Nikko Co 41TX-27-1 WILD CAT User Manual USERS MANUAL 1

Download:
Mirror Download [FCC.gov]
Document ID	716035
Application ID	XMnKcvZ6+ozzspEgGb8uPg==
Document Description	USERS MANUAL 1
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	112.5kB (1406203 bits)
Date Submitted	2006-10-16 00:00:00
Date Available	2006-10-16 00:00:00
Creation Date	2006-06-22 17:33:51
Producing Software	Adobe PDF Library 7.0
Document Lastmod	2006-06-22 17:34:01
Document Title	USERS MANUAL 1
Document Creator	Adobe InDesign CS2 (4.0)

driving your vehicle
60-4455
1:16 Scale WildCat RC Truck
Thread the
vehicle’s antenna
wire through the
supplied antenna
tube. Then, insert the
tube into the antenna
tube holder on the
vehicle’s body.
Screw the
antenna into its
transmitter. Extend
antenna to full
height during use.
1. Slide ON/OFF on bottom of chassis to ON.
2. Use the transmitter’s control levers to steer
your vehicle, as shown below.
3. Slide ON/OFF on the vehicle to OFF when you
finish driving.
Forward
Left
Straight
Right
Stop
Wheel Alignment
If your vehicle does not drive in a straight
line when you release the right stick,
adjust WHEEL ALIGNMENT on the bottom
of the chassis. Push to L if the vehicle is
pulling to the right or to R if the vehicle is
pulling to the left.
Reverse
installing the batteries
RF emissions information
Thank you for purchasing your
1:16 Scale WildCat RC Truck from
RadioShack. Your truck comes in two
frequencies (27MHz and 49MHz) so you
and a friend can drive together. Perfect
for children ages six and up.
what’s included
WildCat RC Truck
Vehicle Antenna Tube
User’s Guide
Transmitter
Transmitter Antenna
Please read this user’s guide before
installing, setting up and using your new product
www.radioshack.com
©2006. RadioShack Corporation.
All rights reserved. RadioShack and
RadioShack.com are trademarks
used by RadioShack Corporation.
60-4455 A3 edited.indd 1
60-4455
06A06
Printed in China
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult your local RadioShack store or an experienced radio/TV technician
for help.
If you cannot eliminate the interference, the FCC requires that you stop
using your product. Changes or modifications not expressly approved by
RadioShack may cause interference and void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) This device must accept any interference received, including interference
that may cause undesired operation.
The carrier frequency.....................................................27.145MHz/49.86MHz
Field Strength....................................................................<80 dBµV/m at 3m
Only use the antenna supplied with this product.
This radiocommunication device complies with all the requirements of Industry
Canada Standard RSS-310.
Ce dispositif de radiocommunication rencontre toutes les exigences de la
norme CNR-310 d’Industrie Canada.
In Your Transmitter
In Your Vehicle
Insert one 9V battery (not supplied) in the battery
compartment matching the polarity symbols
(+ and -) marked inside.
Turn off your vehicle. Insert six AA alkaline
batteries (not supplied) in the battery compartment
matching the polarity symbols (+ and -) marked
inside.
battery notes
• If you do not plan to use your vehicle for a week or more, remove the batteries. Batteries can leak
chemicals that may damage electronic parts.
• Dispose of old batteries promptly and properly. Do not burn or bury them.
• Use only fresh batteries of the required size and recommended type.
• Do not mix old and new batteries, or batteries with different capacities or different chemistries.
• If your vehicle does not respond, drives slowly, or the range reduces, replace the batteries in your
vehicle.
safety and care
• Do not use your vehicle near devices with transmitters
using the same frequency (27 MHz or 49 MHz).
• If someone uses a CB nearby, it might interfere with the
control of your vehicle. If this happens, move the vehicle
away from the CB.
• Never play with your truck in the street.
• When you using your truck, be careful to avoid highimpact collisions with people and objects.
limited 90-day warranty
This product is warranted by RadioShack against manufacturing defects in material
and workmanship under normal use for ninety (90) days from the date of purchase
from RadioShack company-owned stores and authorized RadioShack franchisees
and dealers. For complete warranty details and exclusions, check with your local
RadioShack store.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102		
04/04
Actual product may vary from the images found in this document.
06/22/2006 17:34:01

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Tagged PDF                      : Yes
XMP Toolkit                     : 3.1.1-111
About                           : 8d3d7da3-db42-11d8-8912-87323669aa26
Create Date                     : 2006:06:22 17:33:51+08:00
Metadata Date                   : 2006:06:22 17:34:01+08:00
Modify Date                     : 2006:06:22 17:34:01+08:00
Creator Tool                    : Adobe InDesign CS2 (4.0)
Thumbnail Format                : JPEG
Thumbnail Width                 : 256
Thumbnail Height                : 256
Thumbnail Image                 : (Binary data 12015 bytes, use -b option to extract)
Instance ID                     : uuid:de4361df-45a8-4189-9259-9386ab4abe99
Document ID                     : adobe:docid:indd:3adb352f-fcb2-11da-908b-a5cfd5d9ef78
Rendition Class                 : proof:pdf
Derived From Instance ID        : 3adb352e-fcb2-11da-908b-a5cfd5d9ef78
Derived From Document ID        : adobe:docid:indd:15bfb6fe-fbd4-11da-9930-94e13a0225e6
Manifest Link Form              : ReferenceStream, DirectStream, DirectStream, ReferenceStream, ReferenceStream
Manifest Placed X Resolution    : 72.00, 72.00, 72.00, 300.00, 72.00
Manifest Placed Y Resolution    : 72.00, 72.00, 72.00, 300.00, 72.00
Manifest Placed Resolution Unit : Inches, Inches, Inches, Inches, Inches
Manifest Reference Document ID  : adobe:docid:photoshop:6fa01018-c7a7-11d9-a0b5-d2e797099191, uuid:f338099a-7f7c-460b-9e61-3ed074db1436, uuid:dc665038-2da2-4c42-bf88-cc0c3a2b01f9, uuid:548B5FEE62FFDA118D5BE5079FBC6F40, uuid:835ED8BAD101DB11A0CCBB0D3BB8EA50
Manifest Reference Instance ID  : uuid:558B5FEE62FFDA118D5BE5079FBC6F40, uuid:845ED8BAD101DB11A0CCBB0D3BB8EA50
Format                          : application/pdf
Producer                        : Adobe PDF Library 7.0
Trapped                         : False
Page Count                      : 1
Creator                         : Adobe InDesign CS2 (4.0)

EXIF Metadata provided by EXIF.tools