Tyco Safety Canada 119057 Wireless Security System User Manual

Digital Security Controls Ltd. Wireless Security System 29007827R001 SCW9055 57 1 0 UM ENG

a href="https://usermanual.wiki/Tyco-Safety-Canada" itemprop="url"> Tyco Safety Canada >

user manual

Self Contained Wireless Alarm System SCW9055/SCW9057 v1.0 User ManualWARNING: This manual contains information on limitations regarding product use andfunction and information on the limitations as to liability of the manufacturer. The entire manual should be carefully read.DRAFT
FCC COMPLIANCE STATEMENTCAUTION: Changes or modifications not expressly approved by Digit-al Security Controls could void your authority to use this equipment.This equipment has been tested and found to comply with the limits for a ClassB digital device, pursuant to Part 15 of the FCC Rules. These limits are designedto provide reasonable protection against harmful interference in a residential in-stallation. This equipment generates, uses and can radiate radio frequency ener-gy and, if not installed and used in accordance with the instructions, may causeharmful interference to radio communications. However, there is no guaranteethat interference will not occur in a particular installation. If this equipment doescause harmful interference to radio or television reception, which can be deter-mined by turning the equipment off and on, the user is encouraged to try to cor-rect the interference by one or more of the following measures:• Re-orient the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.• Consult a dealer or experienced radio/television technician for help.The user may find the following booklet prepared by the FCC useful: "How toIdentify and Resolve Radio/Television Interference Problems". This booklet isavailable from the U.S. Government Printing Office, Washington D.C. 20402,Stock # 004-000-00345-4.IMPORTANT INFORMATIONThis equipment complies with Part 68 of the FCC Rules and, if the product wasapproved July 23, 2001 or later, the requirements adopted by the ACTA. On thetop side of this equipment is a label that contains, among other information, aproduct identifier. If requested, this number must be provided to the TelephoneCompany. Product Identifier: US:F53AL01B9057 USOC Jack: RJ-31XTelephone Connection Requirements A plug and jack used to connect this equipment to the premises wiring and tele-phone network must comply with the applicable FCC Part 68 rules and require-ments adopted by the ACTA. A compliant telephone cord and modular plug isprovided with this product. It is designed to be connected to a compatible mod-ular jack that is also compliant. See installation instructions for details.Ringer Equivalence Number (REN)The REN is used to determine the number of devices that may be connected toa telephone line. Excessive RENs on a telephone line may result in the devicesnot ringing in response to an incoming call. In most but not all areas, the sum ofRENs should not exceed five (5.0). To be certain of the number of devices thatmay be connected to a line, as determined by the total RENs, contact the localTelephone Company. For products approved after July 23, 2001, the REN forthis product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a deci-mal point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separatelyshown on the label. REN = 0.1BIncidence of HarmIf this equipment (SCW9055/SCW9057) causes harm to the telephone network,the telephone company will notify you in advance that temporary discontinuanceof service may be required. But if advance notice is not practical, the TelephoneCompany will notify the customer as soon as possible. Also, you will be advisedof your right to file a complaint with the FCC if you believe it is necessary.Changes in Telephone Company Equipment or FacilitiesThe Telephone Company may make changes in its facilities, equipment, opera-tions or procedures that could affect the operation of the equipment. If this hap-pens the Telephone Company will provide advance notice in order for you tomake necessary modifications to maintain uninterrupted service.Equipment Maintenance FacilityIf trouble is experienced with this equipment (SCW9055/SCW9057) for repairor warranty information, contact the facility indicated below. If the equipment iscausing harm to the telephone network, the Telephone Company may requestthat you disconnect the equipment until the problem is solved. This equipmentis of a type that is not intended to be repaired by the end user.DSC c/o APL Logistics 757 Douglas Hill Rd., Lithia Springs, GA 30122Additional InformationConnection to party line service is subject to state tariffs. Contact the state publicutility commission, public service commission or corporation commission forinformation.Alarm dialling equipment must be able to seize the telephone line and place acall in an emergency situation. It must be able to do this even if other equipment(telephone, answering system, computer modem, etc.) already has the telephoneline in use. To do so, alarm dialling equipment must be connected to a properlyinstalled RJ-31X jack that is electrically in series with and ahead of all otherequipment attached to the same telephone line. Proper installation is depicted inthe figure below. If you have any questions concerning these instructions, youshould consult your telephone company or a qualified installer about installingthe RJ-31X jack and alarm dialling equipment for you.INDUSTRY CANADA STATEMENTNOTICE: This product meets the applicable Industry Canada technical spec-ifications.Le présent materiel est conforme aux specifications techniques applicables d’In-dustrie Canada.The Ringer Equivalence Number (REN) for this terminal equipment is 0.1.L'indice d'équivalence de la sonnerie (IES) du présent matériel est de 0.1.The Ringer Equivalence Number is an indication of the maximum number of de-vices allowed to be connected to a telephone interface. The termination on an in-terface may consist of any combination of devices subject only to the requirementthat the sum of the RENs of all the devices does not exceed five.L’indice d’équivalence de la sonnerie(IES) sert à indiquer le nombre maximal de terminaux qui peuvent être raccordésà une interface téléphonique. La terminaison d’une interface peut consister en unecombinaison quelconque de dispositifs, à la seule condition que la somme d’in-dices d’équivalence de la sonnerie de tous les dispositifs n’excède pas 5.The term ’IC:’ before the radio certification number only signifies that IndustryCanada technical specifications were met.Certification Number IC: 160A-9057 (models SCW9055-433/SCW9057-433)Certification Number IC: 160A-9057G (models SCW9055(D)(G)(SM)-433/SCW9057(D)(G)(SM)-433)This Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe B est conforme à la norme NMB-003 duCanada.The SCW9055(X)-433 and SCW9057(X)-433 have been investigated by UL and ULC and found in compliance with the listing requirements for Residential Fire and Burglary applications in accordance with the following standards: UL985, UL1023, UL1635, ULC-S545 and ORD-C1023.This publication covers the following models:TelephoneComputerTelephoneTelephoneFax MachineAlarm DialingEquipmentRJ-31XJack UnusedRJ-11 JackTelephoneLineNetworkServiceProvider'sFacilitiesCustomer Premises Equipment and WiringUnusedRJ-11 JackNetworkDemarcationPoint AnsweringSystem• SCW9055-433/868 • SCW9055G-433/868 • SCW9055G-SM-433/868 • WT4901• SCW9057-433/868 • SCW9057G-433/868 • SCW9057G-SM-433/868 • WT8901• SCW9055D-433/868 • SCW9055D-SM-433/868 • WT5500-433/868 • WT4911• SCW9057D-433/868 • SCW9057D-SM-433/868 • WT5500P-433/868 • WT8911• SCW9055I-433/868 • SCW9055I-SM-433/868 • WT4989 • PT4• SCW9057I-433/868 • SCW9057I-SM-433/868 • WT8989 • PT8NOTE: The 868 MHz models are not UL/ULC listed.NOTE: Only these models shall be used with UL/ULC listed systems: SCW9055-433, SCW9057-433,SCW9055G-433, SCW9057G-433, WT5500-433, WT5500P-433, WT4901, WT4911, WT4989 andPT4. Only certain models of SCW9055/57 include the SMS features, check with your installer.DRAFTThis device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Le fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne peut pas provoquer d'interférences et (2) cet appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement de l' appareil.
Download:
Mirror Download [FCC.gov]
Document ID1509567
Application IDnJlNx8ZlqYre7fxoFA28Kg==
Document Descriptionuser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize265.8kB (3322440 bits)
Date Submitted2011-07-26 00:00:00
Date Available2011-07-27 00:00:00
Creation Date2011-06-13 09:26:52
Producing SoftwareAcrobat Distiller 9.4.2 (Windows)
Document Lastmod2011-06-28 21:28:57
Document Title29007827R001_SCW9055-57_1.0_UM_ENG.fm
Document CreatorPScript5.dll Version 5.2.2
Document Author: tvecchiarelli
FCC ID Filing: F53119057

Navigation menu