Synapse Wireless HCTAG Health Care RF Tag User Manual 13 0253 Exhibit Cover
Synapse Wireless Inc. Health Care RF Tag 13 0253 Exhibit Cover
Manual
Certification Exhibit FCC ID: U9O-HCTAG FCC Rule Part: 15.249 ACS Project Number: 13-0253 Manufacturer: Synapse Wireless Inc. Model: HCTAG Manual 5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598 DATA SHEET HCTAG Series Model Number: HCTAG Part Numbers: HCTAG-ST001 Document Revision v1.0 © 2013 Synapse, All Rights Reserved All Synapse products are patented or patent pending Specifications are subject to change without notice – confirm that data is current Synapse, the Synapse logo, SNAP, and Portal are all registered trademarks of Synapse Wireless, Inc. 500 Discovery Drive Huntsville, Alabama 35806 877-982-7888 Doc # 430157-01A Page 2 of 7 ∙ ©2013 Synapse Wireless, Inc. ∙ Document Number 430157-01A ∙ 500 Discovery Drive, Huntsville, AL 35806 ∙ 256-852-7888 HCTAG Data Sheet ∙ synapse-wireless.com Table of Contents 1. HCTAG OEM Device Overview............................................................................................ 4 Specifications.............................................................................................................................. 5 Electrical Characteristics ............................................................................................................ 5 2. Agency Certifications ............................................................Error! Bookmark not defined. United States (FCC).................................................................................................................... 6 FCC Notices...........................................................................Error! Bookmark not defined. ∙ HCTAG Data Sheet ©2013 Synapse Wireless, Inc. ∙ Document Number 430157-01A 500 Discovery Drive, Huntsville, AL 35806 ∙ 256-852-7888 ∙ Page 3 of 7 ∙ synapse-wireless.com 1. HCTAG OEM Device Overview The HCTAG device is an IEEE 802.15.4, low-power, highly-reliable solution to embedded wireless control and monitoring network needs that require high data rates. The HCTAG embeds Synapse’s SNAP OS, the industry’s first Internet-enabled, wireless mesh network operating system into the Atmel ATmega128RFA1 single-chip AVR® microcontroller with an integrated transceiver that delivers up to 2Mbits/sec. This low-power TAG is intended to be used in Real Time Location Systems using RF technologies with power consumptions as low as 1.0 μA to enable a new generation of battery-driven systems. SNAP’s on-board Python interpreter provides for rapid application development and over-the-air programming, while Atmel’s low-power RF single-chip design saves board space and lowers the overall Bill of Materials and power consumption. The HCTAG is approved as an FCC Part 15 unlicensed modular transmitters. The modules provide up to 16 channels of operation in the ISM 2.4GHz frequency band. The HCTAG device is intended to be a low-power transmitter with a low duty cycle (<14%) operation that can be worn on the body by the user. This Data Sheet details Part Number HCTAG: • • • • • • • • • 128k flash, 58.5k free for over-the-air uploaded user apps One UART port (not externally accessible) for control or transparent data, which surmounts noisy environments Low power modes: 1.0 μA with internal timer running Spread spectrum (DSSS) technology Up to 2 Mbps Data Rate 2.4 GHz RF Frequency Receive Mode (7 dBm) standard Transmit Mode (2-3 dBm) for good low-power range HCTAG: Serpentine F-Antenna Page 4 of 7 ∙ ©2013 Synapse Wireless, Inc. ∙ Document Number 430157-01A ∙ 500 Discovery Drive, Huntsville, AL 35806 ∙ 256-852-7888 HCTAG Data Sheet ∙ synapse-wireless.com 16Mhz XTAL 2.4Ghz IEEE 802.15.4 Atmel ATmega128RFA1 Microcontroller Peripherals Balun F-Antenna 32.768kHz XTAL Figure 1.0 Block diagram showing the major subsystems comprising the HCTAG Specifications Table 1.0 HCTAG Specifications Transmit Power Output RF Data Rate Receiver Sensitivity Supply Voltage Transmit Current (Typ@3.0V) Idle/Receive Current (Typ@3.0V) Power-down Current (Typ@3.0V) Frequency Spreading Method Modulation Dimensions Operating Temperature Antenna Option Topology Error Handling Number of Channels UARTS with HW Flow Control FCC Part 15.247 Industry Canada (IC) Performance Power Requirements General Networking Available I/O Agency Approvals 3 dBm 250Kbps, 500Kbps, 1Mbps, 2Mbps -107 dBm (1% PER) 2.7 - 3.6 V 40mA 20mA 1.0uA ISM 2.4 GHz Direct Sequence (DSSS) O-QPSK 3.25" x 2.0" x 0.375" -40 to 85 deg C. Serpentine F- antenna SNAP Retries and acknowledgement 16 1 Port - 8 total I/O FCC ID: U9O-HCTAG IC: 7084A-HCTAG IC: 7084A-HCTAG Electrical Characteristics The HCTAG is powered by quantity two AAAA Alkaline Battery Cells. They are not intended to be user-replaceable. ∙ HCTAG Data Sheet ©2013 Synapse Wireless, Inc. ∙ Document Number 430157-01A 500 Discovery Drive, Huntsville, AL 35806 ∙ 256-852-7888 ∙ Page 5 of 7 ∙ synapse-wireless.com 2. Agency Certifications United States (FCC) WARNING: The HCTAG modules have been tested by the FCC for use with other products without further certification (as per FCC Section 2.1091). Changes or modifications to this device not expressly approved by Synapse Wireless Inc. could void the user’s authority to operate the equipment. The HCTAG modules comply with Part 15 of the FCC rules and regulations. Compliance with the labeling requirements, FCC notices and antenna usage guidelines is required. FCC ID: U90-HCTAG THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS. (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION FCC Notices WARNING: The HCTAG device have been tested by the FCC for use with other products without further certification (as per FCC Section 2.1091). Changes or Page 6 of 7 ∙ ©2013 Synapse Wireless, Inc. ∙ Document Number 430157-01A ∙ 500 Discovery Drive, Huntsville, AL 35806 ∙ 256-852-7888 HCTAG Data Sheet ∙ synapse-wireless.com modifications to this device not expressly approved by Synapse Wireless Inc. could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. RF Exposure Warning: “This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment is in direct contact with the body of the user under normal operating conditions. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.” ∙ HCTAG Data Sheet ©2013 Synapse Wireless, Inc. ∙ Document Number 430157-01A 500 Discovery Drive, Huntsville, AL 35806 ∙ 256-852-7888 ∙ Page 7 of 7 ∙ synapse-wireless.com
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes Page Count : 8 XMP Toolkit : 3.1-701 Producer : ScanSoft PDF Create! 7 Creator Tool : Microsoft Word - 13-0253 - Exhibit Cover.doc Create Date : 2013:07:24 12:31:41-04:00 Modify Date : 2013:07:24 12:31:42-04:00 Title : Microsoft Word - 13-0253 - Exhibit Cover.doc Creator : courtney.mcgann Author : courtney.mcgannEXIF Metadata provided by EXIF.tools