ℹ️ Document Conversion Notice: This page was converted from the original file for easier reading. Diagrams/images may appear only in the original PDF below.
Document preview
File info: application/pdf · 20 pages · 146.38KB

TRÅDFRI

IKEA

Adding Light Sources to Your Steering Device

Before you can use your light source, you'll need to pair it with a steering device. To add more light sources, just repeat the steps below:

Diagram: Illustration shows a light bulb being screwed into a socket connected to a device with an on/off switch. The switch is shown in the 'off' position (0), then moved to the 'on' position (1). A close-up view shows a finger toggling the switch from 0 to 1.

  1. Make sure that your light source is installed and the main power switch is turned on.
  2. Hold the steering device close to the light source you want to add (no more than 5 cm away).
  3. Press and hold the pairing button ? for at least 10 seconds. A red light will shine steadily on the steering device. Your light source will begin to dim and finally flash one time to indicate that it has been successfully paired.

Diagram: An information icon (?) is displayed. A light bulb is connected to a device. A double-headed arrow indicates a maximum distance of 5 cm (2 inches) between the light source and the steering device. A finger is shown pressing a button on the steering device for more than 10 seconds. A separate inset shows a CR2032 3V Lithium Battery being inserted into a compartment, accompanied by a small chain/link symbol (?).

Up to 10 light sources can be paired with 1 steering device. Make sure to pair them one at a time. If the light sources are close to each other, disconnect those that have already been paired from the main power switch.

Important Information

CAUTION:

DO NOT USE WITH STANDARD DIMMERS. Only use the control provided with or specified by these instructions to control this bulb. This bulb will not operate properly when connected to a standard (incandescent) dimmer or dimming control. Only controllable by IKEA Smart lighting products.

The colour temperature can be switched between 2200K (warm glow), 2700K (warm white) and 4000K (cool white).

RESET YOUR DEVICE

Toggle the main switch 6 times.

TECHNICAL DATA:

  • Operating frequency: 2405 – 2480 MHz
  • Output power: 10 dBm

Manufacturer:

IKEA of Sweden AB

Address:

Box 702, SE-343 81 Älmhult, SWEDEN

Regulatory Information

License rights and limitations

NO RIGHTS OR LICENSES, EXPRESS OR IMPLIED, ARE GRANTED TO USE THIRD-PARTY DEVICES IN COMBINATION WITH THESE PRODUCTS IN A WIRELESS MESH NETWORK, OR TO USE THIRD-PARTY SERVICES TO ACCESS, MONITOR OR CONTROL THESE PRODUCTS IN A WIRELESS MESH NEWORK VIA THE INTERNET OR ANOTHER EXTERNAL WIDE AREA NETWORK.

For use pursuant to U.S. Patent Nos.:

  • US 6,914,893
  • US 7,697,492
  • US 8,964,708

FCC/IC Compliance

This device complies with Part 15 of the FCC Rules/Innovation Science and Economic Development Canada's licence-exempt RSS standard(s). Operation is subject to the following two conditions:

  • this device may not cause harmful interference, and
  • this device must accept any interference received, including interference that may cause undesired operation of the device.

WARNING:

Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

RF EXPOSURE INFORMATION

According to RF exposure regulations, under normal operations the end user shall refrain from being closer than 20 cm from the device.

Disposal

Disposal Instructions

?️ The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.

© Inter IKEA Systems B.V. 2019 AA-2240092-1

Models: TR DFRI Remote Control Kit

Original Document

If the viewer doesn’t load, open the PDF directly.