antaira RS232 to RS232 Isolator and Surge Protector Installation Guide

RS232 to RS232 Isolator and Surge
Protector
Installation Guide

Contents hide

1 Introduction

2 Features:

3 Layout: RS232 Isolator and Surge Protector

4 Accessories

5 Installing the Isolator and Surge Protector

6 RS232 Mode Male DB9 Pin Assignments and

7 Specifications

8 Documents / Resources

8.1 References

9 Related Posts

Introduction

Thank you for purchasing this RS232 (to RS232) Isolator and Surge Protector. It is designed for your PC, workstation, thin client, or server to provide an instant isolation solution for the RS232 serial devices. It provides a DB9 female connector (DCE, with 3-wire signals, TXD, RDX, and GND) that can be connected directly to your PC’s RS232 port. An external 5V DC power source should be applied to its input DC jack. The power source can be supplied by either an AC power adapter or a USB-to-DC-Jack conversion cable.

Features:

Provides one RS232 to RS232 Adaption

Supports up to 2,500Vrms Isolation for all RS232 Signals
Supports 3 RS232 Signals (TXD, RDX, GND)

Supports DB9 Female (DCE) to DB9 Male (DTE) Connector Conversion
Supports Baud Rate up to 921.6 Kbps

+5V DC External Power is Required, Powered by AC Adapter or USB Port with a USB-to-DC-Jack Cable
Compact Size for Critical Applications

No Driver Required for All Operating Systems

Layout: RS232 Isolator and Surge Protector

Accessories

Installing the Isolator and Surge Protector

Since this isolator hardware unit should be powered by the external power source, please connect the 5V AC power adapter or the USB-to-Power-DC-Jack Conversion Cable to make sure the unit works properly. If you are using the USB-to-Power-DC-Jack Cable instead of the AC adapter, please make sure that the USB port is at the Host side (the same side as the DB9 Female connector), DO NOT connect to the USB port at the device side (the same side as the DB9 Male connector), otherwise, the unit won’t work and the DC power was passed through the isolation circuits so the isolator will not function properly.

Use static electricity discharge precautions.
Remove possible static discharge potential from any objects that the converter may come in contact with before installation. This can be accomplished by touching a bare metal chassis rail after you have turned off the power.
Locate an unused RS232 port (with DB9 male connector, configured as DTE), insert the DB9 female connector of the isolator on it

Installing RS232 cable
Connect the RS232 cable from the Isolator’s DB9 male connector to the RS232 device.
Connect the 5V AC Adapter or USB-to-Power-DC-Jack Conversion Cable

RS232 Mode Male DB9 Pin Assignments and

DB9-Male Pin Assignment:

9 Pins Signal

DB9(Male) to DB9(Male) Wiring

Specifications

Type	Specifications
Connectors Number of Ports RS232 Signals Baud Rate Power Requirement Operating Temperature Operating Humidity Storage Temperature	DB9 Female, DB9 Male 1 RS232 TXD, RDX, GND Up to 921.6Kbps 5V/100mA max. 0 to 60°C (32 to 140°F) 5 to 95% RH -20 to 85°C (-4 to 185°F)