74, Version 5.21, Version 5.010;PS 5.002;hotconv 1.0.57;makeotf.lib2.0.21895, Version 5.21
Font Composite                  : False, False, False, False, False
Font File Name                  : arial.ttf, CALIBRI.TTF, arialbd.ttf, AdobeSongStd-Light.otf, times.ttf
Plate Names                     : Black
Swatch Groups Group Name        : Default Swatch Group
Swatch Groups Group Type        : 0
Swatch Groups Colorants Tint    : 100.000000
Swatch Groups Colorants Swatch Name: New Color Swatch 1
Swatch Groups Colorants Mode    : CMYK
Swatch Groups Colorants Type    : PROCESS
Swatch Groups Colorants Cyan    : 0.000000
Swatch Groups Colorants Magenta : 100.000000
Swatch Groups Colorants Yellow  : 0.000000
Swatch Groups Colorants Black   : 0.000000
Producer                        : Adobe PDF library 9.90
Page Count                      : 3
Creator                         : Adobe Illustrator(R) 15.0
For                             : Jessica Rousseau,
Bounding Box                    : 82 255 1070 782
Container Version               : 11
Creator Version                 : 15
Image Height                    : 527
Image Width                     : 988
Image Size                      : 988x527
Megapixels                      : 0.521
EXIF Metadata provided by EXIF.tools
FCC ID Filing: 2AGR43260B

Navigation menu