KIDZTECH TOYS 88061-49MRX 1/12 R/C Cars User Manual 1 12 IM 88062 88182
KIDZTECH TOYS MANUFACTURING LTD 1/12 R/C Cars 1 12 IM 88062 88182
User Manual
Performance Tips 88132 RADIO CONTROL VEHICLE 1:12 Battery Requirement Contents 1. Vehicle: 1 x 7.2V rechargeable battery pack 2. Transmitter: 1 x 9V battery RC Vehicle (Vehicle) x 1 RC Transmitter (Transmitter) x 1 Antenna for RC Transmitter x 1 Instruction Manual x 1 7.2V rechargeable Battery Pack x 1 Charger x 1 9V Battery x 1 Battery Precaution 1. The 7.2V rechargeable battery pack must be charged before use by utilizing the battery charger which included 2. Do not overcharge the battery pack. Do not charge for more than 6 hours 3. Do not charge the battery pack if it shows leakage, corrosion, or has loose or exposed wires or other damage 4. Do not cover the battery pack with any sort of materials while charging 5. Do not touch the battery pack when it is hot. Wait until the battery pack cools before installing it in the Vehicle and before recharging 6. Do not dispose of the battery in fire 7. Do not dismantle the battery or charger, and do not cut the battery or charger cables 8. The battery pack will be warm after charging, and hot after use in a vehicle 9. The supply terminals are not to be short-circuited 10. Rechargeable batteries are to be removed from the toy before being charged 11. Rechargeable batteries are only to be charged under adult supervision 12. Battery replacement must be only made by adults 13. The transformer (charger) is not a toy 14. Charge only type (700mAh Max.) rechargeable battery packs. Other types of batteries may burst causing injury to persons and damage. This power unit is intended to be correctly orientated in a vertical or floor mount position. This charger is intended to be used for charging 7.2V rechargeable battery pack with capacity 700mAH Max. It cannot be used for charging non-rechargeable batteries. Regular examination of battery charger for any damage to their cord, plug, enclosure and other parts, and that, in the event of such damage, it must not be used with the charger or battery pack charge until such damage has been repaired. Note that the 9V battery is non-rechargeable and is not to be recharged. Only batteries of the same or equivalent type as recommended are to be used. It will need replacement when transmission is poor. 15. Exhausted batteries are to be removed from the product. ADAPTER ( Included ) 7.2V 7.2V 700mAh 1 x 9V For Transmitter ( Included ) For Vehicle ( Included ) Do not drive on grass, dirt, sand, dusts, carpet or go through water Do not drive in windy or rainy weather Avoid direct impact the Vehicle with obstacles Switch OFF the power when not in use to prevent damage of Vehicle and Transmitter due to leakage of electrolyte from batteries Remove all batteries from the Vehicle and Transmitter when not in use for long period Keep fingers, hair and loose clothing away from wheels The operating range can be affected by a variety of factors a) Low Voltage of batteries in Transmitter or Vehicle b) Interference from other items that emit radio frequency signals 8. Outdoor usage is recommended in order to get optimum control range 9. Recommend to play the vehicle on a clean and smooth surface 10. Clean the battery compartment to make sure it is free from dust to prevent poor contact of batteries Cautions Charging the Rechargeable Battery Pack for the Vehicle: 1. 2. 3. 4. 5. 1. 2. 3. 4. 5. 6. 7. Connect the 7.2V rechargeable battery pack to the battery charger Plug the charger into the standard AC socket The charging time for a full charge is about 5 hours When charging is completed, unplug the charger from the AC socket Disconnect the rechargeable battery pack form the battery charger How to Play 1. Switch ON the Vehicle 2. Use the Forward / Backward joystick (Fig.3) to drive the Vehicle forward and backward 3. Use the Left / Right joystick (Fig.3) to control the Vehicle turning left or right 4. If the vehicle does not run in straight line, adjust the Direction Adjustment on the vehicle chassis (Fig. 1) 5. Play on smooth surface to have the optimum performance 6. Remember to switch OFF the power of the Vehicle and Transmitter after playing 7. The optimum control range is up to 20m outdoor 1. 2. 3. 4. Do not attempt to disassemble the Vehicle or Transmitter Do not operate the Vehicle with same frequency with other player(s) in same location that will interfere and make the Vehicle out of control. Make sure the batteries are installed with correct polarities (+/-) as shown inside the battery compartment Remove the package and take out all accessories before giving the Vehicle and Transmitter to child to play FCC label compliance statement: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna - Increase the separation between the equipment and receiver - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected - Consult the dealer or an experienced radio/TV technician for help Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the userâs authority to operate the equipment. RSS-310 Compliance Statement: This device complies with Industry Canada Licence-exempt RSS-310. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Declaration of Conformity The product is in conformity with the requirement of EU Directive 1999/5/EC Environmental notes: The whole product also does not belong to household waste at the end of the product life. You can return it at collection points for the recycling of electronic and electronical instruments The symbol on the item, instruction manual, hangtag or packing is showing this clearly. Materials should be recycled according to their respective markings. Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection. Please ask at your local community for the correct collection point. Disposal of batteries Battery and Antenna Installation For Transmitter (Fig. 3 and Fig. 4) 1. Switch OFF the power 2. Unscrew the screw on the battery cover 3. Open the battery cover 4. Install 1 new 9V battery with correct polarity (+/-) as shown inside the battery compartment 5. Close the battery cover 6. Tighten the screw on the battery cover 7. Insert the antenna into the top of Transmitter, tighten it by rotating clockwise (viewing from top of Transmitter) For Vehicle (Fig. 1 and Fig. 2) 1. Switch OFF the power 2. Unscrew the screw on the battery cover 3. Open the battery cover 4. Install a new 7.2V battery pack with correct polarities (+/-) as shown inside the battery compartment 5. Close the battery cover 6. Tighten the screw on the battery cover Fig. 2 Vehicle Fig. 4 Transmitter The packaging and instruction manual contain important information. Please keep them for future reference. Warning! Choking Hazard. Not suitable for children under the age of 3 years due to small parts. We reserve the right to improve/amend specifications and colors without notice. Warning! The Antenna of vehicle is not to be inserted into socket outlets. Transmitter Antenna 7.2V LED Battery Indicator Forward / Backward Left / Right 9V Battery OFF / ON Fig. 1 Vehicle - Battery Installation Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries are sold. You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances: Pb=Battery contains lead Cd=Battery contains cadmium Hg=Battery contains mercury Fig. 3 Transmitter - Battery installation KIDZTECH TOYS MANUFACTURING LTD. Room 1201,12/F, Inter-Continental Plaza, 94 Granville Road, TST East, HK. Tel: (852) 27218868 Info@kidztech.net Made in China http://www.kidztech.net KT13/06/12-00E
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes XMP Toolkit : Adobe XMP Core 5.3-c011 66.145661, 2012/02/06-14:56:27 Format : application/pdf Title : 1-12 IM (88062-88182) Metadata Date : 2014:05:15 10:12:21+08:00 Modify Date : 2014:05:15 10:12:21+08:00 Create Date : 2014:05:15 10:12:21+08:00 Creator Tool : Adobe Illustrator CS6 (Macintosh) Thumbnail Width : 256 Thumbnail Height : 184 Thumbnail Format : JPEG Thumbnail Image : (Binary data 19487 bytes, use -b option to extract) Instance ID : uuid:9734c527-d9b8-f945-87f2-c0e407eeca01 Document ID : xmp.did:0580117407206811822AD8EC72D108D9 Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : uuid:9fa9ce34-00e9-45a6-a28a-3f2edafcf151 Derived From Document ID : xmp.did:2E35CA8C41A6E21199F3FF8B2796DA30 Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:648F70ACC005E111BCBBA3771F521898, xmp.iid:0580117407206811822AD8EC72D108D9 History When : 2011:11:03 10:08:08+08:00, 2014:05:15 10:12:14+08:00 History Software Agent : Adobe Illustrator CS5, Adobe Illustrator CS6 (Macintosh) History Changed : /, / Startup Profile : Print Has Visible Overprint : False Has Visible Transparency : True N Pages : 1 Max Page Size W : 839.999029 Max Page Size H : 594.000263 Max Page Size Unit : Millimeters Font Name : ArialMT, Arial-BoldMT, Arial-Black, ContinuumBold, MyriadPro-Regular Font Family : Arial, Arial, Arial Black, Continuum Bold, Myriad Pro Font Face : Regular, Bold, Regular, Regular, Regular Font Type : Open Type, Open Type, Open Type, TrueType, Open Type Font Version : Version 5.06, Version 5.06, Version 5.00.1x, Macromedia Fontographer 4.1 5/6/96, OTF 1.006;PS 001.000;Core 1.0.23;hotunix 1.28 Font Composite : False, False, False, False, False Font File Name : Arial.ttf, Arial Bold.ttf, Arial Black.ttf, CONTB.TTF, MyriadPro-Regular.otf Plate Names : Cyan, Magenta, Yellow, Black Swatch Groups Colorants Tint : 100.000000 Swatch Groups Group Name : Brights Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=60 M=90 Y=0 K=0 Swatch Groups Colorants Mode : CMYK Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Cyan : 60.000004 Swatch Groups Colorants Magenta : 90.000000 Swatch Groups Colorants Yellow : 0.003099 Swatch Groups Colorants Black : 0.003099 Producer : Adobe PDF library 10.01 Page Count : 1 Creator : Adobe Illustrator CS6 (Macintosh)EXIF Metadata provided by EXIF.tools