Precyse Technologies BS24103000 PBS Base Station User Manual The iLocate Tracking Solutions
Precyse Technologies Inc PBS Base Station The iLocate Tracking Solutions
Contents
- 1. installation guide
- 2. users manual
installation guide
PBS installation guide The iLocate Tracking Solutions PBS installation guide Copyright © 2007 Precyse Technologies Inc. All rights reserved PBS installation guide Regulatory Information/disclaimers Installation and use of this Wireless Radio device must be in strict accordance with the instructions included in the user documentation provided with the product. Any changes or modifications made to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment. The Manufacturer is not responsible for any radio or television interference caused by unauthorized modification of this device, of the substitution or attachment. Manufacturer and its authorized resellers or distributors will assume no liability for any damage or violation of government regulations arising from failing to comply with these guidelines. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Instructions concerning human exposure to radio frequency electromagnetic fields: To comply with FCC Section 1.307 (b) (1) for human exposure to radio frequency electromagnetic fields, implement the following instruction: A distance of at least 20cm. between the equipment and all persons should be maintained during the operation of the equipment. The minimum distance will be determined after testing has been completed. This document is confidential and proprietary. No part of this document may be reproduced, stored, or transmitted in any form or by any means without prior written permission from Precyse technologies Inc. Parelec Inc. PBS installation guide Table of contents Regulatory Information/disclaimers ............................................................................................. 2 Introduction ........................................................................................................................4 Acronyms ..................................................................................................................................... 4 Standards used throughout this guide ........................................................................................... 4 Audience and scope ...................................................................................................................... 4 Base Station unit (PBS) installation .................................................................................5 Verify PBS contents ..................................................................................................................... 5 PBS connectors and indicators ..................................................................................................... 6 PBS hardware installation ............................................................................................................ 7 Checking the installation .................................................................................................10 Visual check after connection..................................................................................................... 10 Copyright © 2007 Precyse Technologies Inc. All rights reserved PBS installation guide Introduction The PBS is a component of the Precyse iLocate™ real time location system. The PBS allows for 2-way RF communication with the Smart Agent tags, supporting multi-frequency mode for unexpected RF interference protection. The PBS base station is a low cost, low maintenance stand-alone device. This unit communicates with the central iLocate™ server over existing Ethernet or Wi-Fi networks. Acronyms Acronym Definition PBS RF Base Station Beacon/PBC RF Transmitter that is continuously transmitting its ID PBS ID ID number of PBS SID system ID – unique to each project Tag compact battery powered device, typically usually attached to the monitored asset Frame zone straight line visibility zone RSSI Received Signal Strength Indicator User area All open and close area that is in use of the system and under its control Standards used throughout this guide Symbol / font Definition Warnings and security notes Additional notes for information Audience and scope This user guide describes the process for installing the Precyse Base Station (PBS) as part of the iLocate™ RTLS system. Parelec Inc. PBS installation guide Theory of operation The PBS base station is responsible for synchronizing all the other parts of the system and transmitting data to and from the PC connected to it. The GPS receiver in the PBS is used as an absolute timing and clock source. Amplifier block: The amplifier box is connected to the PBS via a proprietary control protocol. Two of the four RF connectors are used as transmit and receive channels to the amplifier. The other two SMA connectors are disabled (Internally, physically disconnected). The fifth RF port is a GPS antenna port. Base Station unit (PBS) installation Verify PBS contents Each PBS unit consists of the following components: Base station unit Amplifier unit Associated cables Copyright © 2007 Precyse Technologies Inc. All rights reserved PBS installation guide Warning: The amplifier unit can be used only with the supplied PBS. Do not exchange amplifiers between different PBS. Connection to any other equipment, different than the supplied unit is not authorized. PBS connectors and indicators 1. Power indicator 2. Synch indicator 7. DC Power port 3-6. PBS channel indicators 1-4 9-12. TCP\IP ports 1-4 8. Heartbeat port PBS - front view 13-16. RF Channels antennae connectors 18. Synch Generator (GPS Antenna) 17. External amplifier connector. Connect only to the supplied amplifier Parelec Inc. PBS installation guide PBS - rear view Connector / indicator Description 1. Power indicator LED (red) On - Power is connected. Flashing - There is a problem with the power supply. Off – power supply not connected. 2. Synch indicator 3-6. PBS channel indicators #1-4 Synchronization LED (green)– Flashes once a second when the system is active Green LED (green) – flashes when a signal is sent on the corresponding channel 7. DC Power port DC power port (12V-2 A, 24W MAX) 8. Heartbeat port Not used at this stage 9-12. TCP\IP port 1-4 Network connector for corresponding channel. RJ45 connector. 13,16. RF Channel 1,4 antennae connectors Physical antenna connector for the corresponding channel. 14, 15 RF transmit, RF receive – Connected to Amplifier unit. 17. External amplifier connector A DB9 connector that contains power and control outputs. Warning: Do not connect this port to a computer or any other RS232 port or terminal equipment. 18. GPS Antenna connector Connect a GPS antenna (Either active or passive) PBS hardware installation Pre-installation checklist: Determine the specific location for the PBS. Ensure available power source (AC). Available LAN port to connect to the iLocate ™ server. Antennae. Copyright © 2007 Precyse Technologies Inc. All rights reserved PBS installation guide Installation: 1. Connect the PBS to the power supply. Verify that the power indicator LED (#1) turns on. Warning: The power consumption of the unit is 12V-2.0A,. In order to ensure proper functioning of the unit, use the power source supplied with the unit or a compatible power unit with the same polarity and voltage. 2. Connect the amplifier unit. Pay attention to TX and RX ports. Use only the supplied cables. PBS channel indicator #1 RF ports. 3. Connect the antenna to the amplifier’s antenna connector. You can use only antennae supplied by Precyse technologies. Other antenna types are not supported. Verify that the appropriate PBS channel indicator LED flashes. Antenna port Control port RX, TX ports Control port TCP/IP port #1 4. Connect the PBS IP port to the server using the appropriate IP port on the PBS unit. The Ethernet LED on the connector will light indicating the connectivity. Note: The PBS unit has 4 holes in the base for fixing the unit in place. Use 4 screws and washers to fasten the unit. DO NOT DRILL HOLES IN THE UNIT OR OTHERWISE CHANGE THE PROTECTIVE BOX OF THE PBS. 5. Amplifier unit: connect it according to the following block diagram. Use only cables and connectors approved by Precyse Technologies. Parelec Inc. PBS installation guide PBS TX (J2) RF Transmit DB9 (J17) DB9 Cable RX (J3) RF receive TX (J1) RX (J2) DB9 (J4) Amplifier Copyright © 2007 Precyse Technologies Inc. All rights reserved PBS installation guide Checking the installation Visual check after connection Verify that the power LED indicator (red) is on when the power is connected. Verify that the appropriate PBS RF Channel indicator is on. Verify that the Appropriate LAN LED indicator is on Check connection of PBS to the network / server ( ping ) . Appendix A: Marketing and installation 1. The product intended use and application: The BS24103000 (PBS) is used as a radio base station for the iLocate system. By transmitting a synchronization signal, and receiving transmissions from other devices on the iLocate network it acts as a bridge between the iLocate hardware and a personal computer. 2. The EUT is installed either indoors or outdoors (inside an appropriate sealed box). The installation requirements are proper site planning, infrastructure (AC supply with an AC to DC adapter or DC supply, mechanical mounting, clearance around it), sealed box (Per Precyse Tech’s requirements, an IP55 or equivalent box uninterrupted power supply where required, etc). 3. Amplifier unit: Use only the supplied amplifier unit with its supplied base station. Use only the supplied cables which were shipped with the unit. In case of damage or fault, use only authorized replacements from Precyse Technologies Inc. 4. Marketing: The EUT is sold to system integrators only. It is not available for nonprofessionals. 10 Parelec Inc. PBS installation guide One Stamford Plaza, 263 Tresser Blvd Suite 957, Stamford, CT 06901 Tel: 203.564.1526 http://www.precysetech.com Parelec Inc.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Page Count : 11 Language : en-US Tagged PDF : Yes Title : The iLocate Tracking Solutions Author : jlewin Subject : PBS installation guide Creator : Microsoft® Office Word 2007 Create Date : 2008:12:03 12:43:21 Modify Date : 2008:12:03 12:43:21 Producer : Microsoft® Office Word 2007EXIF Metadata provided by EXIF.tools