ecom instruments 300011GR03 RFID Reader User Manual Annex
ecom instruments GmbH RFID Reader Annex
Contents
- 1. user manual Annex
- 2. user manual
user manual Annex
Communication
Mobile Computing
Portable Lighting
Measurement & Calibration
FCC Compliance Statement
for RFID-Reader Model No.TLB 30, LID, UNI 13
This Statement is part of the User Manual
Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for
future reference
Users of this product are cautioned to use accessories and peripherals approved by ecom instruments GmbH. The use of
accessories other than those recommended, or changes to this product that are not approved by ecom instruments GmbH,
may void the compliance of this product and may result in the loss of the user’s authority to operate the equipment.
Laser Compliance and Precaution
The SN-SE955 is registered with the CDRH as a Class II Laser Product (21 CRF Subchapter J, Part 1040). This product has a
maximum output of 1 mW at 630 to 670 nm.
Caution: There are no user serviceable parts inside the SE955. Use of controls or adjustments, or performance of procedures
other than those specified herein, may result in hazardous laser light exposure of up to mW at 630 to 670 nm.
Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50,0 dated July 26, 2001.
EN60825-1:1994+A1:2002+A2:2001
IEC60825-1:1993+A1:1997+A2:2001
Caution: Use of controls, adjustments or performance of procedures other than those specified herein may result in
hazardous laser light exposure. Class 2 laser scanners use a low power, visible light diode. As with many very bright light source,
such as the sun, the user should avoid staring directly into the light beam. Momentary exposure to a Class 2 laser is not known
to be harmful.
U.S.A. Digital Emissions Compliance
For a Class A digital device or peripheral, the user instructions shall include the following or similar statement, placed in a
prominent location in the text of the manual:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
Communication
Mobile Computing
Portable Lighting
Measurement & Calibration
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
FCC § 15.19 labeling requirements
This device complies with part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
FCC § 15.21 Information to user
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
Canadian Digital Apparatus Compliance
This device complies with Industry Canada license-exempt RSS standards. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Industry Canada Statements
Le present appareil est conforme aux CNR d’Industrie Canada applicaables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes: 1) L’appareil ne doit pas produire de brouillage, et 2) l’utilisat
de l’appareil doit accepter tout brouillage radioélectrique sui, meme si le brouillage est susceptible d’en compromettre le
fonctionnement.
Communication
Mobile Computing
Portable Lighting
Measurement & Calibration
CE Compliance Statement
Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for
future reference
Users of this product are cautioned to use accessories and peripherals approved by ecom instruments GmbH. The use of
accessories other than those recommended, or changes to this product that are not approved by ecom instruments GmbH,
may void the compliance of this product and may result in the loss of the user’s authority to operate the equipment.
Caution: For use with ecom AM Ci70 -Ex only. See battery instructions. No user-serviceable parts. Charge only with the
charging devices mentioned in section 4. “Safety Regulations”. Use of incorrect charger may present a risk of fi re or explosion.
802.11 Radio Precaution Statement
Caution: Users are responsible for confi guring the channels of operation that comply with their country regulatory standards.
A Wireless Network Administrator should review the operating restrictions detailed within the Access Point installation manual.
Radiation Exposure Statement
Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE
C95.1, Federal Communications Commission Offi ce of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and
European Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF) radiation.
If a body worn accessory is not purchased from ecom, the accessory must contain no metal.
Communication
Mobile Computing
Portable Lighting
Measurement & Calibration
Laser Compliance and Precaution
This product complies with the following standards for laser safety:
IEC 60825-1:2007/EN 60825-1:2008-05: Class 2 (1 mW, 630 – 670 nm)
EU – R&TTE Declaration
ecom instruments GmbH declares that this device is in accordance with the essential requirements and other provisions of
R&TTE Directive (1995/5/EC).
0700
This product is marked with this logo and uses radio frequency bands that are not harmonized throughout the European Union
and other countries as noted in the table below.
This equipment may be operated in the following countries without restriction:
AT, BE, CY, CZ, DK, EE, FI, DE, GR, HU, IE, IT, LV, LT, LU, MT, NL, PL, PT, SK, SI, ES, SE, GB, IS, LI, CH, BG, RO, TR
WEEE-Reg.-Nr. DE 934 99306
300011AL15E00
Änderungen vorbehalten. Subject to change.
ecom instruments GmbH · Industriestr. 2 · 97959 Assamstadt · Germany
Phone: + 49 (0) 62 94 / 42 24 0 · Fax: + 49 (0) 62 94 / 42 24 100
E-Mail: sales@ecom-ex.com · www.ecom-ex.com
Copyright© 2013 ecom instruments GmbH.
Der Inhalt dieses Dokuments darf ohne vorherige schriftliche Genehmigung durch die ecom instruments GmbH in keiner Form, weder ganz noch teilweise ver-
vielfältigt, weitergegeben, verbreitet oder gespeichert werden.
Der Inhalt dieses Dokuments wird so präsentiert, wie er aktuell vorliegt. Die ecom instruments GmbH übennimmt weder ausdrücklich noch stillschweigend
irgendeine Gewährleistung für die Richtigkeit oder Vollständigkeit des Inhalts dieses
Dokuments, einschließlich, aber nicht beschränkt auf die stillschweigende
Garantie der Markttauglichkeit und der Eignung für einen bestimmten Zweck, es sei denn, anwendbare Gesetze oder Rechtsprechungen schreiben zwingend eine
Haftung vor. Die ecom instruments GmbH behält sich das Recht vor, jederzeit ohne vorherige Ankündigung Änderungen an diesem Dokument vorzunehmen
oder das Dokument zurückzuziehen.
Copyright© 2013 ecom instruments GmbH.
The contents of this document, either in part or in their entirety, may not be reproduced, forwarded, distributed or saved in any way without ecom instruments GmbH prior
written consent.
The contents of this document are presented as they currently exist. ecom instruments GmbH does not provide any express or tacit guarantee for the correctness or com-
pleteness of the contents of this document, including, but not restricted to, the tacit guarantee of market suitability or fi tness for a specifi c purpose unless applicable laws
or court decisions make liability mandatory. ecom instruments GmbH reserves the right to make changes to this document or to withdraw it any time without prior notice.