User manual

Charging Port
Microphone SIRI
0807 09 10 1211
6.Project Specification and Instruction
- Bluetooth Version : V4.0
- Supported devices: Bluetooth mobile phones, Bluetooth 
  speakers Bluetooth PC and other Bluetooth devices
- Maximum work range: 33 Feet (10 Meters)
- Talk time:  About 15 Hours
- Music play:  About 13 Hours
- Charging time:  2.5 Hours
- Charging Voltage: DC 5V
- Work Voltage: 3.7V 250MAH
- Sensitivity: 105±3dB 
- Frequency Response: 20Hz~20KHz
※  The actual time may vary from mobile phone types and
      functions.
    Thank you for selecting our latest Bluetooth headset, please 
read this User's Manual carefully before you operate this 
headset, and please save this Manual for further reference. 
Before operating, please read all the Safety notice to make sure 
the safe and appropriate use.
Safety Notice:
  Please observe the rules of the Country or Region which you 
  are in while driving.
  Do not disassemble or modify the headset at any reason, 
  otherwise, It may damage or burn the headset.
  If there is any quality problem, please send the headset to 
  authorized service center for repairing.
  Please keep the equipment along with all the accessories out 
  of the reach of children and pets. It will cause suffocation and 
  serious injury.
  Do not put the device under the environment which the 
  temperature is too low or too high ( Below 0℃ or over 45℃).
  Extreme temperatures will cause the device deformation,
  reduce the charging capacity and shorten the working life.
  Please do not wet the device, for the liquid can cause serious 
  damage to the device. Please do not touch the device by wet 
  hands. It is out of the maintenance range for the damage 
  caused by water.
  Please avoid closing to the eyes of children and pets when 
  using the flash indicator of the device.
  Please do not operate the device in thunderstorm weather. 
It will damage your hearing if you listen with high 
volume for a long time. It is recommended that 
only use the lowest volume which is necessary 
for speaking and listening to music.  
1. Guide
■Headset introduction
USB Charging Cable:
2.Instruction
■ Key Function
3.Bluetooth Indicator Status
5.Headset Charging
This headset is equipped with built-in non-detachable and 
rechargeable battery.
Please make sure that the battery is charged full for the first 
time use.
Power switch
Pairing
Play / Pause
Receive
Hang up phone 
call
4. SIRI :
The function only applies to phone with siri itself
语音控制
■ Connect the charger to the charging port.
■ Insert the charger into the standard power outlet. 
During the charging, indicator will turn to Red. If without
charging, please plug out the travel charger first, then 
connect it again. 
■ After full charging, red indicator will be off. Please plug out
the travel charger from the power outlet and headset.
■ It will reduce the battery performance after long time / 
repeatable charge and dis-charge.
■ And it is normal phenomenon for all the rechargeable battery. 
Please do not dial or receive phone call during charging, and 
please plug out the charger from the headset, then receive 
the phone call. When the battery is low, the headset will 
appear the prompt and the red indicator will flash.
Power on 
Pairing
Power off
Receive
Hang up
phone call
Play/Pause
Press the key for 3 seconds to switch off (the red 
indicator flashes once)
Press the key for 5 seconds to switch on and enter
into pairing mode (The red indicator flashes once and 
the blue indicator flashes twice, and then the red and 
blue indicators take turns to flash)
When calls coming, press the key once to receive 
phone calls, press again to hang up phone calls,  
Press the key for 2 seconds to reject phone calls
In music mode, press the key once to pause, and 
press it again to play. (when phone call comes, the 
music will be off. When phone call is off, the music 
will continue)
When the bluetooth is on, press the key twice shortly
can activate siri function 
Work Status  Indicator Light Status Remark
Switch on Red indicator flash once
Blue indicator flash once
Switch off Red indicator flash once
Connection
Phone call Blue indicator will flash once 
every 6 seconds
Blue indicator will flash once
every 6 seconds
Blue indicator will flash once 
every 6 seconds
Play Music
Pairing Mode Red and blue indicators take 
turns to flash 
Charging
Low battery 
warning
Red indicator is on all the time when 
charging; the light is off when charged full
Red indicator will flash once 
every 60 seconds
(1) Turn on the bluetooth function of the phone.
(2) Press “     ” for 5 seconds to swith on and enters into 
     pairing mode when the red and blue indicators take turns
     to flash.
(3) Find “180s BT” from the device list of the phone and make 
     connection.
4) Press the key twice shortly to activate siri function.
3) Microphone on the phone will appear at that time, and you 
can use siri directly.
  Bluetooth headphone
Press the 
key twice
 shortly
This device complies with Part 15 of the FCC Rules.   Operation 
is subject to the following two conditions: (1) this device may not 
cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause 
undesired operation.Changes or modifications not expressly 
approved by the party responsible for compliance could void the 
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply 
with the limits for a Class B digital device, pursuant to Part 15 of 
the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential 
installation. This equipment generates, uses instructions, may  
cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of 
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different 
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for 
help.