DOG TRAINING COLLAR WITH GPS TRACKER

PRODUCT INCLUDES:

• Collar
• USB Charger
• USB Cable
• Adapter
• Remote Control and antenna
• Long/short probes if trainer

A visual depiction shows a dog wearing a collar with a remote control and a person using it, with a landscape in the background indicating a maximum range of 25 Km.

PREPARING THE GPS-TRAINING COLLAR FOR FIRST USE

Charge the collar for 7-8 hours for a standby time of 20 hours. Connect the small USB adapter to the USB cable, and then the cable to the USB charger. Connect the charger to the collar by lifting the orange plastic protective cover. To switch on the collar, hold the back of the remote control at the USB output (where the built-in magnet is) for 1 second, at the point where the collar indicator LED is. Remove the remote control. The red indicator LED on the collar will continuously light, showing it is charging. To complete a full charge, switch off the collar using the remote control magnet.

The remote control should be charged for 4-5 hours via its USB connector.

After 7-8 hours of charging, remove the charger. To switch off the collar, hold the remote control part with the built-in magnet at the collar's indicator LED for 4 seconds.

PAIRING AND USE THE GPS-TRAINING COLLAR

The collar is pre-paired with the remote control. To re-pair, follow these steps: Switch on the remote control, then the collar. The collar's red indicator LED will flash. Press the screen light button for 4-5 seconds until the speaker icon on the screen flashes, indicating tuning mode. Hold the back of the remote control (with the built-in magnet) at the collar's indicator LED for 10 seconds. Remove the remote control. If the collar emits 3 consecutive beeps, press the shock command button for 2 seconds to confirm sync. Repeat for other collars. Press the audio command button to return to normal operation.

Pressing the shock button sends a shock command. The screen flashes when a command is sent. Shock levels range from 1 (lowest) to 8 (highest) using the number buttons. Switch off the remote control using the ON/OFF switch.

TIPS FOR USING THE GPS-TRAINING COLLAR

This device is designed for hunting dogs and works in harsh conditions like rain and dense vegetation. It is lightweight, durable, and suitable for both small and large dogs.

Position the collar on the underside of the dog's neck, facing the ground. Ensure the two probes touch the dog's skin for stimulus. The collar should be snug. If the dog has long fur, trim it slightly so the probes make good skin contact. Use short or long probes as needed.

Find the correct power level by starting at level 1 and increasing until the dog reacts. If level 8 yields no reaction, the collar may not be positioned correctly or is too loose. Ensure proper fit and fur trimming for probe contact.

Always supervise charging. Charge once a month if not in use, store in a dry place below 40 degrees Celsius. It is recommended to charge both the collar and remote control before each use.

GPS TRACKER

The collar has a built-in GPS antenna, and the remote control has a Bluetooth module for communication with a mobile phone or tablet (Android 4.4+ with Bluetooth 4 or 5). To synchronize, follow these steps:

1. Download and install the app on your mobile device.
2. Turn on the remote control.
3. Start the application.
4. Select 'Start Scan', then tap the Bluetooth icon to go to the map.
5. A dog's head icon on the map indicates the dog's position (collar must be outdoors, facing the sky).
6. Tapping the dog's head shows the distance between the user and the collar.

The application allows selection of GPS information intervals (e.g., 60, 30, 20, 15, or 2 seconds) and control of the remote functions.

Visuals show the app interface for scanning devices, connecting, and setting GPS intervals and commands.

WARRANTY

A 1-year warranty is offered, excluding the built-in rechargeable batteries of the collar and remote control.