Weccan WECCANDRONE 2.4G control RC quadcopter/helicopter User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2698265
Application ID	XSeBy9sOVmrQj7JnKVX2Ng==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	108.69kB (1358660 bits)
Date Submitted	2015-07-30 00:00:00
Date Available	2015-07-30 00:00:00
Creation Date	2015-07-29 18:14:18
Producing Software	Adobe PDF library 10.01
Document Lastmod	2015-07-29 19:21:59
Document Title	SG-F88（DAS）可编辑英文说明书-过验证-20150729
Document Creator	Adobe Illustrator CS6 (Windows)

1. FOREWARD
14 +
Please read manual before flight.
AGES
IMPORTANT NOTES
SKY FURY
SG-F88
MANUAL
Contents
FOREWORD
PRECAUTIONS
STANDARD ACCESSORIES
PARTS OF AIRCRAFT
PARTS OF CONTROLLER
CONTROLLER BATTERY INSTALLATION
BATTERY AND CHARGING AIRCRAFT
BATTERY A
BINDING OF RADIO TRANSMITTER AND RECEIVER
10
FLIGHT ADJUSTMENT AND SETTING
11
RULE OUT TROUBLEDURING FLIGHT
12
PARTS LIST
The product is a sophisticated hobby product but not a toy. Although small, it still poses certain risk factors that
should not be over looked. Please follow safety and operation recommendations to ensure correct operation of this
drone. The use of this drone beyond it’s intended purchases and disassembly may cause unforeseen danger and
should be avoided.
The manufacturer and dealer assume no liability for accidental damages by abnormal wear of parts improper
assembly, or operation in unsafe manners. This product is intended for use by age 14 years or older. Please
ensure the product is operated under a safe environment.
We recommend that you seek the assistance of an experienced pilot before attempting to fly our products for the
first time. A local expert is the best way to properly assemble, setup, and fly your model for the first time. This
drone requires a certain degree of skill to operate, and is an item subject to normal wear and tear. Any damage or
dissatisfaction as a result of accidents or modifications are not covered by warranty and cannot be returned for
repair or replacement.
2. PRECAUTIONS
CAUTION
Fly only in safe areas away from other people. Do not operate stunt aircraft within the vicinity of crowds. Stunt
aircrafts are prone to accidents, failures, and the operator is responsible for any and all damage occurred by this
aircraft.
CAUTION
INDOOR AND OUTDOOR USE
3. STAANDAR ACCESSORIES
While this aircraft is specially designed for indoor and outdoor use, operator MUST keep
away from obstacles of any kind at all time.
CAUTION
PREVENT MOISTURE
This aircraft is comprised of a number if sophisticated electronic components; user must
absolutely prevent aircraft from coming into contact with water/moisture of any kind.
CAUTION
PROPER OPERATION
4. PRATS OF AIRCRAFT
To insure safety and proper function the user must not remove or modify the aircraft in any
form. Should a repair be needed the user should only utilize the original spare parts that
came with the aircraft at time of purchase.
Shell
CAUTION
SAFETY NOT FOR NI-MH BATTERIES
Make sure the batteries are installed based on polarity indicated in the case and do not
mix batteries of different chemistry/spec. Please take out the batteries if you are not going
to use for a long time to avoid potential leakage which may damage the transmitter.
Please dispose depleted batteries according to local laws and ordinances. Do not dispose
improperly.
CAUTION
Styrofoam Shell
Holder
SAFETY NOTE ON LI-PO BATTERIES
Polymer batteries poses higher operational risks compared to other battery chemistry,
thus it is imperative to follow its usage instructions. Manufacturer and dealer assume no
liability for accidental damages caused by improper usage.
Receiver
board
Blade B
Blade A
CAUTION
KEEP AWAY FROM HEAT
R/C models are made of various forms or plastic. Plastics are very susceptible to damage
or deformation due to extreme heat and cold climate. Make sure not to store the model
near any source of heat such as an oven, or heater. It is best to store the model indoors,
in a climate-controlled, room temperature environment.
Blade D
Blade C
Carbon fiber
Motor block
5. PARTS OF CONTROLLER
7. BATTERY AND CHARGING AIRCRAFT
①
Do not disassemble
USB
Single Eversion
Polymer Battery
3.7v 650mAh
Speed slow
30%/Quick 60%/Fast 100%
Throttle Trim
Pitch forward/reverse Trim
Throttle left/right
Rotation Trim
Directional control trick
forward/reverse left/right
Charge the aircraft with the charger that is included with the unit. Unplug battery to aircraft cord, and plug battery to
USB cord into computer. Full charge in roughly 60-70minutes.
WARNING
Left/right Rotation Trim
Left/Right roll trim
For safety concerns, battery charging must be done under supervision at all times.
CAUTION
Power switch
LED Indicator LED
6. CONTROLLER BATTRY INSTALLATION
Step 1
Step 2
Battery lid
Charger Specifications
Red light
Red light out
Input
Unit charged
Charging
110-240V
Charging Current
Full Voltage
600mAn
4.25±0.3V
② A.The aircraft battery is shipped from the manufacturer with a protective insulator; remove the
insulator before use.
B.The aircraft battery is not replaceable.
8. BATTERY A
Battery specification
Usage duration
Chagr time
Polymer battery
3.7V 650mAh
Aircraft flight time 6-8mins
60-70mins
Carbon-Zinc
(Non Rechargeable)
1.5V
(GP 15G R6P)
Thansmitter operation time 18 hours
Non rechargeable
ed
lud
t in
Battery type
No
Open battery cover
WARNING
Use 6 AA sized batteries, install based
on polarity indicated. Do not mix
batteries of different chemistry/spec.
CAUTION RISK OF EXPLOSION IF BATTERY
IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO THE LAW.
Do not mix old and new batteries.
Ne pas mélanger les piles usées avec des neuves.
Do not mix alkaline, standard (carbon zinc)
or rechargeable (nickel cadmium) batteries.
Ne pas mélanger les piles alcalines, les piles standard
(au carbone-zinc) ni les piles rechargeables
(au nickel-cadmium).
9. BINDING OF RADIO TRANSMITTER AND RECEIVER
Step 1
10. FLIGHT ADJUSTMENT AND SETTING
PLEASE PRACTICE SIMULATION FLIGHT BEFORE ACTUAL FLIGHT
Place the aircraft in a flat position. Connect the
batteries per the attached diagram; connect the
red light will illuminate.
Polymer Battery
3.7V 650mAh
Step 2
Turn the remote controller on and set the throttle
stick to the lowest power position on the remote
controller.
Set throttle stick
to lowest point
Mode
Aileron
Illustration
Move left
ON/OFF
Mode
Throttle
Move right
Step 3
Illustration
Ascent
Descent
Rudder
Elevator
Turn left
At end of use, unplug the power cord.
Turn right
Fly forward
Step 4
Turn off the remote controller.
ON/OFF
Fly backward
11. RULE OUT TROUBLE DURING FLIGHT
Situation
The receiver light keeps flashing
The aircraft has no reaction
Motor does not respond to throttle stick,
receiver LED flashes.
Main rotor spins but unable to takeoff.
Cause
Unable to bind to transmitter
1.Lost poer to transmiter and receiver
vehicle battery is inserted properly.
2.Check transmitter and receiver voltage.
3. Poor contact on battery terminals.
contact between battery contacts.
The aircraft battery is not fully charged.
1.Deformed main bladed.
2.Flight vehicle battery depleted.
charged battery.
3. Aircraft detects unit is not in a
horizontal position.
Strong vibration of slight vehicle
1.Deformed main blades.
Tail still off trim after tab adjustment,
or inconsistent speed during left/right
pirouette.
1. Danaged tail rotors
2.Danaged tail drive motor
3.Aircraft detects unit is not in a
horizontal position.
12. PARTS LIST
Solue
Repeat the power on initializing process.
1.Turn on transmulter and ensure flight
2. Use fully charged batteries.
3.Reset the battery and ensure good
Fully charge the battery, or replace
with a fully charged battery.
1.Replace main blades.
2. Charge or replace with fully
3. Place in a flat position and reboot.
1. Replace main blades
1.Replace main blades
2. Replace the main motor
3. Place in a flat position and reboot.
Name
No
Quantity
Styrofoam Shell
Receiver board
Frame
Battery
Blade A
Blade B
Motor Blok
Tube
Motor
10
Motor cover
11
Carbon fiber
12
Motor pinion gear
13
Copper Gear
14
Copper set
15
LED Light
16
Holder
17
Shell
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Create Date                     : 2015:07:29 18:14:18+09:00
Creator                         : Adobe Illustrator CS6 (Windows)
Modify Date                     : 2015:07:29 19:21:59+08:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Format                          : application/pdf
Title                           : SG-F88（DAS）可编辑英文说明书-过验证-20150729
Metadata Date                   : 2015:07:29 19:21:59+08:00
Creator Tool                    : Adobe Illustrator CS6 (Windows)
Thumbnail Width                 : 60
Thumbnail Height                : 256
Thumbnail Format                : JPEG
Thumbnail Image                 : (Binary data 7522 bytes, use -b option to extract)
Instance ID                     : uuid:a9838844-d37e-4c08-80cb-18dcc8c2328a
Document ID                     : xmp.did:65F286E7D935E51198CAF907E5498248
Original Document ID            : uuid:5D20892493BFDB11914A8590D31508C8
Rendition Class                 : proof:pdf
Derived From Instance ID        : uuid:0c3c5a5f-36cf-45f6-a89f-e492a18cb6ac
Derived From Document ID        : xmp.did:BADFFAAFBE35E5119D03DF559844B03E
Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8
Derived From Rendition Class    : proof:pdf
History Action                  : saved, saved
History Instance ID             : xmp.iid:3637CBC394A1E21193ACDA81AA04FDD1, xmp.iid:65F286E7D935E51198CAF907E5498248
History When                    : 2013:04:10 12:11:48+08:00, 2015:07:29 18:14:09+08:00
History Software Agent          : Adobe Illustrator CS5, Adobe Illustrator CS6 (Windows)
History Changed                 : /, /
Startup Profile                 : Print
Has Visible Overprint           : True
Has Visible Transparency        : True
N Pages                         : 1
Max Page Size W                 : 285.000347
Max Page Size H                 : 210.000274
Max Page Size Unit              : Millimeters
Font Name                       : 809-CAI978, ArialMT, Arial-BoldMT, MicrogrammaD-BoldExte, AdobeSongStd-Light
Font Family                     : 809-CAI978, Arial, Arial, MicrogrammaDBolExt, Adobe 宋体 Std
Font Face                       : Regular, Regular, Bold, Regular, L
Font Type                       : TrueType, Open Type, Open Type, TrueType, Open Type
Font Version                    : Version 001.005 April 12, 1994, Version 5.06, Version 5.06, Version 001.005, Version 5.017;PS 5.002;hotconv 1.0.67;makeotf.lib2.5.33168
Font Composite                  : False, False, False, False, False
Font File Name                  : 809-CAI978.ttf, arial.ttf, arialbd.ttf, MICROGBE.TTF, AdobeSongStd-Light.otf
Plate Names                     : Black
Swatch Groups Group Name        : 默认色板组
Swatch Groups Group Type        : 0
Swatch Groups Colorants L       : 67.059998
Swatch Groups Colorants A       : 56
Swatch Groups Colorants B       : 91
Swatch Groups Colorants Swatch Name: [套版色] 2
Swatch Groups Colorants Type    : PROCESS
Swatch Groups Colorants Tint    : 100.000000
Swatch Groups Colorants Mode    : CMYK
Swatch Groups Colorants Cyan    : 92.971700
Swatch Groups Colorants Magenta : 87.972802
Swatch Groups Colorants Yellow  : 89.019603
Swatch Groups Colorants Black   : 79.998499
Producer                        : Adobe PDF library 10.01
Page Count                      : 6

EXIF Metadata provided by EXIF.tools