RR2VV-6533B-R6

RR2VV-6533B-R6

12 мар. 2025 г. — ©2025 ANDREW, an Amphenol company. All rights reserved. Amphenol and ANDREW are registered trademarks of Amphenol and/or its.

Full PDF Document

If the viewer doesn’t load, open the file directly.

Extracted Text

RR2VV-6533B-R6

12-port sector/multibeam antenna, 4x 698�960 MHz 65� HPBW and 8x 1710�2690 MHz 4x 33�HPBW, 6x RET with tilt indicators
All Internal RET actuators are connected in "Cascaded SRET" configuration Uses the 4.3-10 connector which is 40 percent smaller than the 7-16 DIN connector Enhances network capacity through six sectors on high band while maintaining low band coverage layer through three sectors with only three antenna faces

General Specifications
Antenna Type Band Grounding Type
Performance Note Radome Material Radiator Material Reflector Material RF Connector Interface RF Connector Location RF Connector Quantity, high band RF Connector Quantity, low band RF Connector Quantity, total

Multibeam Multiband RF connector inner conductor and body grounded to reflector and mounting bracket Outdoor usage Fiberglass, UV resistant Copper | Low loss circuit board Aluminum 4.3-10 Female Bottom 8 4 12

Remote Electrical Tilt (RET) Information

RET Hardware RET Interface RET Interface, quantity Input Voltage

CommRET v2 8-pin DIN Female | 8-pin DIN Male 2 female | 2 male 10�30 Vdc

Internal RET Power Consumption, idle state, maximum Power Consumption, normal conditions, maximum Protocol

High band (4) | Low band (2) 1 W 8 W 3GPP/AISG 2.0 (Single RET)

Page 1 of 6

�2021 CommScope, Inc. All rights reserved. All trademarks identified by � or TM are registered trademarks, respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: September 14, 2021

RR2VV-6533B-R6
Dimensions
Width Depth Length Net Weight, without mounting kit
Array Layout

498 mm | 19.606 in 197 mm | 7.756 in 2100 mm | 82.677 in 43 kg | 94.799 lb

Beams Configuration

�2021 CommScope, Inc. All rights reserved. All trademarks identified by � or TM are registered trademarks, respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: September 14, 2021

Page 2 of 6

RR2VV-6533B-R6

Port Configuration

�2021 CommScope, Inc. All rights reserved. All trademarks identified by � or TM are registered trademarks, respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: September 14, 2021

Page 3 of 6

RR2VV-6533B-R6

Electrical Specifications
Impedance Operating Frequency Band Polarization Total Input Power, maximum

50 ohm 1710 � 2690 MHz | 698 � 960 MHz �45� 1,000 W @ 50 �C

Electrical Specifications

Frequency Band, MHz
Gain, dBi
Beam Centers, Horizontal, degrees
Beamwidth, Horizontal, degrees
Beamwidth, Vertical, degrees
Beam Tilt, degrees
USLS (First Lobe), dB
Front-to-Back Ratio at 180�, dB
Front-to-Back Ratio, Copolarization 180� � 30�, dB

698�803 15.1
70
10.9 2�12 18 30
29

824�880 15.4
64
9.7 2�12 18 30
28

880�960 15.5
61
9.1 2�12 18 34
29

1710�1880 1920�2170 2300�2490 2490�2690

17.4

18.9

19

19.5

�27

�25

�24

�22

32

29

27

24

8.9 2�12 18 34

7.9 2�12 20 36

6.8 2�12 19 34

6.4 2�12 19 33

29

31

30

30

25

25

25

25

25

25

25

Page 4 of 6

�2021 CommScope, Inc. All rights reserved. All trademarks identified by � or TM are registered trademarks, respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: September 14, 2021

RR2VV-6533B-R6

Isolation, Cross Polarization, dB Isolation, Inter-band, dB Isolation, Beam to Beam, dB VSWR | Return loss, dB PIM, 3rd Order, 2 x 20 W, dBc Input Power per Port, maximum, watts

25
25
1.5 | 14.0
-150 400

25
25
1.5 | 14.0
-150 400

Electrical Specifications, BASTA

Frequency Band, MHz
Gain by all Beam Tilts, average, dBi
Gain by all Beam Tilts Tolerance, dB
Gain by Beam Tilt, average, dBi
Beamwidth, Horizontal Tolerance, degrees
Beamwidth, Vertical Tolerance, degrees
USLS, beampeak to 20� above beampeak, dB
Front-to-Back Total Power at 180� � 30�, dB
CPR at Boresight, dB
CPR at Sector, dB
CPR at 10 dB Horizontal Beamwidth, dB

698�803 14.7
�0.4
2 � | 14.8 7 � | 14.8 12 � | 14.6
�6.1
�0.7
17
21
21 11

824�880 15.1
�0.3
2 � | 15.2 7 � | 15.2 12 � | 14.9
�5.1
�0.4
16
22
21 8

Mechanical Specifications

Wind Loading @ Velocity, frontal Wind Loading @ Velocity, lateral Wind Loading @ Velocity, maximum Wind Loading @ Velocity, rear Wind Speed, maximum

25
25
1.5 | 14.0
-150 400

25
25 17
1.5 | 14.0
-150 250

25
25 17
1.5 | 14.0
-150 250

25
25 17
1.5 | 14.0
-150 250

25
25 17
1.5 | 14.0
-150 250

880�960 15.3

1710�1880 1920�2170 2300�2490 2490�2690

16.7

18.4

18.4

19.1

�0.3

�1.2

�0.7

�1.6

�0.8

2 � | 15.4 7 � | 15.4 12 � | 15.0
�3.3
�0.6
16
23
18 12

2 � | 16.8 7 � | 16.8 12 � | 15.5
�3.1
�0.6
13
28
16
3

2 � | 18.4 7 � | 18.5 12 � | 18.1
�1.4
�0.5
16
29
20
9

2 � | 18.5 7 � | 18.6 12 � | 18.0
�2.8
�0.4
16
28
16
9

2 � | 19.1 7 � | 19.3 12 � | 18.7
�1.2
�0.5
15
28
22
11

803.0 N @ 150 km/h (180.5 lbf @ 150 km/h) 275.0 N @ 150 km/h (61.8 lbf @ 150 km/h) 1,040.0 N @ 150 km/h (233.8 lbf @ 150 km/h) 661.0 N @ 150 km/h (148.6 lbf @ 150 km/h) 241.402 km/h | 150 mph

Packaging and Weights

608 mm | 23.937 in

Page 5 of 6

�2021 CommScope, Inc. All rights reserved. All trademarks identified by � or TM are registered trademarks, respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: September 14, 2021

RR2VV-6533B-R6

Width, packed Depth, packed Length, packed Weight, gross

608 mm | 23.937 in 352 mm | 13.858 in 2282 mm | 89.843 in 57.4 kg | 126.545 lb

Regulatory Compliance/Certifications

Agency CHINA-ROHS ISO 9001:2015 ROHS

Classification Above maximum concentration value Designed, manufactured and/or distributed under this quality management system Compliant/Exempted

Included Products
BSAMNT-4

� Wide Profile Antenna Downtilt Mounting Kit for 2.4 - 4.5 in (60 - 115 mm) OD round members. Kit contains one scissor top bracket set and one bottom bracket set.

* Footnotes
Performance Note

Severe environmental conditions may degrade optimum performance

�2021 CommScope, Inc. All rights reserved. All trademarks identified by � or TM are registered trademarks, respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the most current information. Revised: September 14, 2021

Page 6 of 6